Pax Technology L1400 Manuel utilisateur

Taper
Manuel utilisateur
1. Contents Checklist
Please check the components after unpacking. If any one of them is missing, or if there is a page
missing from the product manual,ect., please contact the dealer.
Name
Qty.
L1400
1
AC Power Adapter
1
AC Power cable
1
Product Manual
1
2. Product Description
3.Installtion
Type-C port: Connect Power or Hub
Type-C port: Connect USB device.
Pogopin Port: Connect ElysTablet device.
4. Instruction
Power ON/OFF
Power on: Press and hold the Power button (on the top) for three seconds until
the main screen displays normally.
Power off: Press and hold the Power button (on the top) for three seconds until
the shutdown menu appears, tap “Shutdown”, and then shutting...”appears. The
terminal will be turned off after a few seconds.
5. Specification
Operation System: Android 11
CPU: Qcta-core,2.0GHzprocessor
Memory: 4GB RAM + 64GB Flash Memory
Display: 14 inch,resolution:1920*1080, multi-touch capacitive touch screen
Audio: Built-in dual speaker/Built-in dual MIC
Fingerprint: Side fingerprint
Camera: 5 mega-pixel auto-focusing camera
Wireless Communication: Support Wi-Fi2.4/5G,Blutooth 5.0
Peripheral Ports: 2 Type-C port
1 Pogopin ports
7. Cautions of Installation and Usage
1Avoid exposing the terminal in hot, humid, dusty or strong electromagnetic environment.
2Do not violently vibrate, shake or beat the product.
3Do not plug/unplug any units of the product when it is power on, otherwise it may
damage the internal circuit.
4Do not maintain the terminal if you are non-professional
Trademark notice:
The Bluetooth® word mark and logos are registered trademarks owned by Bluetooth SIG,
Inc. and any use of such marks by PAX Technology Limited is under license. Other
trademarks and trade names are those of their respective owners.
FCC compliance statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this
device may not cause harmful interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation.
changes or modifications not expressly approved by the party responsible for compliance could void the user’s
authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help.
FCC SAR statement
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. End user
must follow the specific operating instructions for satisfying RF exposure compliance. This transmitter must not be
co-located or operating in conjunction with any other antenna or transmitter.
This equipment complies with IC radiation exposure limits set forth for an uncontrolled environment. This
equipment should be installed and operated with minimum distance 20cm between the radiator & your body.
ISED compliance statement
This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and
Economic Development Canada’s licence-exempt RSS(s). Operation is subject to the following two conditions:
(1) This device may not cause interference.
(2) This device must accept any interference, including interference that may cause undesired operation of the
device.
L’émetteur/récepteur exempt de licence contenu dans le présent appareil est conforme aux CNR d’Innovation,
Sciences et Développement économique Canada applicables aux appareils radio exempts de licence.
L’exploitation est autorisée aux deux conditions suivantes :
(1) L’appareil ne doit pas produire de brouillage;
(2) Lappareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible den
compromettre le fonctionnement.
The user manual for LE-LAN devices shall contain instructions related to the restrictions mentioned in the above
sections, namely that:
i. the device for operation in the band 51505250 MHz is only for indoor use to reduce the potential for
harmful interference to co-channel mobile satellite systems;
ii. where applicable, antenna type(s), antenna models(s), and worst-case tilt angle(s) necessary to remain
compliant with the e.i.r.p. elevation mask requirement set forth in section 6.2.2.3 shall be clearly
indicated.
i. le dispositif utilisé dans la bande 5150-5250 MHz est réservé à une utilisation en intérieur afin de
duire le risque de brouillage préjudiciable aux systèmes mobiles par satellite dans le même canal;
ii. èle (s) d'antenne et l'angle (s) d'inclinaison le plus défavorable nécessaire (s) pour rester conforme (e)
au p.e. L'exigence relative au masque d'élévation énoncée à la section 6.2.2.3 doit être clairement
indiquée.
IC SAR statement
This equipment complies with ISED radiation exposure limits set forth for an uncontrolled environment. End user
must follow the specific operating instructions for satisfying RF exposure compliance. This transmitter must not
be co-located or operating in conjunction with any other antenna or transmitter.
Radiation Exposure Statement:
This equipment complies with IC radiation exposure limits set forth for an uncontrolled environment. This
equipment should be installed and operated with minimum distance 20cm between the radiator & your body.
Cet équipement est conforme aux limites d'exposition aux rayonnements IC établies pour un environnement non
contrôlé. Cet équipement doit être installé et utilisé avec un minimum de 20 cm de distance entre la source de
rayonnement et votre corps.
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5

Pax Technology L1400 Manuel utilisateur

Taper
Manuel utilisateur

dans d''autres langues