1. Shut o the power at the circuit breaker and remove existing xture, including the crossbar.

2. Carefully unpack your new xture and lay out all the parts on a clear area. Be careful not to lose any small parts necessary for installation.

3. The lamp can switch between three color temperatures (3000K-3500K-4000K),which can be adjusted to your preference with

the switch in the canopy (Fig. 3).

4. Connect the driver’s input wires to junction box wires as shown (Fig. 2). Make sure that all wire connectors (A) are secure. If your outlet

box has a green or bare copper ground wire, connect the driver’s ground wire to it. Otherwise, connect the xture’s ground wire directly

to the back plate using the green screw provided. After wires are connected, tuck them carefully inside the junction box.

5. Secure the mounting back plate on canopy to the junction box using standard junction box screws that comes with the junction box.

9. To prevent moisture from entering the outlet box and causing a short, use clear caulking (i.e. indoor/outdoor silicone sealant) to outline

the outside of xture conopy where it meets the wall. (Fig.5)