Honeywell TH3000 Manuel utilisateur

Operating

Manual

PRO TH3000 Series

Non-Programmable Digital Thermostat

69-1776EF-1

Read and save these instructions.

® U.S. Registered Trademark. Patents pending.

Need Help?

For assistance with this product please visit http://yourhome.honeywell.com

or call Honeywell Customer Care toll-free at 1-800-468-1502

CAUTION: EQUIPMENT DAMAGE HAZARD.

To prevent possible compressor damage, do not operate cooling system when outdoor

temperature is below 50°F (10°C).

This manual covers the following models:

TH3110D: For 1 Heat/1 Cool systems

TH3210D: For 2 Heat/1 Cool heat pump systems only

(Pull thermostat from wallplate and turn over to find model number.)

PRO TH3110D / TH3210D

1

Table of contents

About your new thermostat

Thermostat features ...................................2

Quick reference to controls .......................3

Quick reference to display ........................4

Thermostat Operation

System switch (Heat/Cool) ........................5

Fan switch (Auto/On) .................................6

Temperature controls .................................7

Compressor protection ..............................8

Appendices

Battery replacement .................................. 9

In case of difficulty...................................10

Customer assistance ...............................12

Accessories ..............................................12

5-year limited warranty ............................13

Operating Manual

2

Your new Honeywell thermostat has been designed to give you many years of reliable

service and easy-to-use, push-button climate control.

Features

• Large, clear, backlit display is easy to read, even in the dark.

• Displays both room temperature and temperature setting.

• Built-in compressor protection.

About your new thermostat

PRO TH3110D / TH3210D

3

About your new thermostat

Temperature adjustment

(see page 7)

Fan Switch (see page 6)

On: Fan runs continuously.

Auto: Fan runs only when heating or

cooling system is on.

Quick reference to controls

System switch (see page 5)

• Cool: Cooling system control.

• Off: All systems off.

• Heat: Heating system control.

• Em Heat: Emergency & Auxiliary

Heat control. Compressor is locked

out. (Select models only.)

Digital display screen

Operating Manual

4

System Status

• Cool On: Cooling system is on.

• Heat On: Heating system is on.

• Em: Emergency heat is on. **

• Aux: Auxiliary heat is on. **

Quick reference to display screen

Em Aux

Heat On

Set To

Inside

75

Replace Batt

Current inside temperature

Temperature setting

If “Heat On” or “Cool

On” is flashing, com-

pressor protection is

engaged (see page 8).

Low battery warning

(see page 9)

** Only for heat pumps with this capability

(select models only).

PRO TH3110D / TH3210D

5

The SYSTEM switch can be set to control

your heating or cooling system, depending

on the season.

• Cool: Cooling system control.

• Off: All systems are off.

• Heat: Heating system control.

• Em Heat: Emergency & Auxiliary Heat

control. Compressor is locked out.

(Select models only.)

System switch

Set SYSTEM switch to control the

heating or cooling system.

CAUTION: EQUIPMENT DAMAGE HAZARD.

Do not operate cooling system when outdoor

temperature is below 50°F (10°C).

Operating Manual

6

Fan switch

Set the FAN switch to Auto or On.

In “Auto” mode (the most commonly used

setting), the fan runs only when the heat-

ing or cooling system is on.

If set to “On,” the fan runs continuously.

Use this setting for improved air circula-

tion, or for more efficient air cleaning.

Set FAN switch to choose whether the fan

runs continuously or only as needed.

PRO TH3110D / TH3210D

7

About your new thermostatTemperature controls

Press the temperature adjustment

buttons until the temperature you want

is displayed in the upper right portion of

the screen.

Note: Make sure the SYSTEM switch is set

to the system you want to control (Heat or

Cool).

Desired

temperature.

Temperature

adjustment buttons.

Cool On

Set To

78

Inside

75

Operating Manual

8

This feature helps prevent damage to the

compressor in your air conditioning or heat

pump system.

Damage can occur if the compressor is

restarted too soon after shutdown. This fea-

ture forces the compressor to wait 5 minutes

before restarting.

During the wait time, the display will flash

the message Cool On (or Heat On if you have

a heat pump). When the safe wait time has

elapsed, the message stops flashing and the

compressor turns on.

Message flashes until safe restart

time has elapsed.

Built-in compressor protection

Cool On

Set To

Inside

75

PRO TH3110D / TH3210D

9

Batteries are optional (for backup

power) if your thermostat was wired to

run on AC power when installed.

Install fresh batteries when the REPLACE

BATT warning begins flashing. The

warning flashes about two months

before the batteries are depleted.

Replace batteries once a year, or

before leaving home for more than a

month. Batteries provide backup power

to the display during power interrup-

tions. All settings are permanently

stored in memory, and do not require

battery power.

Pull at bottom to

remove thermostat

from wallplate.

Turn thermostat

over, insert fresh AA

alkaline batteries,

then reinstall ther-

mostat.

Battery replacement

Operating Manual

10

If you have difficulty with your thermostat, please try the following suggestions.

Most problems can be corrected quickly and easily.

Display is blank • Check circuit breaker and reset if necessary.

• Make sure power switch at heating & cooling system is on.

• Make sure furnace door is closed securely.

• Make sure fresh AA alkaline batteries are correctly installed (see page 9).

Heating or

cooling system

does not respond

• Set system switch to Heat (see page 5). Make sure the temperature is

set higher than the Inside temperature.

• Set system switch to Cool (see page 5). Make sure the temperature is

set lower than the Inside temperature.

