JLB7tech JLB853 4.3-Inch Split Screen Video Baby Monitor Manuel utilisateur
- Catégorie
- Moniteurs vidéo bébé
- Taper
- Manuel utilisateur
JLB853
WARNING
STRANGULATION HAZARD
Children have STRANGLED in cords.
Keep this cord out of reach of children (more than 3 feet/1 meter away
from the crib). Never use extension cords with AC adapters. Only use the
AC Adapters provided.
WARNING
Adult assembly required. Keep small parts
away from children when assembling.
Warning Information
Keep this instrmanual fr
future reference.
Fr adult usey.
WARNING
· When an AC Adapter is plugged into an electrical outlet, do not the exposed end.
· Test baby monitor before first use, periodically, and when changing locaon of the baby unit(Camera).
· Do not use monitor near water (Such as bathtub, Sink, etc).
· Keep parent unit away from heat sources (Such as stoves, radiators, etc).
· Make sure there is proper venlaon around baby unit and parent unit.
·This product is not a toy. Do not allow children to play with it.
· The mains plug or an appliance coupler is used as the disconnect device, the disconnect device shall remain readily
operable.
· The baby monitor should not be considered as a medical device. While using the baby monitor, it is strongly
recommended to have an adult directly checking on your baby. Premature babies or children considered at risk must be
supervised by your pediatrician or other medical staff.
THIS PRODUCT CANNOT REPLACE RESPONSIBLE ADULT SUPERVISION
· Use only the original rechargeable baery provided.
· Do not shot-circuit supply terminals.
· Remove baery when product is stored for long periods of me or when baery is exhausted.
· Dispose of exhausted baery properly.
· Keep all baeries away from children.
· The apparatus shall not be exposed to dripping or splashing and that no objects filled with liquids, such as
vases, shall be placed on the apparatus.
· Danger of explosion if baery is incorrectly replaced. Replace only with the same or equivalent type.
· Baeries (baery pack or baeries installed) shall not be exposed to excessive heat such as sunshine, fire or the like.
Baery WarningPrecauons
· Do not overload wall outlets, extension cords, or integral convenience receptacles as this can result in a risk of fire or electrics
shock.
· The baby monitor works beer in temperature ranging between 0 and 40 (32 and 104 ).
· Do not dismantle the appliance. It does not contain any parts that may be used independently.
· Never expose the baby monitor for long period to sun’s direct rays and never place it next to a source of heat, in a damp or
very dusty room.
· Never push objects of any kind into this product through openings they may touch dangerous voltage points or short-out
parts that could result in a fire or electric shock. Never spill liquid of any kind on the product.
· Do not aempt to service this product yourself as opening or removing covers may expose you to dangerous voltage or other
hazards. Refer all servicing to qualified service personnel.
·The product should be mounted to a wall or ceiling inly as recommended by the manufacturer.
INSTRUCTION MANUAL
1Setup and use your digital video baby monitor
Installing Baby Unit
A. Place Baby Unitat surface, such as a deskethe camerwall.
1 meter
Never place the baby unit crd
within 1 met
ect the small plugthe pwer adapter tthe Baby Unit and tther end ta
suitable electricatlet. Only use the encled adapter (5V DC 1000mA).
B.
cg the pwer supply fthe Parent Unit.
ct the small plugthe pwer adapter tthe parent unit and tther end t
a electricatlet. Only use the encadapter (5V DC/1000mA).
Recmmend charginat least 3rs befrerst use.
C.
2
When baery is lw, the pwercwash red acreen
display baery icwash red indicag that the baery needs t
charged.
Notice:
If you use the parent unit for the first time, when you turn on the parent unit, some boot menus
will pop-up on the screen, we try to explain status and function on these menus, please
according to the tips to switch to the monitor system interface. When you are fimaliar with
this monitor, you could switch off these on screen tips in menu.
Precaution: use of battery for Parent Unit
Only charge the battery when the battery life indicator is low. Constant
recharging of your battery before the low battery indicator light comes on will
decrease the life of your batteries.
USB CHARGING
TALK MENU
SPLIT
VOX
POWER
Split Screen View
. Use
Power on off status LED
Steady Green: Parent Unit is pwer.
Steady Orange: Charging bery.
Flash Red: Beryw
Power Saving on off status
Steady Green: Pwer saving m vated.
Sound Level indicator
Visual indicatr fr
picked up frm baby unit.
r the
frm Baby unit, the mre
are light.
Power Saving-on/off mode
Screen is switctave bery
energy
hen baby cry l
egh, screen is switct
display baby’s viBaby cry level is
adjustable frm Menu sng (Sevity
evel , M, H).
unit.
MENU
Microphone
Power
TALK MENU
SPLIT
VOX
POWER
Press tswitc/ Pwer Saving (
ress tst menu se
ress t)
ress tst menu se
rttalk tby unit.
Talk
Up/Down
Camera Up/Down
Left/Right
Camera Left/Right
Select
Power Saving-on/off
VOX
OK
SPLIT
TALK
3Function of keys and LED indicators
Parent Unit
JLB853
This device complies with Part 15 of the FCC Rules. Operaon is subject to the following two condions:
(1) This device may not cause harmful interference, and (2) This device must accept any interference received, including
interference that may cause undesired operaon.
FCC Cauon
To assure connued compliance, any changes or modificaons not expressly approved by the party responsible for
compliance could void the user's authority to operate this equipment. (Example -use only shielded interface cables when
connecng to computer or peripheral devices).
FCC Radiaon Exposure Statement
This equipment compliew with FCC RF radiaon exposure limits set forth for an uncontrolled environment. This
equipment should be installed and operated with a minimum distance of 20 cenmeters between the radiator and your
body.
This transmier must not be co-located or operang in conjuncon with any other antenna or transmier.
