Chief OFB215S Guide d'installation

Catégorie
Mur
Taper
Guide d'installation
INSTALLATION INSTRUCTIONS
Instrucciones de instalación
Installationsanleitung
Instruções de Instalação
Istruzioni di installazione
Installatie-instructies
Instructions d´installation
Office Furniture Bracket
Spanish Product Description
German Product Description
Portuguese Product Description
Italian Product Description
Dutch Product Description
French Product Description
OFB215
OFB215 Installation Instructions
2
DISCLAIMER
Milestone AV Technologies and its affiliated corporations and
subsidiaries (collectively “Milestone”), intend to make this
manual accurate and complete. However, Milestone makes no
claim that the information contained herein covers all details,
conditions or variations, nor does it provide for every possible
contingency in connection with the installation or use of this
product. The information contained in this document is subject
to change without notice or obligation of any kind. Milestone
makes no representation of warranty, expressed or implied,
regarding the information contained herein. Milestone assumes
no responsibility for accuracy, completeness or sufficiency of
the information contained in this document.
Chief® is a registered trademark of Milestone AV Technologies.
All rights reserved.
IMPORTANT SAFETY INSTRUCTIONS!
WARNING: A WARNING alerts you to the possibility of
serious injury or death if you do not follow the instructions.
CAUTION: A CAUTION alerts you to the possibility of
damage or destruction of equipment if you do not follow the
corresponding instructions.
WARNING: Failure to read, thoroughly understand, and
follow all instructions can result in serious personal injury,
damage to equipment, or voiding of factory warranty! It is the
installer’s responsibility to make sure all components are
properly assembled and installed using the instructions
provided.
WARNING: Failure to provide adequate structural strength
for this component can result in serious personal injury or
damage to equipment! It is the installers responsibility to
make sure the structure to which this component is attached
can support five times the combined weight of all equipment
Reinforce the structure as required before installing the
component.
WARNING: Exceeding the weight capacity can result in
serious personal injury or damage to equipment! It is the
installer’s responsibility to make sure the combined weight of
all components attached to the OFB215 up to (and including)
the display does not exceed 25 lbs (11.34 kg) per arm. Do not
exceed the weight limitations of the mount being installed to
the bracket or of the office furniture being used to mount the
accessory. Use with products heavier than the maximum
weight indicated may result in collapse of the mount and its
accessories causing possible injury.
WARNING: Use this mounting system only for its intended
use as described in these instructions. Do not use
attachments not recommended by the manufacturer.
WARNING: Never operate this mounting system if it is
damaged. Return the mounting system to a service center for
examination and repair.
WARNING: Do not use this product outdoors.
--SAVE THESE INSTRUCTIONS!--
Installation Instructions OFB215
3
LEGEND
Tighten Fastener
Apretar elemento de fijación
Befestigungsteil festziehen
Apertar fixador
Serrare il fissaggio
Bevestiging vastdraaien
Serrez les fixations
Loosen Fastener
Aflojar elemento de fijación
Befestigungsteil lösen
Desapertar fixador
Allentare il fissaggio
Bevestiging losdraaien
Desserrez les fixations
Phillips Screwdriver
Destornillador Phillips
Kreuzschlitzschraubendreher
Chave de fendas Phillips
Cacciavite a stella
Kruiskopschroevendraaier
Tournevis à pointe cruciforme
Open-Ended Wrench
Llave de boca
Gabelschlüssel
Chave de bocas
Chiave a punte aperte
Steeksleutel
Clé à fourche
By Hand
A mano
Von Hand
Com a mão
A mano
Met de hand
À la main
Hex-Head Wrench
Llave de cabeza hexagonal
Sechskantschlüssel
Chave de cabeça sextavada
Chiave esagonale
Zeskantsleutel
Clé à tête hexagonale
Pencil Mark
Marcar con lápiz
Stiftmarkierung
Marcar com lápis
Segno a matita
Potloodmerkteken
Marquage au crayon
Drill Hole
Perforar
Bohrloch
Fazer furo
Praticare un foro