• Wait 5 minutes for the system to respond.

In case of difficulty

PRO TH3110D / TH3210D

11

Temperature

settings do not

change

Make sure heating and cooling temperatures are set to acceptable ranges:

• Heat: 40° to 90°F (4.5° to 32°C).

• Cool: 50° to 99°F (10° to 37°C).

“Cool On” or

“Heat On” is

flashing

• Compressor protection feature is engaged. Wait 5 minutes for the system

to restart safely, without damage to the compressor (see page 8).

“Heat On” is not

displayed

• Set the System switch to Heat, and set the temperature level above the

current room temperature (see page 7).

“Cool On” is not

displayed

• Set the System switch to Cool, and set the temperature level below the

current room temperature (see page 7).

In case of difficulty

Operating Manual

12

For assistance with this product, please visit

http://yourhome.honeywell.com.

Or call Honeywell Customer Care toll-free at

1-800-468-1502.

To save time, please note your model number

and date code before calling.

Accessories/replacement parts

To order, please call Honeywell Customer Care

toll-free at 1-800-468-1502.

Cover plate assembly* ........Part No. 50002883-001

*Use to cover marks left by old thermostats.

Customer assistance

Turn thermostat over

to find model number

and date code.

Pull at bottom to

remove thermostat

from wallplate.

PRO TH3110D / TH3210D

13

Honeywell warrants this product, excluding battery, to be free from defects in the workmanship

or materials, under normal use and service, for a period of five (5) years from the date of pur-

chase by the consumer. If at any time during the warranty period the product is determined to

be defective or malfunctions, Honeywell shall repair or replace it (at Honeywell’s option).

If the product is defective,

(i) return it, with a bill of sale or other dated proof of purchase, to the place from which you pur-

chased it; or

(ii) call Honeywell Customer Care at 1-800-468-1502. Customer Care will make the determination

whether the product should be returned to the following address:

Honeywell Return Goods, Dock 4 MN10-3860, 1885 Douglas Dr. N., Golden Valley, MN 55422, or

whether a replacement product can be sent to you.

This warranty does not cover removal or reinstallation costs. This warranty shall not apply if it

is shown by Honeywell that the defect or malfunction was caused by damage which occurred

while the product was in the possession of a consumer.

Honeywell’s sole responsibility shall be to repair or replace the product within the terms stated

above. HONEYWELL SHALL NOT BE LIABLE FOR ANY LOSS OR DAMAGE OF ANY KIND,

5-year limited warranty

Operating Manual

14

5-year limited warranty

INCLUDING ANY INCIDENTAL OR CONSEQUENTIAL DAMAGES RESULTING, DIRECTLY OR

INDIRECTLY, FROM ANY BREACH OF ANY WARRANTY, EXPRESS OR IMPLIED, OR ANY

OTHER FAILURE OF THIS PRODUCT. Some states do not allow the exclusion or limitation of

incidental or consequential damages, so this limitation may not apply to you.

THIS WARRANTY IS THE ONLY EXPRESS WARRANTY HONEYWELL MAKES ON THIS

PRODUCT. THE DURATION OF ANY IMPLIED WARRANTIES, INCLUDING THE WARRANTIES

OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE, IS HEREBY LIMITED TO

THE FIVE-YEAR DURATION OF THIS WARRANTY.

Some states do not allow limitations on how long an implied warranty lasts, so the above limita-

tion may not apply to you. This warranty gives you specific legal rights, and you may have other

rights which vary from state to state.

If you have any questions concerning this warranty, please write Honeywell Customer Relations,

1985 Douglas Dr, Golden Valley, MN 55422 or call 1-800-468-1502. In Canada, write Retail

Products ON15-02H, Honeywell Limited/Honeywell Limitée, 35 Dynamic Drive, Scarborough,

Ontario M1V4Z9.

Honeywell International Inc.

1985 Douglas Drive North

Golden Valley, MN 55422

http://yourhome.honeywell.com

Honeywell Limited-Honeywell Limitée

35 Dynamic Drive

Scarborough, Ontario M1V 4Z9

® U.S. Registered Trademark.

69-1776EF-1 M.S. Rev. 04-06

Automation and Control Systems

Printed in U.S.A. on recycled

paper containing at least 10%

post-consumer paper fibers.

Mode

d’emploi

Série PRO TH3000

Thermostat numérique non programmable

69-1776EF-1

Veuillez lire le mode d’emploi et le conserver en lieu sûr.

® Marque de commerce enregistrée aux États-Unis. Brevets en instance

Besoin d’aide?

Pour obtenir de l’aide sur ce produit Honeywell, veuillez consulter le site Web

http://yourhome.honeywell.com ou adressez-vous au Service à la clientèle

de Honeywell en composant sans frais le 1-800-468-1502

MISE EN GARDE : RISQUE DE DOMMAGE MATÉRIEL

Pour éviter d’endommager le compresseur, ne faites pas fonctionner le système de

refroidissement lorsque la température extérieure est inférieure à 10 °C (50 °F).

Le présent mode d’emploi porte sur les modèles suivants :

TH3110D : Pour systèmes à 1 étage de chauffage/1 étage de

refroidissement

TH3210D : Pour thermopompes à 2 étages de chauffage/1 étage de

refroidissement seulement

(Retirer le thermostat de la plaque murale et le retourner pour trouver le

numéro de modèle.)

La page charge ...

Honeywell TH3000 Manuel utilisateur

Ce manuel convient également à

Honeywell TH3000 Manuel utilisateur

dans d''autres langues

Documents connexes

Autres documents