Arris XB6 WestNet Comcast XFINITY Advanced Gateway Manuel utilisateur
- Taper
- Manuel utilisateur
FCC COMPLIANCE
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1)
This device may not cause harmful interference, and
(2) this device must accept any interference received,
including interference that may cause undesired
operation.
This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful
interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio
communications. However, there is no guarantee that
interference will not occur in a particular installation.
If this equipment does cause harmful interference to
radio or television reception, which can be determined
by turning the equipment o and on, the user is
encouraged to try to correct the interference by one of
the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and
receiver.
• Connect the equipment into an outlet on a circuit
dierent from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV
technician for help.
FCC Caution: Any changes or modications not expressly
approved by the party responsible for compliance could
void the user’s authority to operate this equipment.
This transmitter must not be co-located or operating in
conjunction with any other antenna or transmitter.
Note: The country code selection is for non-US models
only and is not available to all US models. Per FCC
regulation, all Wi-Fi products marketed in US must x to
US operation channels only.
Radiation Exposure Statement:
This equipment complies with FCC radiation exposure
limits set forth for an uncontrolled environment. This
equipment should be installed and operated with
minimum distance 49 cm (19.5 inches) between the
radiator and your body.
CANADIAN COMPLIANCE
CAN ICES-003(B) / NMB-003(B)
This device complies with Innovation, Science and
Economic Development Canada’s license-exempt RSSs.
Operation is subject to the following two conditions:
(1) This device may not cause interference; and
(2) This device must accept any interference, including
interference that may cause undesired operation of the
device.
Le présent appareil est conforme aux CNR d’Industrie
Canada applicables aux appareils radio exempts
de licence. L’exploitation est autorisée aux deux
conditions suivantes : (1) l’appareil ne doit pas produire
de brouillage, et (2) l’utilisateur de l’appareil doit
accepter tout brouillage radioélectrique subi, même
si le brouillage est susceptible d’en compromettre le
fonctionnement.
The device meets the exemption from the routine
evaluation limits in section 2.5 of RSS 102 and
compliance with RSS-102 RF exposure, users can obtain
Canadian information on RF exposure and compliance.
Le dispositif rencontre l’exemption des limites courantes
d’évaluation dans la section 2.5 de RSS 102 et la
conformité à l’exposition de RSS-102 rf, utilisateurs peut
obtenir l’information canadienne sur l’exposition et la
conformité de rf.
Caution: (i) the device for operation in the band 5150–
5350 MHz is only for indoor use to reduce the potential
for harmful interference toco-channel mobile satellite
systems.
Le dispositif fonctionnant dans la bande 5150-5350 MHz
est réservé uniquement pour une utilisation à l’intérieur
an de réduire les risques de brouillage préjudiciable
aux systèmes de satellites mobiles utilisant les mêmes
canaux.
Caution: This transmitter must not be co-located or
operating in conjunction with any other antenna or
transmitter. This equipment should be installed and
operated with a minimum distance of 49 centimeters
(19.5 inches) between the radiator and your body.
Cet émetteur ne doit pas être Co-placé ou ne
fonctionnant en même temps qu’aucune autre antenne
ou émetteur. Cet équipement devrait être installé et
actionné avec une distance minimum de 49 centimètres
(19,5 pouces) entre le radiateur et votre corps.
For indoor use only.
Pour une utilisation en intérieur uniquement.
Open Source Software Information
For instructions on how to obtain a copy of any source
code being made publicly available by ARRIS related to
software used in this ARRIS product you may send your
request in writing to:
ARRIS, Software Pedigree Operations, 2450 Walsh
Avenue, Santa Clara, CA 95051, USA
The ARRIS website opensource.arrisi.com also
contains information regarding use of open source.
ARRIS has created the opensource.arris.com site to
serve as a portal for interaction with the software
community-at-large.
© 2022 CommScope, Inc. All rights reserved.
ARRIS and the ARRIS Logo are trademarks of CommScope, Inc. and/or its aliates. All other trademarks are the
property of their respective owners.
