®®
KOALA KARE PRODUCTS
Installation and Operation Instructions
KB112-01RE
Baby Changing Station
Cambiador Plegable
Table à Langer
Babywickelstation
Your unit should be installed to meet 2010 ADA Standards for Accessible Design when and where applicable.
You are responsible for the safe operation of this unit.
IMPORTANT. RETAIN FOR FUTURE REFERENCE. READ CAREFULLY.
IMPORTANTE. GUÁRDELO PARA FUTURAS CONSULTAS. LEER ATENTAMENTE.
IMPORTANT. À CONSERVER POUR INFORMATION. À LIRE ATTENTIVEMENT.
WICHTIG. ZUR SPÄTEREN BEZUGNAHME AUFBEWAHREN. BITTE SORGFÄLTIG DURCHLESEN.
KB112-01RE Operating Instructions
Tools Needed
Hardware Provided
Please Note: To assure proper installation, it is suggested that a qualied person or carpenter
install the Koala Baby Changing Station. Koala Kare Products will not be responsible if the station is
not installed properly. Koala Baby Changing Stations are intended for use on an existing countertop
surface that is capable of holding signicant weight. Unit should be permanently mounted to the
countertop surface per the installation instructions. When an infant is placed onto the changing
surface, use strap and buckle to secure infant to the changing surface. Never Leave Child Unattended.
You are responsible for the safe operation and use of this product. Not intended to hold more than 50
lbs.
Restraint System: To fasten the waist restraint strap, place strap around child’s midsection, and
push spring tabs into buckle until both spring tabs lock in place with an audible “click”. Straps can be
adjusted to make strap tighter or looser as required.
Inspection Criteria:
• A properly maintained baby changing station:
• Is free of any cracks or damage that can cause injury.
• Has both ends of a functioning, non-frayed strap:
buckle clicks when closed and strap is attached to unit at both ends.
• Check labels and replace as needed.
gloves
level
drill
measuring
tape
1/8” (3 mm)
(regular & masonry)
drill bits
pencil
Phillips head
screwdriver
Sealant (Silicone)
eight screw
cover bases
eight 10 x 1¼”
Phillips
panhead wood screws
eight screw covers
Step 1.
Remove changing station from the shipping
container and check for any freight damage.
Identify the best location for installing the unit.
Step 2.
Remove the rough opening template from
the shipping carton. Remove paper template
and lay it on the surface where the unit will
be mounted. Drill hole in interior of rough
opening to allow saw access. Cut out rough
opening.
Step 3.
Construct under counter support as shown in
the illustration. Support should be 3” below
bottom of mounting surface.
Step 4.
Place the Countertop Baby Changing Station (BCS) onto counter surface and place in
desired position. Using the mounting holes as a guide, mark the screw hole locations with a
pencil. Remove BCS and drill holes with a 1/8” diameter drill bit.
Step 5.
Place BCS onto counter surface using the drilled holes as a guide. Slide screw through the
screw cover base. Screw fasteners through holes into countertop surface. Securely snap
screw cover onto screw cover base. Apply a suitable water sealant (not provided) such as
silicone around the base of the BCS.
*Note: If drilling into marble or granite, take care to not crack or chip the surface
area while drilling. Larger drill bit may be necessary.
KB112-01RE Installation Instructions
2”X 4” SUPPORT WITH
MOUNTING BRACKETS
ON EACH END
PLACE SEALANT
UNDER EDGE
3”
(76 mm)
KB112-01RE ASTM F2285-04 (2016)
ENGLISH
WARNING:
Never leave child unattended.
WARNING: Avoid serious injury from fall-
ing or sliding out. Always use restraint system.
WARNING: Designed for Infants Only.
Age up to 3.5 years and weighing less than 50 lbs
(22.7 kg). Keep one hand on the child at all times.
Parcels or accessory items, or both, placed on the
unit may cause the unit to become unstable.
FRANÇAIS
ATTENTION:
Ne laissez jamais un enfant sans surveillance.
ATTENTION: Évitez les blessures
occasionnées par une chute ou une glissade.
Utilisez toujours le système de retenue.
ATTENTION: Conçue uniquement pour
les jeunes enfants. Jusqu’à 3 ans et demi et moins
de 50 lb (22.7 kg). Conservez une main sur l’enfant
à tout moment.
Tout paquet ou accessoire placé sur la table peut
créer un déséquilibre.
ESPAÑOL
ADVERTENCIA:
No deje nunca al niño desatendido.
ADVERTENCIA: Evite que el niño se
lesione por caerse o resbalarse del cambiador Use
siempre el sistema de sujeción.
ADVERTENCIA: Diseñado exclusiva-
mente para bebés. Hasta 3 años y medio de edad
y con un peso inferior a 50 libras (22,7 kg aproxi-
madamente). Mantenga siempre al niño sujeto con
una mano.
Colocar paquetes o accesorios, o ambas cosas,
encima del cambiador puede provocar que se
desestabilice.
DEUTSCH
WARNUNG:
Das Kind niemals unbeaufsichtigt lassen.
WARNUNG: Ernsthafte Verletzungen
durch Herausfallen oder Herausrutschen ver-
hindern. Immer das Rückhaltesystem verwenden.
WARNUNG: Dieses Produkt ist nur für
Kleinkinder bis zu 3 1/2 Jahren und einem Gewicht
von höchstens 50 lbs. (22.7 kg) vorgesehen. Das
Kind immer mit einer Hand festhalten.
Durch Ablegen von Päckchen und Zubehör auf der
Wickelstation kann diese instabil werden.
Koala Kare Products A Division of Bobrick
6982 South Quentin St., Centennial, CO 80112-3945
Main 303.539.8300 Toll Free 888.733.3456
Fax 303.539.8399
Koalabear.com
P/N 974- April 2018
-
1
-
2
-
3
-
4
Koala Kare KB112-01RE Mode d'emploi
- Taper
- Mode d'emploi
- Ce manuel convient également à
dans d''autres langues
Documents connexes
-
Koala Kare KB112-01CT Mode d'emploi
-
-
Koala Kare 300-5-KIT Mode d'emploi
-
-
-
-
-
Koala Kare KB115 Manuel utilisateur
-
-
Koala Kare 311-33-KIT Mode d'emploi