1
Installation Instructions for
Osborne Pendant
1.0
P1488
Pendant
P1488
1
2
1A
3
4
5
Feed the fixture wires through the washer and cover, then screw the cover onto the socket assembly stem.
Feed the fixture wires through the upper frame and screw it onto the cover.
Feed the fixture wires through the fixture loop and screw it onto the upper frame.
Install the candle tube by sliding it over the socket.
Install the candle follower by placing it on top of the candle tube.
Screw the lamp into the socket. Refer to the label on the lamp socket for Max Wattage information.
Insert the shade into the lower frame, then secure the lower frame to the upper frame by screwing the fasteners to the lower frame.
Follow enclosed supplement installation instructions for electrical and fixture installation onto house junction box.
CAUTION RISK OF FIRE-
This product must be installed in accordance with the
applicable installation code by a person familiar with the
construction and operation of the product and the hazards
involved.
Use minimum 90°c supply conductors.
GP I :ENERAL RODUCT NFORMATION
These fixtures are intended to be installed utilizing compliant junctionNEC
boxes.
This product is safety listed for damp locations.
Incandescent lamps may be dimmed with a standard incandescent dimmer.
LED LEDlamps may be dimmed with a dimmer. Consult lamp manufacturer for
additional information.
This instruction shows a typical installation.
WASHER
CANDLE TUBE
CANDLE FOLLOWER
7
5
4
LAMP
6
LOWER FRAME
SHADE
FASTENER
SOCKET ASSEMBLY
COVER
UPPER FRAME
6
7
FIXTURE LOOP
3
8