JVC SP-SG2BT Manuel utilisateur

SP-SG2BT
JVC
Marque
JVC
Modèle
SP-SG2BT
Taper
Manuel utilisateur
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment
o and on, the user is encouraged to try to correct the interference by one
or more of the following measures:
— Reorient or relocate the receiving antenna.
— Increase the separation between the equipment and receiver.
— Connect the equipment into an outlet on a circuit dierent from that to
which the receiver is connected.
— Consult the dealer or an experienced radio/TV technician for help.
FCC Warning
Note: The Grantee is not responsible for any changes or modications not
expressly approved by the party responsible for compliance. such
modications could void the user's authority to operate the equipment.
The device has been evaluated to meet general RF exposure requirement.
The device can be used in portable exposure condition without restriction.
This device complies with Industry Canada license-exempt RSS standard(s).
Operation is subject to the following two conditions: (1) this device may
not cause interference, and (2) this device must accept any interference,
including interference that may cause undesired operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables
aux appareils radio exempts de licence. L'exploitation est autorisée aux
deux conditions suivantes : (1) l'appareil ne doit pas produire de brouillage,
et (2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique
subi, même si le brouillage est susceptible d'en compromettre le
fonctionnement.
The device has been evaluated to meet general RF exposure requirement.
The device can be used in portable exposure condition without restriction.
The device has been evaluated to meet general RF exposure requirement.
le dispositif de a été évalués à répondre général rf exposition exigence.
IC Warning
FCC ID: 2AYBO-SPSG2BT IC: 282B-SPSG2BT
SP-SG2BT
  • Page 1 1

JVC SP-SG2BT Manuel utilisateur

SP-SG2BT
JVC
Marque
JVC
Modèle
SP-SG2BT
Taper
Manuel utilisateur
Télécharger le PDF
rapport

dans d''autres langues

Autres documents