VNI CE HW EU2 TSR WLC CIR
User manual
Continental
Radio Frequency Transmitter SBRT
Page 1 of 2
VNI CE HW EU2 TSR WLC CIR
1. General description of the RF transmitter
Honda SBRT is a UHF transmitter designed to be a gateway between buckle
switch and a sitting switch, which transmits wirelessly the status of those
switches to the BCM, either upon a request initiated by the BCM using LF
signal, or upon a status change of one or both switches. The term that Honda
customer uses to describe such a transmitter is a Seat Belt Reminder
Transceiver.
SBRT is part of a SMART system to locate seats units and monitor the status
of the sensors.The DUT will be attached below the car seats and inside cabin
area. The number of SBRT’s are different from vechicle to vechicle (Figure 1).
The SBRT is going to work using 433.92MHz working frequency band,
covering the following two functions:
a. 1st function, using 433.66MHz channel frequency. When an LF
request is sent by the BCM, the SBRT is responding accordingly to the
BCM on 433.66MHz.
b. 2nd function, using 433.92MHz channel frequency. When one of the
two switches (BSS- Buckle Switch Sensor or PSS -Passenger Sitting
Switch) are activated, the SBRT is responding accordingly to the BCM
on 433.92MHz.
This device complies with Part 15 of the FCC Rules. Operation is subject
to the following two conditions:
(1) this device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause
undesired operation.
Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
This device complies with Industry Canada’s licence-exempt RSSs. Operation
is subject to the following two conditions: (1) This device may not cause
interference; and (2) This device must accept any interference, including
interference that may cause undesired operation of the device. Le présent
appareil est conforme aux CNR d'Industrie Canada applicables aux appareils
radio exempts de licence. L'exploitation est autorisée aux deux conditions
suivantes: (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de
l'appareil doit accepter tout brouillage radioélectrique subi, même si le
brouillage est susceptible d'en compromettre le fonctionnement
Page 2 of 2
-
1
-
2
dans d''autres langues
- English: Continental SBRT User manual
Autres documents
-
SEOYON ELECTRONICS NYOSYEC3TX1612 Manuel utilisateur
-
Bosch MQB 37W BR22 Manuel utilisateur
-
Olympus Camedia C-7070 Wide Zoom Manuel utilisateur
-
Olympus BCN-1 Manuel utilisateur
-
Sony PCV-RX590G Guide de référence
-
Olympus BCS-5 Manuel utilisateur
-
-
-