No part of this content may be reproduced in any form or by any means or used to make any derivative work
(such as translation, transformation, or adaptation) without written permission from CommScope, Inc. and/or its
aliates (“CommScope”). CommScope reserves the right to revise or change this content from time to time without
obligation on the part of CommScope to provide notication of such revision or change.
CommScope provides this content without warranty of any kind, implied or expressed, including, but not limited
to, the implied warranties of merchantability and tness for a particular purpose. CommScope may make
improvements or changes in the products or services described in this content at any time. The capabilities, system
requirements and/or compatibility with third-party products described herein are subject to change without notice.
Caring for the environment by recycling
When you see this symbol on an ARRIS product, do not dispose of the product with residential or
commercial waste.
Some countries or regions have set up systems to collect and recycle electrical and electronic
waste items.
Recycling information can be obtained from the WEEE recycling section at www.CommScope.com.
Please recycle product packaging and this document.
Important Safety Instructions
Do not connect equipment during electrical storm.
Do not use product near water. Do not locate product
near ame, ignition, or heat sources. Use only the
power supply and/or power cord included with the
product. Clean using only dry, lint-free cloth. Do not
use cleaning agents or aerosols. Install product near
the power outlet.
Ground coaxial cable shield at building/residence
either close to point of entrance or at point of
attachment. Ground as close as practical to building/
residence to minimize grounding connector length and
reduce potential voltage dierences between cable
TV coaxial cable and other grounding system. Ensure
coax cable attached to device is in good physical shape
and properly tightened to unit. Do not block ventilation
openings. Never stand it on soft furnishings or carpets.
In areas with a high number of power surge events,
additional power surge protection may be required.
For models equipped with telephone service:
Telephones should be connected directly to telephony
modem. Only a professional installer may connect
telephony modem to home’s existing telephone
wiring. Physical connections to previous telephone
provider must be removed. Failure to do so may
cause hazardous conditions, loss of service, and/or
permanent damage.
Power Supply Unit
This Class III product shall be powered by the Power
Supply that is provided together with the product.
Bloc d’alimentation
Ce produit de classe III doit être alimenté par le bloc
d’alimentation qui est fourni avec le produit.
ARRIS, 3871 Lakeeld Drive
Suwanee, GA 30024, USA
www.commscope.com 616641-032-B
Consignes de sécurité importantes
Ne pas connecter l’équipement pendant un orage
électrique. Ne pas utiliser le produit près de l’eau. Ne
pas placer le produit près d’une amme, d’une source
d’inammation ou de chaleur. Utilisez uniquement le
bloc d’alimentation ou le cordon d’alimentation fourni
avec le produit. Nettoyez uniquement avec un chion
sec et non pelucheux. N’utilisez pas de produits de
nettoyage ou d’aérosols. Installez le produit près d’une
prise de courant.
Mettez à la terre le câble blindé coaxial dans le bâti-
ment/la résidence, soit près du point d’entrée, soit au
point de xation. Eectuez la mise à la terre aussi près
que possible du bâtiment/de la résidence an de min-
imiser la longueur du connecteur de mise à la terre et
de réduire les diérences de tension potentielles entre
le câble coaxial de la télévision par câble et les autres
systèmes de mise à la terre. Assurez-vous que le câble
coaxial xé à l’appareil est en bon état physique et qu’il
est correctement serré à l’appareil. Ne bloquez pas les
ouvertures de ventilation. Ne le posez jamais sur des
tissus d’ameublement ou des tapis. Dans les zones
où le nombre de surtensions est élevé, une protec-
tion supplémentaire contre les surtensions peut être
nécessaire.
Pour les modèles équipés d’un service
téléphonique : Les téléphones doivent être connectés
directement au modem téléphonique. Seul un
installateur professionnel peut connecter le modem
téléphonique au câblage téléphonique existant de
la maison. Les connexions physiques avec l’ancien
fournisseur de services téléphoniques doivent être
supprimées. La non-conformité de cette consigne peut
entraîner des conditions dangereuses, une perte de
service ou des dommages permanents.
-
1
-
2