The antennas used for this transmier must be installed to provide a separaon distance of at least 20 cm from all persons
and must not be co-located or operang in conjuncon with any other antenna or transmier.
Industry Canada Statement
This device cmplies with Industry Canada licence-eempt RSS standard.
Oper is subject t the flwing tw c: (1) this device may t cause interference,
and () this device must accept any interference, including interference that may cause undesired
erthe device.
résent appareil est cnfrme aR d'Industrie Canada applicables aappareils radieempts
de licence'elitst autrisée aecvantes :
(1) l'appareil ne it pas prre de brllage, et () l'lisateur de l'appareil t accepter tut
bruillage radlectrique subi, même si le bruillage est susceble d'en cmprmre le
fment.
INSTRUCTION MANUAL 4Start to use monitor
Status bar
Signal strength reference
Camera number
Baby rm temperature
Bery level
Talk funvated
Zm in is vated Mitmuted
Scan view is vated
CAM1
SCREEN OFF
SPLIT
SCREEN
SCAN
2 3 C
is vated
ECO
Menu operation
SCAN: Display paired camerae bye.
View: Select and display the camera.
Sound Bar:
Reset:
paired list.
OutIn
Zoom
Explanaon On/Off:
TIPS
RESET
Adjust Parent Unit CD
Brightness lighterr darker.
Adjust Parent Unit .
.
Baby Unit
Pairing button
PAIR
Antenna
:Camera Antenna
Microphone
Loudspeaker
USB port
Room Temperature sensor
:
Gather rm temperature infrmn
Pairing button
Federal Communication Commission Interference Statement
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15
of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance
with the instructions, may cause harmful interference to radio communicaotions. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one of the following measures:
. Reorient or relocate the receiving antenna.
. Increase the separation between the equipment and receiver.
. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
. Consult the dealer or an experienced radio/TV technician for help.
23 C CAM1SCREEN OFFSCAN
+
o
23 C CAM1ECOSCAN
+
o
Power saving mode:
Tvate Parent unit frm Pwer saving me
Quiet: Baby cry a lle bit tvate the Parent Unit.
Medium: Baby cry merate tvate the Parent Unit.
Loud: Baby cryr tvate the Parent Unit.
Turn off screen and leave audio on:
ECO mode:
T
POWER
SAVING
Repeat: Repeat all lullabies
OFF: .
ADD: Add aal camera
Step 1: Mve the parent unit tthe same area as the camera. Bth parent and baby unit are
switc.
Step : Select ADD in Menu. The net available camera will autcally be highlighted.
Press Selecttegin pairing.
Step 3: Within 10 secrPairingcamera.
Step 4: Once successfully paired, the camera light will stg and videwill appear
the mtcreen within sec.
Split screen view:
the camera which marked
in red frame.
SPLIT
*
e.
a
ECO
SCREEN
OFF
High: Beep Alarm is issued when rm temperature is higher than
this sng.
Low: Beep Alarm is issued when rm temperature is lwer than this
sng.
C: Display temperature in Celsius scale.
F: Display temperature in Fahrenheit scale.
Temperature calibraon: calibrate rm temperature display tyr
standardize.
ON: vate rm temperature alarm fun.
OFF: Devate rm temperature alarm fun.
HIGH
LOW
ON
OFF
C
F
23 C
o
23 C
o
Temperature alert is
avated
Delete: Delete paired camera frm the list.
Use arrow key to select camera. Audio comes from the camera
where red square is. Press MENU button to start Audio Scan mode.
Monitor cycles audio between cameras about every 10 seconds.
JLB7Tech’s baby monitor warranty policy
JLB7Tech will repair or replace (at our option) your unit free of charge for 12 months from the date of purchase
if the unit is defective in workmanship or materials. To claim your repair/replacement, the product must
be returned to JLB7Tech together with a copy of the purchase receipt. In the absence of the purchase receipt,
the warranty will be 12 months from the date of manufacture. This warranty does not apply to normal wear or
damage from misuse, abuse, improper and handling, installation, accident, unauthorized repair or alteration.
Please contact our Customer service by Facebook JLB7Tech or via email for details.
IC Radiation Exposure Statement:
This equipment cmplies with IC RSS- radiere limit set frth fr an uncntrlled envirment. This equipmentd
be installed arated with minimum distance between the radiatr and ydy.
Cet équipement est cnfrme a CNR- d'Industrie Canada. Cet équipement it êtreinstallé et lisé avec une distance minimale
de cmètres entre le radiateur et vtrecrps. Cet émeur ne it pas être ccalisées rant en cnn avec
autreantenne émeur. es antennes lisées ur cet émeur vent être installés urnir une distance de sépar'au
m cemètre de tte pere etit pas être ctuée ni feavec une au
Kick Stand
Flit the kick stand and place the Parent Unita
stable, level surface.
Battery Door
Open the beryr
tchange bery.
Antenna
ntenna taveer receivide
HW Reset
USB port
Loudspeaker
Reset
-
1
-
2
JLB7tech JLB853 4.3-Inch Split Screen Video Baby Monitor Manuel utilisateur
- Catégorie
- Moniteurs vidéo bébé
- Taper
- Manuel utilisateur
dans d''autres langues
Documents connexes
Autres documents
-
Levana Mila Additional Camera Mode d'emploi
-
Remote Tech RT-NI3SG Manuel utilisateur
-
JUAN JA2215 Manuel utilisateur
-
JUAN JA2216 Manuel utilisateur
-
Alecto DVM-200 Manuel utilisateur
-
Alecto DVM-201 Le manuel du propriétaire
-
Alecto DVM-143 Manuel utilisateur
-
VTech VM341-2 Manuel utilisateur
-
-
VTech Scroll & Learn Camera Manuel utilisateur