User manual

Model no：2035135 Rating: 5V 200MA

Main Unite:

• this section include the photo of the product and the overview of the main unit

• A: Power on/Power off

Also refer to MFB (Skull Button) below mentioned

rr

• Make sure the Giro Device is in OFF mode

• Long Press MFB (Skull Button)(refer to A point) for 5 seconds

• While in pairing mode, the LED will alternate flashing Blue/Red

In STANDBY mode , Blue LED will fast flash two times every 3 secs.

To Power On:

• Make sure Giro is in OFF mode

• Long Press MFB (Skull Button) (refer to A point) for 3 seconds

• Please note cannot pair a NEW phone in STANDBY mode

To Power Off:

• While Giro is in “Power ON” or “STANDBY” mode

• Long Press MFB (Skull Button) (refer to A point) for 3 seconds

• If in STANDBY mode for 30 mins, Giro Device will automatically Power off

To Answer Phone Call, Play/Pause Music:

• Short Press MFB (Skull Button) (refer to A point)

• Music will resume after hanging up call

Volume Up:

• Long Press Volume Up Button (+)

Track Backward:

• Long Press Volume Down Button (-)

Tested Line of Sight Range of BT Connection:

• 12 meters

Battery Playback Time:

• 7 to 7.5 hours

Charging:

Your product contains batteries covered by the European Directive 2006/66/EC, which cannot be

disposed with normal household waste.

Please inform yourself about the local rules on separate collection of batteries because correct disposal

helps to prevent negative consequences for the environmental and human health.

Caution:

Risk of explosion battery is replaced by an incorrect type.

Dispose of used batteries according to the instructions

Warning: Changes or modifications to this unit not expressly approved by the party responsible for

compliance could void the user’s authority to operate the equipment.

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device,

connected.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two

conditions :

operation of the device.

Under Industry Canada regulations, this radio transmitter may only operate using an antenna of a type

radio interference to other users, the antenna type and its gain should be so chosen that the equivalent

isotropically radiated power (e.i.r.p.) is not more than that necessary for successful communication.

Conformement a la reglementation d'Industrie Canada, le present emetteur radio peut fonctionner avec

une antenne d'un type et d'un gain maximal (ou inferieur) approuve pour l'emetteur par Industrie

Canada. Dans le but de reduire les

risques de brouillage radioelectrique a l'intention des autres utilisateurs, il faut choisir le type d'antenne

et son gain de sorte que la puissance isotrope rayon ee equivalente (p.i.r.e.) ne depasse pas l'intensite

necessaire a l'etablissement d'une communication satisfaisante.

Le present appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts

de licence. L'exploitation est autoris e e aux deux conditions suivantes : (1) l'appareil ne doit pas

produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage radioelectrique subi,

meme si le brouillage est susceptible d'en compromettre le fonctionnement.