Chief CMA480W Guide d'installation

Catégorie
Kits de montage
Taper
Guide d'installation
INSTALLATION INSTRUCTIONS
Instrucciones de instalación
Installationsanleitung
Instruções de Instalação
Istruzioni di installazione
Installatie-instructies
Instructions d´installation
Below Ceiling Enclosure
Spanish Product Description
German Product Description
Portuguese Product Description
Italian Product Description
Dutch Product Description
French Product Description
CMA480
CMA480 Installation Instructions
2
DISCLAIMER
Milestone AV Technologies and its affiliated corporations and
subsidiaries (collectively "Milestone"), intend to make this
manual accurate and complete. However, Milestone makes no
claim that the information contained herein covers all details,
conditions or variations, nor does it provide for every possible
contingency in connection with the installation or use of this
product. The information contained in this document is subject
to change without notice or obligation of any kind. Milestone
makes no representation of warranty, expressed or implied,
regarding the information contained herein. Milestone assumes
no responsibility for accuracy, completeness or sufficiency of
the information contained in this document.
Chief® is a registered trademark of Milestone AV Technologies.
All rights reserved.
IMPORTANT WARNINGS AND
CAUTIONS!
WARNING: A WARNING alerts you to the possibility of
serious injury or death if you do not follow the instructions.
CAUTION: A CAUTION alerts you to the possibility of
damage or destruction of equipment if you do not follow the
corresponding instructions.
WARNING: Failure to read, thoroughly understand, and
follow all instructions can result in serious personal injury,
damage to equipment, or voiding of factory warranty! It is the
installer’s responsibility to make sure all components are
properly assembled and installed using the instructions
provided.
WARNING: Failure to provide adequate structural strength
for this component can result in serious personal injury or
damage to equipment! It is the installer’s responsibility to
make sure the structure to which this component is attached
can support five times the combined weight of all equipment.
Reinforce the structure as required before installing the
component.
WARNING: Exceeding the weight capacity can result in
serious personal injury or damage to equipment! It is the
installer’s responsibility to make sure the combined weight of
all components located in the CMA480 does not exceed
25 lbs (11.3 kg).
DIMENSIONS
MEASUREMENTS: [MILLIMETERS]
INCHES
Installation Instructions CMA480
3
LEGEND
Tighten Fastener
Apretar elemento de fijación
Befestigungsteil festziehen
Apertar fixador
Serrare il fissaggio
Bevestiging vastdraaien
Serrez les fixations
Loosen Fastener
Aflojar elemento de fijación
Befestigungsteil lösen
Desapertar fixador
Allentare il fissaggio
Bevestiging losdraaien
Desserrez les fixations
Open-Ended Wrench
Llave de boca
Gabelschlüssel
Chave de bocas
Chiave a punte aperte
Steeksleutel
Clé à fourche
By Hand
A mano
Von Hand
Com a mão
A mano
Met de hand
À la main
Hex-Head Wrench
Llave de cabeza hexagonal
Sechskantschlüssel
Chave de cabeça sextavada
Chiave esagonale
Zeskantsleutel
Clé à tête hexagonale
CMA480 Installation Instructions
4
TOOLS REQUIRED FOR INSTALLATION
PARTS
1/8"
(included)
A (1)
[CMA480]
B (1)
1/4-20 x 3/4"
C (1)
1/8"
Installation Instructions CMA480
5
INSTALLATION
WARNING: Failure to provide adequate structural strength
for this component can result in serious personal injury or
damage to equipment! It is the installer’s responsibility to
make sure the structure to which this component is attached
can support five times the combined weight of all equipment.
Reinforce the structure as required before installing the
component.
1. Install ceiling plate following instructions included with the
ceiling plate.
NOTE: The ceiling plate may be an above-ceiling model (such
as the CMA440), or a standard below-ceiling plate
(such as the CMS115).
2. Install extension column following instructions included with
the extension column.
3. Remove one screw from door at each end of CMA480. (See
Figure 1)
Figure 1
4. Open doors of CMA480. (See Figure 2)
Figure 2
5. Loosen carriage bolts and open clamp bracket. (See
Figure 3)
Figure 3
6. Lift CMA480 up and onto extension column, and place
CMA480 flush with the ceiling.
7. Tighten clamp bracket around column, and tighten carriage
bolts. (See Figure 4)
Figure 4
3
x 2
4
5
5
7
7
Cable Management
Holes
CMA480 Installation Instructions
6
8. Insert one 1/4-20 x 3/4" set screw (B) into CMA480
enclosure clamp, and tighten against extension column.
(See Figure 5)
Figure 5
9. Power cords and cables may be run through the cable
management holes. (See Figure 4)
10. Close CMA480 door(s) and secure with screw(s) removed
in Step 3. (See Figure 6)
Figure 6
(B) x 1
8
10
Installation Instructions CMA480
7
CMA480 Installation Instructions
USA/International A 8401 Eagle Creek Parkway, Savage, MN 55378
P 800.582.6480 / 952.894.6280
F 877.894.6918 / 952.894.6918
Europe A Fellenoord 130 5611 ZB EINDHOVEN, The Netherlands
P +31 (0)40 2668620
F +31 (0)40 2668615
Asia Pacific A Room 24F, Block D, Lily YinDu International Building
LuoGang, BuJi Town, Shenzhen, CHINA.
P +86-755-8996 9226
F +86-755-8996 9217
Chief Manufacturing, a products division
of Milestone AV Technologies
8800-002031 Rev00
2009 Milestone AV Technologies, a
Duchossois Group Company
www.chiefmfg.com
07/09
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6
  • Page 7 7
  • Page 8 8

Chief CMA480W Guide d'installation

Catégorie
Kits de montage
Taper
Guide d'installation

dans d''autres langues