Chief FCA500 Guide d'installation

Catégorie
Kits de montage
Taper
Guide d'installation
INSTALLATION INSTRUCTIONS
Lower Video Shelf
Spanish Product Description
German Product Description
Portuguese Product Description
Italian Product Description
Dutch Product Description
French Product Description
FCA500
FCA500 Installation Instructions
2
DISCLAIMER
Milestone AV Technologies and its affiliated corporations and
subsidiaries (collectively "Milestone"), intend to make this
manual accurate and complete. However, Milestone makes no
claim that the information contained herein covers all details,
conditions or variations, nor does it provide for every possible
contingency in connection with the installation or use of this
product. The information contained in this document is subject
to change without notice or obligation of any kind. Milestone
makes no representation of warranty, expressed or implied,
regarding the information contained herein. Milestone assumes
no responsibility for accuracy, completeness or sufficiency of
the information contained in this document.
Chief® is a registered trademark of Milestone AV Technologies.
All rights reserved.
IMPORTANT SAFETY INSTRUCTIONS
WARNING: A WARNING alerts you to the possibility of
serious injury or death if you do not follow the instructions.
CAUTION: A CAUTION alerts you to the possibility of
damage or destruction of equipment if you do not follow the
corresponding instructions.
WARNING: Failure to read, thoroughly understand, and
follow all instructions can result in serious personal injury,
damage to equipment, or voiding of factory warranty! It is the
installer’s responsibility to make sure all components are
properly assembled and installed using the instructions
provided.
WARNING: Exceeding the weight capacity can result in
serious personal injury or damage to equipment! It is the
installer’s responsibility to make sure the combined weight of
all components
placed on the FCA500 does not exceed 20 lbs
(9.1 kg).
WARNING: Use this mounting system only for its intended
use as described in these instructions. Do not use
attachments not recommended by the manufacturer.
WARNING: Never operate this mounting system if it is
damaged. Return the mounting system to a service center for
examination and repair.
WARNING: Do not use this product outdoors.
WARNING: RISK OF INJURY TO PERSONS! Do not use
this mounting system to support video equipment such as
televisions or computer monitors.
--SAVE THESE INSTRUCTIONS--
DIMENSIONS
L
OF MOUNT
L
OF MOUNT
OF MOUNT
L
DIMENSIONS: INCHES
[MILLIMETERS]
Installation Instructions FCA500
3
LEGEND
TOOLS REQUIRED FOR INSTALLATION
PARTS
Tighten Fastener
Apretar elemento de fijación
Befestigungsteil festziehen
Apertar fixador
Serrare il fissaggio
Bevestiging vastdraaien
Serrez les fixations
Loosen Fastener
Aflojar elemento de fijación
Befestigungsteil lösen
Desapertar fixador
Allentare il fissaggio
Bevestiging losdraaien
Desserrez les fixations
Open-Ended Wrench
Llave de boca
Gabelschlüssel
Chave de bocas
Chiave a punte aperte
Steeksleutel
Clé à fourche
Phillips Screwdriver
Destornillador Phillips
Kreuzschlitzschraubendreher
Chave de fendas Phillips
Cacciavite a stella
Kruiskopschroevendraaier
Tournevis à pointe cruciforme
#2
3/8"
A (1)
[Shelf assembly]
B (1)
[Shelf upright]
C (1)
[Hanging bracket]
D (1)
[Retaining bracket]
E (8)
[Hook & loop]
F (4)
10-24 x 3/8"
G (4)
10-24
FCA500 Installation Instructions
4
ASSEMBLY AND INSTALLATION
Attaching Bracket and Upright to Mount
1. Lower hanging bracket (C) onto mount rail, placing hooks
over mount rail. (See Figure 1)
Figure 1
2. Hang shelf upright (B) onto the hanging bracket (C), placing
studs on hanging bracket into slots on shelf upright. (See
Figure 2)
Figure 2
3. Attach retaining bracket (D) to shelf upright, pressing
retaining bracket against mount rail and tightening, using
four 10-24 lock nuts (G). (See Figure 2)
Assembling Shelf to Upright
1. Partially install two 10-24 x 3/8" Phillips pan head screws (F)
into the top two holes on shelf upright (B). (See Figure 3)
2. Raise shelf assembly (A) up to hang it on two screws
inserted in Step 1. (See Figure 3)
Figure 3
3. Fasten two 10-24 x 3/8" Phillips pan head screws (F) into
the lower holes of shelf assembly (A). (See Figure 4)
Figure 4
4. Tighten two upper screws inserted in Step 1.
(C)
Mount rail
3
(G) x 4
2
(C)
Slots
Studs
(D)
Mount rail
1
(F) x 2
2
(B)
(A)
3
(F) x 2
(A)
Installation Instructions FCA500
5
Adjustments
1. Loosen two nuts on each side of retaining bracket. (See
Figure 5)
2. Adjust height of shelf, as necessary.
3. Tighten four nuts on retaining bracket.
Figure 5
Installing Components
WARNING:
Exceeding the weight capacity can result in
serious personal injury or damage to equipment! It is the
installer’s responsibility to make sure the combined weight of
all components located on the FCA500 does not exceed 20 lbs
(9.1 kg).
4. Put hook and loop squares (E) together to form four
squares.
5. Remove paper from one side of each square.
6. Attach hook and loop squares to shelf. (See Figure 6)
7. Remove paper from hook and loop squares and place
component on shelf, pressing it against hook and loop
squares. (See Figure 6)
8. Route cable from component (not included) towards back of
shelf and down behind the FCA500. (See Figure 7)
NOTE: OPTIONAL: Slots are provided in shelf for strap (not
included) to hold component in place. (See Figure 7)
Figure 6
Figure 7
(Mount rail not shown for clarity)
1
3
2
6
(E) x 4
7
Example
component
(not included)
Strap
(not included)
Cable
8
(Mount rail not shown for clarity)
FCA500 Installation Instructions
6
Installation Instructions FCA500
7
FCA500 Installation Instructions
USA/International A 6436 City West Parkway, Eden Prairie, MN 55344
P 800.582.6480 / 952.225.6000
F 877.894.6918 / 952.894.6918
Europe A Franklinstraat 14, 6003 DK Weert, Netherlands
P +31 (0) 495 580 852
F +31 (0) 495 580 845
Asia Pacific A Office No. 1 on 12/F, Shatin Galleria
18-24 Shan Mei Street
Fotan, Shatin, Hong Kong
P 852 2145 4099
F 852 2145 4477
Chief Manufacturing, a products division
of Milestone AV Technologies
8800-002267 Rev01
2012 Milestone AV Technologies,
a Duchossois Group Company
www.chiefmfg.com
11/12
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6
  • Page 7 7
  • Page 8 8

Chief FCA500 Guide d'installation

Catégorie
Kits de montage
Taper
Guide d'installation

dans d''autres langues