Gat boren
Percez un trou
Adjust
Ajustar
Einstellen
Ajustar
Regolare
Afstellen
Ajuster
Remove
Quitar
Entfernen
Remover
Rimuovere
Verwijderen
Retirez
Optional
Opcional
Optional
Opcional
Opzionale
Optie
En option
Security Wrench
Llave de seguridad
Sicherheitsschlüssel
Chave de segurança
Chiave di sicurezza
Veiligheidssleutel
Clé de sécurité
OFB215 Installation Instructions
4
TOOLS REQUIRED FOR INSTALLATION
PARTS
1/8” (included)
A (1)
[cover plate]
G (1)
B (1)
[support plate]
C (1)
[channel plate] D (4)
#10-24 x 1 1/4”
E (2)
#10-32 x 7/8
1/8”
F (2)
[shim]
Installation Instructions OFB215
5
Assembly And Installation
Connecting to K1C/K2C Series Mount
IMPORTANT ! : The OFB215 is designed to mount K1C
or K2C Series mounts to Steelcase FrameOne™ office
furniture rails. Do NOT attempt to attach any other
mounts to this bracket!
1. Remove desk clamp from K1C/K2C mount by removing four
flat head cap screws holding clamp to column. Discard four
screws. (See Figure 1)
Figure 1
2. Use four #10-24 x 1 1/4” flat head cap screws (D) to secure
support plate (B) and cover plate (A) to K1C/K2C column.
(See Figure 2)
NOTE: If space will be limited behind mount, attach K1C200/
K2C200 mounts so that height adjustment knob is in
the front. (See Figure 2)
Figure 2
Assembly to Office Furniture Rail
IMPORTANT ! : The OFB215 is designed to be installed
to Steelcase FrameOne™ office furniture rails. Do NOT
attempt to install this bracket to any other type of office
furniture rails!
NOTE: If mounting holes on displays are recessed, it may be
necessary to install displays prior to installing
assembly. Proceed to Display Installation Section in
K1C/K2C installation instructions prior to installing
assembly to rail.
1. Drop channel plate (C) at an angle into front groove of
FrameOne™ rail. (See Figure 3)
2. Make sure channel plate (C) lays flat in rail and slide plate
until it is at desired mounting position. (See Figure 3)
Figure 3
K2C200 mount
1
x 4
knob in
front
(D) x 4
(A)
(B)
2
(side view)
FrameOne™ rail
(C)
(C) at final position
1
2
OFB215 Installation Instructions
6
3. Hook back of cover plate (A) into back groove of
FrameOne™ rail. (See Figure 4)
4. Place dual pole mount assembly onto FrameOne™ rail
making sure holes on attachment plate line up with holes on
channel plate (C). (See Figure 4)
5. Use two #10-32 x 7/8” flat head cap screws (E) to secure
cover plate (A) to channel plate (C). (See Figure 4)
Figure 4
NOTE: If mount leans forward after installation, install one or
two shims (F) in between cover plate (A) and rail as
shown in the following steps.
Installing Shim Spacers (if required)
IMPORTANT ! : Do NOT install one or both shims (F)
unless required as damage to the FrameOne rail may
result!
6. Remove two #10-32 x 7/8” flat head cap screws (E) holding
cover plate (A) to channel plate (C).
7. Slide one or two shims (F) in between cover plate (A) and
rail, lining up holes on shim(s) with holes on plate and rail.
(See Figure 5)
8. Use two #10-32 x 7/8” flat head cap screws (E) to reinstall
cover plate (A) to channel plate (C). (See Figure 5)
Figure 5
Install displays following K1C/K2C installation instructions.
Lateral Shift Adjustment
1. Loosen two #10-32 x 7/8” flat head cap screws (E). (See
Figure 6)
2. Adjust lateral shift position as desired. (See Figure 6)
3. Tighten two #10-32 x 7/8” flat head cap screws (E). (See
Figure 6)
Figure 6
5
3
4
(E) x 2
(A)
(C)
(F) x 1 or 2 (if required)
7
8
(E) x 2
1 3
2
Installation Instructions OFB215
7
USA/International A 6436 City West Parkway, Eden Prairie, MN 55344
P800.582.6480 / 952.225.6000
F877.894.6918 / 952.894.6918
Europe A Franklinstraat 14, 6003 DK Weert, Netherlands
P+31 (0) 495 580 852
F+31 (0) 495 580 845
Asia Pacific A Office No. 1 on 12/F, Shatin Galleria
18-24 Shan Mei Street
Fotan, Shatin, Hong Kong
P852 2145 4099
F852 2145 4477
OFB215 Installation Instructions
Chief Manufacturing, a products division
of Milestone AV Technologies
8800-002395 Rev00
2013 Milestone AV Technologies, a
Duchossois Group Company
www.chiefmfg.com
05/13
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6
  • Page 7 7
  • Page 8 8

Chief OFB215S Guide d'installation

Catégorie
Mur
Taper
Guide d'installation

dans d''autres langues