Dell DWRFID2003 Manuel utilisateur

OEM Installation Guidance

For Dell RFID 13.56MHz Wireless Module, FCC ID: E2K‐DWRFID2003,

IC ID: 1514B-DWRFID2003

‐ OEM integrators must ensure that its product is electrically identical to Dell’s reference designs. Any

modifications to Dell’s reference designs may invalidate regulatory approvals in relation to the product,

or may necessitate notifications to the relevant regulatory authorities.

‐ OEM integrators are responsible for regression testing to accommodate changes to designs, new

antennas, and host and submit for C2PC filings.

Colocation with other transmitter modules will be addressed through filings for those co‐located

transmitters when necessary or that colocation of other transmitters will be according to applicable

KDB guidelines including those for RF exposure

‐The final system integrator must ensure there is no instruction provided in the user manual or

customer documentation indicating how to install or remove the transmitter

‐ Appropriate labels must be affixed to the product that complies with applicable regulations in all

respects. The regulatory label on the final system must include the statement: “Contains FCC ID:

E2K‐ DWRFID2003 and/or IC: 1514B‐ DWRFID2003”.

‐ A user’s manual or instruction manual must be included with the product that contains the text as

required by applicable law shall be provided to OEM integrators. They may include:

1. USA—Federal Communications Commission (FCC)

FCC COMPLIANCE STATEMENT:

This device complies with part 15 of the FCC Rules. Operation is subject to the following two

conditions:

(1) This device may not cause harmful interference, and (2) this device must accept any interference

received, including interference that may cause undesired operation.

INFORMATION TO USER:

This equipment has been tested and found to comply with the limits for a Class B digital device,

pursuant to Part 15 of FCC Rules. These limits are designed to provide reasonable protection against

harmful interference in a residential installation. This equipment generates, uses, and can radiate

radio frequency energy. If not installed and used in accordance with the instructions, it may cause

harmful interference to radio communications. However, there is no guarantee that interference will

not occur in a particular installation. If this equipment does cause harmful interference to radio or

television reception, which can be determined by tuning the equipment off and on, the user is

encouraged to try and correct the interference by one or more of the following measures:

‐Reorient or relocate the receiving antenna

‐Increase the distance between the equipment and the receiver.

‐Connect the equipment to outlet on a circuit different from that to which the receiver is connected.

‐Consult the dealer or an experienced radio/TV technician for help.

FCC Caution: Any changes or modifications not expressly approved by the party responsible for

compliance could void the user's authority to operate this equipment.

The final host manual shall include the following regulatory statement: