KitchenAid KHGH 9010/I Mode d'emploi

Marque: KitchenAid

Modèle: KHGH 9010/I

Catégorie: Plaques de cuisson

Taper: Mode d'emploi

La page est en cours de chargement...

een door AGB goedgekeurde afsluiter.

REFERENCE TO LOCAL REGULATIONS

The appliance is supplied with a 1/2” threaded

conical end to be connected to the gas supply

(according to ISO regulations ISO 7/1 RP 1/2).

The connection must be effected in

accordance with standard NBN D 51-003

using rigid piping or in accordance with

specifications sheet A.R.G.B./03 using flexible

tubing.

The appliance must be installed complete

with an AGB-approved stop valve.

REFERENCE TO LOCAL REGULATIONS

Provision for ventilation

The room in which the appliance is installed

must have an air supply to current B.S. 5440

- Part 2

All rooms require a permanent vent in

addition to the openable window.

If there are other fuel burning appliances in

the same room B.S. 5440 - Part 2 should be

consulted to determine the air vent

requirements.

If the appliance is installed in a cellar or

basement, it is advisable to provide an air vent

of 65 cm, irrespective of the room volume.

Gas Safety Regulations

The law requires that all gas appliances are

installed by competent persons in accordance

with the current gas safety regulations. Failure

to install appliances correctly may lead to

prosecution.

It is in your own interest, and that of safety, to

ensure that the law is complied with. The hob

should be installed in accordance with the

Gas Safety (Installation and Use)

Regulations, the Building Regulations

issued by the Department of the Environment

and the Building Standard (Scotland)

(Consolidation) Regulations, issued by the

Scottish Development Department.

In the G.B., CORGI registered installers work

to safe standards of practice.

RAPPELS SUR LES NORMES DE

SÉCURITE EN VIGUEUR DANS LE PAYS

D’INSTALLATION

L’installation et la maintenance de l’appareil

doivent être effectuées par un technicien

qualifié qui travaille en conformité avec les

réglementations en vigueur, et tout

particulièrement :

- Décret du 2 août 1977

Règles techniques et de sécurité applicables

aux installations fonctionnant au gaz et au gaz

d’hydrocarbures liquéfiés situées à l’intérieur

d’immeubles résidentiels et des dépendances.

- Standard DTU P 45 - 204

Installations au gaz (anciennement DTU no.

61-1 - Installations au gaz avril 1982 +

supplément no. 1 de juillet 1984).

- Réglementations du ministère de la

santé.

Pour les appareils raccordés à l’alimentation

électrique principale.

- Standard NF C 15-100

Installations électriques basse tension -

Standards.

REFERENCE TO LOCAL REGULATIONS

The installation and maintenance of the

appliance must be carried out by a qualified

skilled technician in accordance with the

regulations in force, and in particular:

- Decree of 2 August 1977

Technical and Safety Rules applicable to fuel

gas and liquefied hydrocarbon installations

located within residential buildings and

outbuildings.

- Standard DTU P 45 - 204

Gas installations (formerly DTU no. 61-1 -

Gas installations April 1982 + supplement no.

1 of July 1984).

- Departmental Health Regulations

For appliances connected to the mains

electricity supply.

- Standard NF C 15-100

Low-voltage electrical installations -

Standards.

501910600861:Layout 1 6-05-2008 13:48 Pagina 4

La page est en cours de chargement...

KitchenAid KHGH 9010/I Mode d'emploi

Marque: KitchenAid

Modèle: KHGH 9010/I

Catégorie: Plaques de cuisson

Taper: Mode d'emploi

Télécharger le PDF

rapport

dans d''autres langues

italiano: KitchenAid KHGH 9010/I Guida utente
English: KitchenAid KHGH 9010/I User guide

Documents connexes

KitchenAid EUR Mode d'emploi

KitchenAid KHGH 9010/I Mode d'emploi

KitchenAid KHGH 9010/I Mode d'emploi

dans d''autres langues

Documents connexes

Autres documents