Intermec CN3NI Supplementary Manual

Taper
Supplementary Manual

Ce manuel convient également à

CN3NI Compliance Insert
Important Operating Instructions
The Model CN3 Non-Incendive (NI) mobile computer has been qualified by Underwriters Laboratories Inc., to the requirements of the
USA and Canada for use in Class I, Division 2-Groups A, B, C, D; Class II, Division 2-Groups F, G; and Class III, Division 2; and Non-
Hazardous locations only. The CN3NI has a T4 temperature code.
Underwriters Laboratories Inc. (UL) has not tested the performance or reliability of the Global Positioning System (GPS) hardware, GPS
operating software, or other GPS-related aspects of this product. UL has only tested for the explosion, fire, shock, and casualty hazards
required by the applicable hazardous locations standards. UL certification does not cover the performance or reliability of the GPS hardware,
GPS operating software, or other GPS-related aspects of this product. UL MAKES NO REPRESENTATIONS, WARRANTIES, OR
CERTIFICATIONS WHATSOEVER REGARDING THE PERFORMANCE OR RELIABILITY OF ANY GPS RELATED
FUNCTIONS OF THIS PRODUCT.
The users of this product are cautioned to use accessories and peripherals approved by Intermec Technologies Corporation. The use of
accessories other than those recommended, or changes to this product that are not approved by Intermec Technologies Corporation, may
void the compliance of this product and may result in the loss of the users authority to operate the equipment.
Warnings and Cautions
Note: This unit has no operator replaceable parts other than the battery pack. Repair of the CN3NI unit must be performed by trained
Intermec service personnel.
Note: From time to time additional battery packs may be added to the qualifications of the CN3NI. Contact your local Intermec
representative if AB9 or AB16 are no longer available as replacement battery packs.
The following additional recommendations must be observed for the safety of the operator and others in potentially hazardous Division 2
locations:
The CN3NI must only be used when the ambient temperature is between -20°C and 50°C (-4°F and 122°F).
The CN3NI may NOT be connected to any other of its available accessories while in potentially hazardous locations. These accessories
include anything that uses the communications dock connector. Allowed connections must be made while outside of the potentially
hazardous location.
The use of Secure Digital and SIM cards in the CN3NI while in potentially hazardous locations is permitted as long as these cards are
not removed or changed while in the hazardous location.
Any connector cover removed while in ordinary locations must be reinstalled prior to entering a Class II or III potentially hazardous
location.
Caution: This marking indicates that the user should read all included documentation before use.
Attention: Ce marquage indique que l’usager doit, avant l’utilisation, lire toute la documentation incluse.
Warning: Explosion Hazard – Substitution of components may impair suitability for Division 2 Class I, II, III locations.
Avertissement: Risque d’explosion – Le remplacement de composants risque de compromettre l’adaptation du produit
aux sites de division 2 catégorie I, II, III.
Warning: Explosion Hazard – Batteries must only be changed or charged in an area known to be non-hazardous. Use
ONLY Intermec battery Model AB9 or AB16.
Avertissement: Risque d’explosion – Les batteries doivent uniquement être remplacées ou rechargées dans un endroit non
dangereux. Utiliser UNIQUEMENT le Modèle de batterie AB9 ou AB16 d’Intermec.
Caution: The battery pack used in this device may present a fire or chemical burn hazard if mistreated. Do not
disassemble or heat above 100°C (212°F). Promptly dispose of used battery pack according to the instructions. Keep away
from children.
Attention: Le bloc-piles utilisé dans cet appareil peut prendre feu, constituer un risque de brûlure chimique, exploser ou
dégager des substances toxiques s’il est manipulé de façon inappropriée. Ne pas jeter au feu, démonter ou chauffer à plus
de 100 °C (212 °F). Mettre rapidement au rebut tout bloc-piles usé, conformément aux instructions. Garder hors de la
portée des enfants.
FCC Digital Emissions Compliance
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates
uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the radio or television receiving antenna.
