SET
1 Rev July 21, 2023 403-216-7043 | [email protected]
5 YEAR
WARRANTY
MADE IN
CANADA
Read and follow these
instructions before installing or
maintaining this product
Veuillez lire et suivre ces
instructions avant l’installation ou
l’entretien de ce produit
• This product is suitable for DRY INDOOR
LOCATIONS ONLY
• Make sure this product is NOT on the same
circuit as inductive loads, (e.g. fluorescent bulbs,
discharge bulbs, ventilation fans, etc...)
• Allow air to flow freely around the fixture
• Do not switch on line voltage until all wiring is
complete
• Incorrect wiring will result in irreparable damage
to LED and power supply
• This product should only be installed by a
licensed electrician
• Ce produit convient pour une installation DANS
UN ENDROIT SEC SEULEMENT
• Assurer vous que des charges inductives ne se
retrouvent pas sur le même circuit que ce produit,
(i.e. fluorescent, ampoules à décharge,
ventilateurs, etc...)
• Permettre à l’air de circuler librement autour du
luminaire
• Compléter les branchements avant de mettre
sous tension
• Un branchement incorrect créerait des
dommages irréparables à l’alimentation et au DEL
• Ce produit devrait être uniquement installé par un
électricien qualifié
Warranty
Garantie
• This product must be installed in accordance
with all applicable installation codes and
ordinance
• Limited five (5) years warranty
• Warranty is void in the eventuality of
unauthorized modifications and/or improper use
• Ce produit doit être installé conformément au
code d’installation et autres normes applicables
• Garantie limitée de cinq (5) ans
• La garantie est non valide advenant une
modification non autorisée ou un usage non
approprié
Overview
SET
2 Rev July 21, 2023 403-216-7043 | [email protected]
5 YEAR
WARRANTY
MADE IN
CANADA
2.0”
[51mm]
2.0”
[51mm]
2.0”
[51mm]
2.0”
[51mm]
Drivers and Wiring
Non-Dimming Driver: 902-35010 (10W)
Constant Current
1-7 Fixtures per driver wired in series.
Remote Driver can be mounted Horizontally or Vertically.
Minimum clearance of 2” (51mm) around the driver is required for
proper air circulation.
Constant Current Driver
Class II Wiring
AC
Set Set Set
Dimming Driver: 902-35025 (25W)
Constant Current
3-17 Fixtures per driver wired in series.
Remote Driver can be mounted Horizontally or Vertically.
Minimum clearance of 2” (51mm) around the driver is required for
proper air circulation.
On-site installer to provide wire for connection between driver and fixture.
SET
3 Rev July 21, 2023 403-216-7043 | [email protected]
5 YEAR
WARRANTY
MADE IN
CANADA
1
Cut hole to correct size and in all desired
locations.
Finish surface and ensure wiring reaches
all locations. Pull wire through hole and
make electrical connections.
Push fixture into hole. Springs will release
once it clears the ceiling.
2 3
4
SET
4 Rev July 21, 2023 403-216-7043 | [email protected]
5 YEAR
WARRANTY
MADE IN
CANADA
Do not scale this when printing this template.
Ne l’augmentez pas lorsque vous imprimez ce modèle.
1.4”
[36mm]
-
1
-
2
-
3
-
4
Documents connexes
-
luminii Place Guide d'installation
-
-
-
-
-
-
-
-
-