FCC Compliance Statements
This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) this device may not cause
harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
Note: This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or
more of the following measures:
ISED Compliance Statements
This device contains licence-exempt transmitter(s)/receiver(s) that
comply with Innovation, Science and Economic Development Canada’s
licence-exempt RSS(s). Operation is subject to the following two
conditions: (1 )This device may not cause interference.(2)This device
must accept any interference, including interference that may cause
undesired operation of the device.
L’émetteur/récepteur exempt de licence contenu dans le présent
appareil est conforme aux CNR d’Innovation, Sciences et Développe-
ment économique Canada applicables aux appareils radio exempts de
licence. L’exploitation est autorisée aux deux conditions suivantes :
(1)L’appareil ne doit pas produire de brouillage; (2)L’appareil doit
accepter tout brouillage radioélectrique subi, même si le brouillage est
susceptible d’en compromettre le fonctionnement.
This equipment complies with IC RSS-102 radiation exposure limits set
forth for an uncontrolled environment. This equipment should be
installed and operated with minimum distance 20cm between the
radiator and your body.
QUICK
START
GUIDE
NEED HELP?
Resources & Support
support.wyze.com
Contact our support wizards:
https://support.wyze.com
Scan the QR code
to learn more
Cet équipement est conforme aux limites d'exposition aux radiations IC
CNR-102 établies pour un environnement non contrôlé. Cet
équipement doit être installé et utilisé avec une distance minimale de
20cm entre le radiateur et votre corps.
a)the device for operation in the band 5150-5250 MHz is only for
indoor use to reduce the potential for harmful interference to
co-channel mobile satellite systems;
b) the maximum antenna gain permitted for devices in the band
5725-5825 MHz shall comply with the e.i.r.p. limits specified for
point-to-point and non point-to-point operation as appropriate.
a)les dispositifs fonctionnant dans la bande 5150-5250 MHz sont
réservés uniquement pour uneutilisation à l’intérieur afin de réduire les
risques de brouillage préjudiciable aux systèmes de satellites mobiles
utilisant les mêmes canaux;
b) le gain maximal d’antenne permis (pour les dispositifs utilisant la
bande 5725-5825 MHz). doit se conformer à la limite de p.i.r.e.
spécifiée pour l’exploitation point à point et non point à point, selon
le cas.-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help.
Caution: Changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate
the equipment.
This equipment complies with FCC radiation exposure limits set forth
for an uncontrolled environment. This equipment should be installed and
operated with minimum distance 20cm between the radiator and your
body.
(1) The ideal location to place the chime is half-way between your
router and your doobell.
(2) Heavy-duty walls and floors made of materials like concrete, brick
or metal can weaken your doorbell signal strength.
Do not use the battery near a heat source, Do not use the battery near fire or
an oven, or in an ambient temperature exceeding 80℃. Over-heat may cause
internal short-circuit, heat generation, smoking, deformation or burning.
Warning：
Use Wedge Kit to change the horizontal angle
Use Corner Kit to change the vertical angle
Micro USB
Charging Port
Power Button
Screw Terminals
Wyze Chime Pro (Base)
Status Light
Setup Button
Speaker
Light Sensor
Lens
Microphone
Doorbell
Button
Speaker Security Screw
Doorbell Front Doorbell Back
PIR Sensor
Where to place your doorbell and chime
Angle (with Corner kit)Angle (without Corner kit)
Angle (with Wedge Kit）Angle (without Wedge kit)
IN THE BOX
Wyze Video Doorbell Pro × 1
Wyze Chime Pro × 1
Back Plate For Screw × 1
Back Plate For 3M Tape × 1
3M Tape × 1
T8 Screwdriver × 1
Corner Kit × 1
Wire Nuts × 3
Long Screws × 3
Short Screws × 3
Extension Wires × 2
Expansion Tubes × 3
USB Charging Cable × 1
Quick Start Guide × 1
Back Plate
For Screw (optional)
Wedge Kit
(Installed on doorbell back)
Back Plate For 3M
Optional choices for Wedge Kit or Corner Kit
users
4ft
150°
4ft
150°
SETUP
Download the Wyze app and sign in or create an account.
Open the Wyze app and tap the + plus sign on the top left corner
of the Home screen. Tap “Add Device" and then select Wyze Video
Doorbell Pro. Follow the instructions to finish installation.
OR DOWNLOAD DIRECTLY FROM THE
APPLE APP STORE OR GOOGLE PLAY
DOWNLOAD THE APP BY
SCANNING THIS QR CODE
SETUP
1
2
INSTALLATION
Installing with 3M
Advice:
Installation height less
than 6.6 feet
Installing with screwsInstalling with screws powered
by AC wire
LIGHT INDICATIONS
Wyze Video Doorbell Pro
Solid White Light
The device is charging
Solid Blue Light
The device is fully charged
Wyze Chime Pro
Flashing Red Light
Connecting to Doorbell
Flashing Yellow Light
Waiting for Connection
Flashing Blue Light
Connecting to network
Solid Blue Light
Connected
30 feet
30 feet
150°
door
150°
door
Corner Kit
-
1
-
2