Increase the separation between the computer equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the radio or television receiver is connected.
Consult the dealer or an experienced radio television technician for help.
Canadian Digital Apparatus Compliance
This Class B digital apparatus meets all requirements of the Canadian Interference-Causing Equipment Regulations.
Conformité aux normes canadiennes sur les appareils numériques
Cet appareil numérique de la classe B respecte toutes les exigences du Réglement sur le matériel brouilleur du Canada.
Battery Information
Battery Recycling Information
Note: In the U.S.A., the EPA does not consider spent Li-ion batteries as hazardous waste.
Specific Absorption Rate (SAR)
Radio Wave Exposure and Specific Absorption Rate (SAR) Information for Model CN3NI Configurations with 802.11b/g Radio
The FCC permits a maximum SAR value of 1.6 W/kg. For use at the ear, the highest SAR value for the Model CN3NI as tested by BABT, is
0.036 W/kg. For body-worn operation, the highest SAR value for the Model CN3NI, as tested by BABT, is 0.087 W/kg. For head-worn
operation, the highest SAR value for the Model CN3NI, as tested by BABT, is 1.031 W/kg.
Pour une utilisation à l’oreille, le TAS limite pour le modèle CN3NI, tel que testé par le BABT, est de 0,036 W/kg. Pour une utilisation au
corps, le TAS limite pour le CN3NI, tel que testé par le BABT est de 0,087 W/kg.
This product has been tested and meets the FCC RF exposure guidelines when used with the Intermec accessories supplied or designated for
this product. Use of other accessories may not ensure compliance with FCC RF exposure guidelines.
Ce produit a été testé et répond aux directives de la FCC en matière d’exposition aux radiofréquences lorsqu’il est utilisé avec les accessoires
Intermec fournis ou conçus pour ce produit. L’utilisation d’autres accessoires pourrait contrevenir aux directives de la FCC en matière
d’exposition aux radiofréquences.
Caution: The battery pack used in this device may ignite, create a chemical burn hazard, explode, or release toxic
materials if mistreated. Do not incinerate, disassemble, or heat above 100°C (212°F). Charge only with Intermec Models
AC14, AD10, AD11, AD12, or AV6. Do not short circuit; may cause burns. Keep away from children.
Use only Intermec battery pack Model AB9 or AB16. Risk of fire or explosion if incorrect battery pack is used. Promptly
dispose of used battery pack according to the instructions.
Attention: Le bloc-piles utilisé dans cet appareil peut prendre feu, constituer un risque de brûlure chimique, exploser ou
dégager des substances toxiques s’il est manipulé de façon inappropriée. Ne pas jeter au feu, démonter ou chauffer à plus
de 100 °C (212 °F). Ne charger qu’avec les dispositifs Intermec AC14, AD10, AD11, AD12, ou AV6. Ne pas court-
circuiter; cela pourrait causer des brûlures. Garder hors de la portée des enfants.
N’utiliser que le modèle de bloc-piles Intermec AB9 ou AB16. L’utilisation d’un mauvais bloc-piles pourrait constituer un
risque d’incendie ou d’explosion. Mettre rapidement au rebut tout bloc-piles usé, conformément aux instructions.
Li-ionLi-ion
This product contains or uses a lithium ion (Li-ion) main battery. When the battery reaches the end of its useful life, the
spent battery should be disposed of by a qualified recycler or hazardous materials handler. Do not mix this battery with the
solid waste stream. Contact your Intermec Technologies Service Center for recycling or disposal information.
Ce produit contient ou utilise une pile principale au lithium-ion (Li-ion). Lorsque la batterie atteint la fin de sa durée de
vie utile, la batterie usées doivent être mises aux rebuts par un agent de recyclage ou un manipulateur de matériaux
dangereux agréé. Il ne faut pas mélanger la batterie aux autres déchets solides. Pour plus d’informations sur le recyclage ou
la mise aux rebuts, contacter votre centre de services Intermec Technologies.
Caution: Use Intermec Model 074246 or AE13 (use with power adapter 851-090-001) for the power supply. Do not
connect and charge the CN3NI if the ambient temperature is greater than 40°C (104°F).
Attention: Utilisez le Model 074246 ou AE13 d’Intermec (utilisez avec l’adaptateur d’alimentation 851-090-001) pour
l’alimentation. Ne pas connecter ou charger le CN3NI si la température ambiante est supérieure à 40°C (104°F).
Radio Wave Exposure and Specific Absorption Rate (SAR) Information for Model CN3NI Configurations with GSM/GPRS Radio
