TECHNICAL FILE
R03.001_28/04/2016
You can nd out more information about the technical features of Emac®’s products by downloading
its Technical File in www.emac.es.
Technical information
www.emac.es
The data provided are for information only and have been obtained by our supplier or Emac®.
Does not constitute legal guarantee in terms of properties and / or functionality of the application of material
Novopeldaño® 5
Placement
Cleaning and maintenance
Uso interioresUso exteriores
Uso pavimentos
Reciclable
The product must be cleaned periodically with a soft cloth. If you use a neutral liquid cleaner, you must
rinse the prole with cold water and dry it to remove the humidity excess. The persistent dirtiness can
be removed by using cleaning approved agents lightly abrasive or a grid covered with polished powder
neutral. If a preserving agent is applied, as well as keep a very thin layer of water repellent, note that it
can’t be yellow,attract dust or dirt or have iridescent effects.
Steel wool, abrasive cleaners, souring products as well as strong acids (hydrochloric and
perchloric),strong bases (caustic soda or ammonia) or carbonated solutions are not recommended.
Citric acid is neither recommended because disolves the protective layer of the surface of aluminium.
Waxes, petrolatum, lanolin or similar substances are not appropriate. Solvents containing haloalkanes
(hydrouoroether and chlorinated solvents) and curing accelerators containing chlorides should not be
used (use special accelerators free of chlorides).
1. If you have acquired Novopeldaño® 5 without adhesive:
Clean the surfaces to be joined to guarantee a perfect adhesion. Spread a big amount of adhesive type
MS Sealing/Express from Fischer or similar on the rear of Novopeldaño® 5, place the prole on the
desired surface and press carefully. Finally, let the adhesive dry.
2. If you have acquired Bricopeldaño® 5 with adhesive:
Clean the surfaces to be joined to guarantee a perfect adhesion. Remove the protective lm of the
adhesive tape, place the prole on the desired surface and press carefully.
Page 3 of 3