KitchenAid KHMS 9010/I Mode d'emploi

KHMS 9010/I
KitchenAid
Marque
KitchenAid
Modèle
KHMS 9010/I
Catégorie
Plaques de cuisson
Taper
Mode d'emploi
La page charge ...
La page charge ...
La page charge ...
een door AGB goedgekeurde afsluiter.
REFERENCE TO LOCAL REGULATIONS
The appliance is supplied with a 1/2” threaded
conical end to be connected to the gas supply
(according to ISO regulations ISO 7/1 RP 1/2).
The connection must be effected in
accordance with standard NBN D 51-003
using rigid piping or in accordance with
specifications sheet A.R.G.B./03 using flexible
tubing.
The appliance must be installed complete
with an AGB-approved stop valve.
REFERENCE TO LOCAL REGULATIONS
Provision for ventilation
The room in which the appliance is installed
must have an air supply to current B.S. 5440
- Part 2
All rooms require a permanent vent in
addition to the openable window.
If there are other fuel burning appliances in
the same room B.S. 5440 - Part 2 should be
consulted to determine the air vent
requirements.
If the appliance is installed in a cellar or
basement, it is advisable to provide an air vent
of 65 cm, irrespective of the room volume.
Gas Safety Regulations
The law requires that all gas appliances are
installed by competent persons in accordance
with the current gas safety regulations. Failure
to install appliances correctly may lead to
prosecution.
It is in your own interest, and that of safety, to
ensure that the law is complied with. The hob
should be installed in accordance with the
Gas Safety (Installation and Use)
Regulations, the Building Regulations
issued by the Department of the Environment
and the Building Standard (Scotland)
(Consolidation) Regulations, issued by the
Scottish Development Department.
In the G.B., CORGI registered installers work
to safe standards of practice.
RAPPELS SUR LES NORMES DE
SÉCURITE EN VIGUEUR DANS LE PAYS
D’INSTALLATION
L’installation et la maintenance de l’appareil
doivent être effectuées par un technicien
qualifié qui travaille en conformité avec les
réglementations en vigueur, et tout
particulièrement :
- Décret du 2 août 1977
Règles techniques et de sécurité applicables
aux installations fonctionnant au gaz et au gaz
d’hydrocarbures liquéfiés situées à l’intérieur
d’immeubles résidentiels et des dépendances.
- Standard DTU P 45 - 204
Installations au gaz (anciennement DTU no.
61-1 - Installations au gaz avril 1982 +
supplément no. 1 de juillet 1984).
- Réglementations du ministère de la
santé.
Pour les appareils raccordés à l’alimentation
électrique principale.
- Standard NF C 15-100
Installations électriques basse tension -
Standards.
REFERENCE TO LOCAL REGULATIONS
The installation and maintenance of the
appliance must be carried out by a qualified
skilled technician in accordance with the
regulations in force, and in particular:
- Decree of 2 August 1977
Technical and Safety Rules applicable to fuel
gas and liquefied hydrocarbon installations
located within residential buildings and
outbuildings.
- Standard DTU P 45 - 204
Gas installations (formerly DTU no. 61-1 -
Gas installations April 1982 + supplement no.
1 of July 1984).
- Departmental Health Regulations
For appliances connected to the mains
electricity supply.
- Standard NF C 15-100
Low-voltage electrical installations -
Standards.
FR
UK
501910600861:Layout 1 6-05-2008 13:48 Pagina 4
La page charge ...
La page charge ...
La page charge ...
La page charge ...
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6
  • Page 7 7
  • Page 8 8

KitchenAid KHMS 9010/I Mode d'emploi

KHMS 9010/I
KitchenAid
Marque
KitchenAid
Modèle
KHMS 9010/I
Catégorie
Plaques de cuisson
Taper
Mode d'emploi
Télécharger le PDF
rapport

dans d''autres langues

Documents connexes

Autres documents