For residents of Canada and the United States and other countries/regions that have adopted the SAR limit recommended by Industry
Canada RSS-102 and Federal Communications Commission Office of Engineering and Technology (OET) Bulletin 65, the maximum
allowed SAR value is 1.6W/kg over 1g of tissue. For use at the ear, the highest SAR value for the Model CN3NI, as tested by BABT is 0.528
W/kg. For body worn operation, the highest SAR value for the Model CN3NI, as tested by BABT, is 0.543 W/kg.
Pour les résidants du Canada et des Etats-unis
et des autres pays/régions qui ont adopté le TAS limite recommandé, cette limite est de 1,6
W/ kg pour 1 g de tissu. Pour une utilisation à l’oreille, le TAS limite pour le modèle CN3NI, tel que testé par le BABT, est de 0,528 W/kg.
Pour une utilisation au corps, le TAS limite pour le CN3NI, tel que testé par le BABT est de 0,543 W/kg.
This product has been tested and meets the FCC RF exposure guidelines when used with the Intermec accessories supplied or designated for
this product. Use of other accessories may not ensure compliance with FCC RF exposure guidelines.
Ce produit a été testé et répond aux directives de la FCC en matière d’exposition aux radiofréquences lorsqu’il est utilisé avec les accessoires
Intermec fournis ou conçus pour ce produit. L’utilisation d’autres accessoires pourrait contrevenir aux directives de la FCC en matière
d’exposition aux radiofréquences.
Radio Wave Exposure and Specific Absorption Rate (SAR) Information for Model CN3NI Configurations with CDMA Radio
For residents of Canada and the United States and other countries/regions that have adopted the SAR limit recommended by Industry
Canada RSS-102 and Federal Communications Commission Office of Engineering and Technology (OET) Bulletin 65, the maximum
allowed SAR value is 1.6W/kg over 1g of tissue. For use at the ear, the highest SAR value for the Model CN3NI as tested by BABT is 0.919
W/kg. For body worn operation, the highest SAR value for the Model CN3NI, as tested by BABT, is 0.520 W/kg.
Pour les résidants du Canada et des Etats-unis
et des autres pays/régions qui ont adopté le TAS limite recommandé, cette limite est de 1,6 W/
kg pour 1 g de tissu. Pour une utilisation à l’oreille, le TAS limite pour le modèle CN3NI, tel que testé par le CCS, est de 0,919 W/kg. Pour
une utilisation au corps, le TAS limite pour le CN3NI, tel que testé par le CCS est de 0,520 W/kg.
This product has been tested and meets the FCC RF exposure guidelines when used with the Intermec accessories supplied or designated for
this product. Use of other accessories may not ensure compliance with FCC RF exposure guidelines.
Ce produit a été testé et répond aux directives de la FCC en matière d’exposition aux radiofréquences lorsqu’il est utilisé avec les accessoires
Intermec fournis ou conçus pour ce produit. L’utilisation d’autres accessoires pourrait contrevenir aux directives de la FCC en matière
d’exposition aux radiofréquences
Important Radio Information
This device complies with Part 15 of the FCC rules and with RSS-210 of Industry Canada. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including
interference that can cause undesired operation.
Caution: The Intermec Model CN3NI requires 15 mm of spacing between the torso and the mobile computer to remain
within the Specific Absorption Rate (SAR) limits for general population exposure. The Intermec Model 815-060-001
provides this 15 mm of spacing.
Attention: Le modèle CN3NI d’Intermec exige 15 mm d’espace entre le torse et l’ordinateur mobile pour rester dans les
limites de taux d’absorption spécifique (TAS) pour l’exposition de la population en général. Le modèle 815-060-001 d
Intermec assure ce 15 mm d’espace.
Caution: Changes or modifications not expressly approved by Intermec could void the user’s authority to operate this
equipment.
Attention: Toute modification non expressément approuvée par Intermec risque d’annuler le droit d’utilisation de cet
équipement qui a été accordé à l’utilisateur.
CN3NI Compliance Insert
*933-142-001*
P/N 933-142-001
Worldwide Headquarters
6001 36th Avenue West
Everett, Washington 98203
U.S.A.
tel 425.348.2600
fax 425.355.9551
www.intermec.com
©
2008 Intermec Technologies
Corporation. All rights reserved.
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4

Intermec CN3NI Supplementary Manual

Taper
Supplementary Manual
Ce manuel convient également à

dans d''autres langues