The Great Outdoors 72596-143C Manuel utilisateur
- Taper
- Manuel utilisateur
INSTALLATION INSTRUCTIONS
Model #72596
READ AND SAVE THESE INSTRUCTIONS
WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER.
AVERTISSEMENT! COUPER LE COURANT AU NIVEAU DES FUSIBLES OU DU DISJONCTEUR.
BARE COPPER(GROUND)
Fig.2
FIXTURE
WIRES
WHITE
BLACK
(HOT)
WIRES
HOUSE
GREEN OR
WHITE
(NEUTRAL)
WIRES
HOUSE
(GROUND)
COPPER
BARE
FIXTURE
WIRES
BLACK
WIRES
FIXTURE
GREEN OR
HOUSE
WIRES
PREPARING FOR INSTALLATION (Fig. 1)
1. Shut off the power at the fuse box or circuit breaker box
(avertissement! couper le courant au niveau des fusibles ou
du disjoncteur) and remove the old fixture, including the
mounting hardware.
2. Carefully unpack your new fixture and lay out all the parts in
a clear area. Take care not to misplace any small parts
necessary for installation.
3. Pull the black, white and ground wires out of post (A).
CONNECTING THE WIRES (Fig. 2)
4. Connect electrical wires while supporting the lantern. If your
post has a ground wire (green or bare copper), connect the
fixture ground wire to it. If not, consult your electrician for
proper grounding. (Fig.2)
COMPLETING THE INSTALLATION (Fig. 1)
5. Align the lantern (C) with post (A) and secure with screws
(B). (Fig.1)
6. At this point, unscrew hex coupling (H), flat washer
(I),rubber washer (J),roof (K), to install 4*40W/E12/B bulb
(no bulb included) in accordance with the fixture
specification –DO NOT EXCEED THE MAXIMUM WATTAGE
RATING! (NE PAS DEPASSER LA PUISSANCE
NOMINALE MAXIMALE!)
7. Replace the roof (K), rubber washer (J), flat washer (I), hex
coupling (H),nipple (G),frame (F),roof (E)and secure with
fixture loop (D).
Your installation is now complete. Return power and test the
fixture.
Fig. 1
“CAUTION-RISK OF FIRE CONSULT A
QUALIFIED ELECTRICIAN TO ENSURE
CORRECT BRANCH CIRCUIT CONDUCTOR”
ATTENTION – RISQUE D’INCENDIE, CONSULTER UN
ÉLECTRICIEN QUALIFIÉ POUR VOUS ASSURER QUE
LES CONDUCTEURS DE LA DÉRIVATION SONT
ADÉQUATS.
This product is protected by United
States Federal and/or State Law,
including Patent and/or Copyright laws.
© Minka Lighting Inc.
Candle Sleeve #
CCV22090P-143
-
1
