Lumination Allusion Glow Lens Guide d'installation
- Taper
- Guide d'installation
LED.com
© 2023 Current Lighting Solutions, LLC. All rights reserved. Information and specifications subject to change
without notice. All values are design or typical values when measured under laboratory conditions.
Page 1 of 2
(Rev 05/23/23)
IND555-Lumination-Allusion-Glow-Difuser-Installation-Guide
WARNING/AVERTISSEMENT
Installation Guide
Allusion
Glow Diuser Installation Supplement
BEFORE YOU BEGIN
Read these instructions completely and carefully.
RISK OF ELECTRIC SHOCK
• Turn power o before inspection, installation or removal.
• Properly ground electrical enclosure.
RISK OF FIRE
• Follow all NEC and local codes.
• Use only UL approved wire for input/output connections.
Minimum size 18 AWG.
• Type IC, inherently protected.
RISK OF INJURY
• Diuser may fall down if not installed properly.
RISQUES DE DÉCHARGES ÉLECTRIQUES
• Coupez l’alimentation avant d’’inspecter, installer ou déplacer le
luminaire.
• Assurez-vous de correctement mettre à la terre le boîtier
d’alimentation électrique.
RISQUES D’INCENDIE
• Respectez tous les codes NEC et codes locaux.
• N’utilisez que des ls approuvés par UL pour les entrées/sorties de
connexion. Taille minimum 18 AWG.
• Type IC, protection inhérente.
RISQUES DE BLESSURE
• Le volet peut tomber s’il n’est pas installé correctement.
Note:
This document is a supplement for the glow diuser installation. Complete xture install instructions have been provided with
the xture.
Provided in the Package
A glow diuser will be included in the packaging with each xture.
• LALR Starter Fixtures: Glow diuser endcaps (Qty. 2)
• LALS Starter Kits: Glow diuser endcaps (Qty. 2)
LED.com
© 2023 Current Lighting Solutions, LLC. All rights reserved. Information and specifications subject to change
without notice. All values are design or typical values when measured under laboratory conditions.
Page 2 of 2
(Rev 05/23/23)
IND555-Lumination-Allusion-Glow-Difuser-Installation-Guide
Lumination® (Glow Diuser Installation Supplement) Installation Guide
Installation
Push diuser so both hooks engage the housing. Inspect
along length of xture to ensure proper connection
2
Squeeze snap hooks together.
Complete the enclosure by installing the endcaps. Slide
diuser under endcap to ensure no LEDs are visible.
1
3
Troubleshooting
Symptom Solution
Components are not tting together. Check the table below to ensure correct parts are being used.
LALS LALR Diuser
Glow Distribution
Endcap
Medium Distribution
Endcap
Glow Distribution
Endcap
Medium Distribution
Endcap
Glow Distribution
(GL)
Medium Distribution
(MM)
Height = 5.0 in Height = 4.5 in Height = 4.5 in Height = 3.8 in Height = 0.8 in Height = 0.3 in
-
1
-
2
Lumination Allusion Glow Lens Guide d'installation
- Taper
- Guide d'installation
dans d''autres langues
Documents connexes
-
Lumination Allusion Louvers Guide d'installation
-
-
-
-
-
-
-