To make sure the house is straight, use a
pencil and a level to draw a vertical
guide on the surface on which you wish
to put the house.
Unroll and remove the protective film on
the back, starting at the tip for about 60 cm
For the installation of wooden slats. Remove the protective
film from the adhesive on the back of the strips and apply on
the edge of the vinyl house, starting with the top of the house.
Press firmly on the wood slats to ensure proper adhesion.
And there you have it, your house is installed!
Stick the top of the house on the surface,
gently smoothing to achieve a uniform
adhesion without air bubble, while
removing the rest of the protective film.
SELF-ADHESIVE WRITE-ON HOUSE
INSTRUCTIONS
or
5 x wood pieces with adhesive tape
A B C
E
1
3
2
D
4
5
CUSTOMER SERVICE 1.866.992.3943
The surface on which I will apply my write-on house
must be clean, dry and smooth
chalkboard adhesive vinyl
dry erase adhesive vinyl