



• Read all instructions before installing.

• System is intended for installation by a licensed electrician in accordance with the National Electrical Code (NEC) and local regulations.

• When handling the xture, do not apply pressure to the LEDs. Hold the xture by the base only.

• Retain installation instructions for future maintenance reference.

All parts must be used as indicated in these instructions. This product is designed for use only with the supplied parts and/or

accessories designated for use by dweLED. Substitution of parts or accessories not designated for use with this product by dweLED could

result in personal injury or property damage, and will void the warranty. Contact an authorized dealer or the manufacturer if any parts are

règlements locaux.

• Lors de la manipulation du luminaire, n’appuyez pas sur les LED. Tenez-le uniquement par la base.

Toutes les pièces doivent être utilisées comme indiqué dans ces instructions. Ce produit est conçu pour être utilisé seulement

avec les pièces et/ou accessoires fournis pour être utilisés avec les produits dweLED. Remplacer des pièces ou accessoires non conçus pour ce

produit dweLED pourrait causer des dommages corporels ou matériels et pourrait également causer l’annulation de la garantie. Veuillez

contacter un revendeur autorisé ou le fabricant si des pièces manquent ou sont endommagées.

Les conditions côtières peut causer une accumulation de minéraux et de résidue sur le luminaire. Nous recommendons

aux clients qui resident dans les zones côtières de nettoyer toutes les surfaces externes du luminaire une fois toutes les deux semaines avec

un chion humide.



Mounting Screw

Qty: 1 Extra

Purple - Dim+

Pink or gray - Dim-

Red - Fixture+

Black - Fixture-



Fixture

Allen Screw

Lamp Body

Safety cood

PS:WS-62039 have 1PC 

2. Carefully unpack your new xture and lay out all the parts on a clear area. Be careful not to lose any small parts necessary for installation.



3. Remove the mounting screw (D) from the xture.

4. Secure the mounting plate to the junction box using standard junction box screws that comes with the junction box.

(i)using any other non-original-manufacturer provided junction box screw may result in safty issue;

(ii) The side of the mounting plate marked “GND” must face out.

5. Properly secure the safety cord to the bracket on mounting back plate to temporary hang the xture in place(only WS-62039).



6. Connect the xture’s input wires to junction box wires as shown (. Make sure that all wire connectors (A) are secure. If your outlet

box has a green or bare copper ground wire, connect the xture’s ground wire to it. Otherwise, connect the xture’s ground wire directly

information.

10. To utilize ELV or TRAIC dimming: use wires black (hot), white (neutral) and bare copper ground wire (ground).

11. To utilize 0-10V dimming: use wire purple (dim+), Pink or gray (dim-), black (hot), white (neutral) and bare copper ground wire (ground).

Make sure to connect 0-10V prior to power-up the xture in order to allow the 0-10V dimming to function properly.