EN
6-Daily use
17
6.12 After washing
1. At programme cycle end !" is displayed.
2. H&"$344513)2"$#01%2&"#$(+$3/%(@3%12355:8$
3. Remove laundry as soon as possible to go easy on it and to prevent more wrinkling.
4. H/!)$(+$%&"$03%"!$#/445:8$
5. I)45/7$%&"$4(0"!$2(!<8$
6. Open the door to prevent formation of moisture and odours. Let it open while not used.
!45#6('&7-',#*1#8,-('&7-',#'),#9:;;,1
The acoustic signal can be deselected if necessary:
1. Switch on the appliance.
2. Select the SPIN programme.
3. Press the “Steam “button and “Extra rinse” button at the same time for about 3
seconds. “
# $%&''
” will be displayed and the buzzer will be deactivated.
For activating the buzzer press these two buttons at the same time again. “
# $%&!
will be displayed.
6.11 Interrupt - cancel wash programme
To interrupt a running programme press gently “Start/Pause“. The LED above the button
1#$63#&1)78$ !"##$1%$3731)$%($!"#/@"$(4"!3%1()8
To cancel a running programme and all its individual settings
1. Press “Start/Pause” button to interrupt the running programme.
2. !"##$,J)*J+,$./%%()$>(!$3.(/%$K$#"2()<#$%($#01%2&$%&"$344513)2"$(+8
3. L/)$4!(7!3@@"$M DF$3)<$#"5"2%$,)($M4""<N$O355$517&%#$3!"$(+$P$%($<!31)$%&"$03%"!8$
4. Select a new programme and start it.
Note: Door lock
▶ For safety reasons the door is locked partially during the washing cycle. It is only pos-
sible to open the door at the end of the programme or after the programme was can-
celled correctly (see description above).
▶ In case of high water level, high water temperature and during spinning it is not pos-
sible to open the door;%()*+,%is displayed
<*',=#$'-+89>#3*8,#?#,+,12>@A-7&+2#3*8,
The switched on appliance will go into standby-mode if it will not be activated within 2
minutes before starting the program or at the end of program. The display switsches
(+8$H&1#$#3Q"#$")"!7:8$H($1)%"!!/4%$%&"$#%3)<.:$@(<"$4/#&$,M%3!%* 3/#",$./%%()8$$
!4B#$'-1'#%-A)#.1*21-33,
Press “Start/Pause“ button (Fig. 6-8) to start. The
RES$(>$%&"$,M%3!%* 3/#",$./%%()$#%(4#$63#&1)7$3)<$
lights up continuously
Appliance operates according to present settings.
Changes are only possible by cancelling the pro-
gramme.
”