Day-Brite CFI FBZ LED High Bay Install Instructions

Marque: Day-Brite CFI

Modèle: FBZ LED High Bay

Taper: Install Instructions

Ce manuel convient également à

FBZ LED High Bay Wireguard

Dual LED mount

product shown.

Quad LED mount

product similar.

Wireguards are not

intended for use with

rigid mounting of the product.

They should only be used with

pendant or chain mounting.

#8 SCREWS

AND

NYLON MOUNTS

(PROVIDED)

SLOT BETWEEN

DRIVER COMPARTMENT

AND LED MOUNT FOR

ATTACHING TETHER

Two LED wireguards are provided. The LED wireguards wrap around the outer edges of the endcaps and the

outside edges of the LED mounts (refer to center view above).

Each wireguard is held in place using four nylon mounts and four screws on each end of the wireguard. The

nylon mounts fit around the wire of the guard and are screwed into the long thin endcaps using #8 screws

(provided) in the locations shown in the upper right view.

IMPORTANT:

A steel wire tether is supplied for each wireguard. Attach the steel wire to the wireguard by

wrapping it around one of the inboard corners of the wireguard and passing one of the looped ends thru the

other looped end of the steel wire. Assemble the snap to the free end loop of the steel wire. Attach this snap

to the slot found on the inside edge of the long thin endcap between the driver compartment and the LED

mount.

CAUTION: THE INSTALLATION AND SERVICING OF THIS PRODUCT SHOULD

BE PERFORMED BY A QUALIFIED ELECTRICIAN OR SERVICE PERSONNEL

FBZ HIGHBAY - WIRE GUARDS

FBZ HIGHBAYS

443581598980 5/7/2021

ATTENTION : L’INSTALLATION ET L’ENTRETIEN DE CE PRODUIT DOIVENT ETRE

EFFECTUÉS PAR UN ÉLECTRICIEN OU UN MEMBRE DU PERSONNEL QUALIFIÉ.

CAUTION: Electrical luminaires are designed for permanent installation in ordinary (non-hazardous) locations in accordance with the National Electrical

Code and all applicable local codes. Do not use in areas of limited ventilation or in high ambient enclosures. The lamp and luminaire operate at high

temperatures. Contact with combustible materials can cause fire and personal contact can cause severe burns.

ATTENTION: Ce luminaire a été conçu pour une installation permanente dans un emplacement régulier (non dangereux) et en conformité avec le Code

électrique canadien et codes locaux applicables. Ne jamais installer dans un endroit où la ventilation est limitée ou dans des boîtiers où la température

ambiante est très élevée. La lampe et le luminaire fonctionnent à des températures élevées, un contact avec des matériaux combustibles peut engendrer un

incendie et un contact corporel peut causer de sévères brûlures

representation or warranty as to the accuracy or completeness of the information

included herein is given and any liability for any action in reliance thereon is disclaimed.

All trademarks are owned by signify holding or their respective owners.

Signify Canada Ltd.

281 Hillmount Road

Markham, ON, Canada L6C 2S3

Telephone: 800-668-9008

Signify North America Corporation

400 Crossing Blvd, Suite 600

Bridgewater, NJ 08807, USA

Telephone: 855-486-2216

Dual LED mount

product shown.

Quad LED mount

product similar.

IF USING V-HOOKS

AND CHAINS, INSTALL

THIS ONE BEFORE

INSTALLING THE

SENSOR WIREGUARD.

Place small sensor guard box around the sensor

mounted to the middle of the products endcap.

The sensor guard is held to the product using four #8

screws (provided).

CAUTION: THE INSTALLATION AND SERVICING OF THIS PRODUCT SHOULD

BE PERFORMED BY A QUALIFIED ELECTRICIAN OR SERVICE PERSONNEL

FBZ HIGHBAY - WIRE GUARDS

Applicable Models