This device complies with RSS-247 of the ISED rules. Operation is subject to the

following two conditions: (1) This device may not cause harmful interference, and (2)

this device must accept any interference received, including interference that may

(iii) the maximum antenna gain permitted for devices in the band 5725-5825 MHz

shall comply with the e.i.r.p. limits specified for point-to-point and non point-to-

point operation as appropriate.

(iv) Users should also be advised that high-power radars are allocated as primary

users (i.e. priority users) of the bands 5250-5350 MHz and 5650-5850 MHz and

that these radars could cause interference and/or damage to LE-LAN devices.

This equipment complies with ISED radiation exposure limits set forth for an

uncontrolled environment. This equipment should be installed and operated with a

minimum distance of 20 cm between the antenna and all persons.

may not cause harmful interference, and (2) this device must accept any interference received, including interference

that may cause undesired operation.

This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of

the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential

installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used

in accordance with the instructions, may cause harmful interference to radio communications. However, there is no

guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to

radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to

try to correct the interference by one of the following measures:

• Reorient or relocate the receiving antenna. • Increase the separation between the equipment and receiver.

FCC rules in the US.

Hereby, SMART Technologies ULC declares that the radio equipment type OPS, AM40 is in compliance with Directive 2014/53/EU. The full text of the EU declaration of conformity is available at the

© 2017 SMART Technologies ULC. All rights reserved. SMART Board, smarttech, the SMART logo and all SMART taglines are trademarks or

registered trademarks of SMART Technologies ULC in the U.S. and/or other countries. All third-party products and company names may be

trademarks of their respective owners. Contents are subject to change without notice. This product and/or use thereof covered by one or

more of the following U.S. patents: smarttech.com/patents. Other patents pending. 08/2017.

SMART Technologies supports global eorts to ensure that electronic equipment is manufactured, sold and disposed of in a safe and environmentally friendly manner.