Danfoss AK-CM 102 Guide d'installation

Taper
Guide d'installation
Warning
Ensure power is disconnected before
adding or removing modules.
Controller conguration must be carried
out when adding or removing modules.
In Out
Instructions
AK-CM 102
Communication module
RI8PQ152 08-2012
080Z0064
24 V a.c./d.c. 2 VA
-20°< t
amb
< 55°C
-0°F < t
amb
< 130°F
0 - 95% RH, non condensing
IP10 / VBG4
UL: E166834
AK-CM 102
AK-XM _ _ _
Princip
Prinzip
Principe
Montering
Mounting
Montage
2 Instructions RI8PQ152 © Danfoss 08/2012 AK-CM 102
Cable:
ANSI/TIA 568 B/C CAT5 UTP cable w/ RJ45 connectors
Eektbehov
Power Requirements
Leistungsbedarf
Puissance requise
Datakommunikation
Data communication
Datenübertragung
Transmission de données
The Product contains electrical components
And may not be disposed together with domestic waste.
Equipment must be separate collected with Electrical and Elec-
tronic waste. According to Local and currently valid legislation.
Strømforsyning = 24 V a.c. eller 18-36 V d.c.
Sørg for, at den yder tilstrækkelig eekt til alle modulopstillingerne.
Klasse II er påkrævet.
Klemmerne må ikke jordes.
Power supply = 24 V a.c. or 18-36 V d.c.
Insure that it provides sucient power for all the modules in the lineup.
Class II is required.
The terminals must not be earthed.
Stromversorgung = 24 V a.c. oder 18-36 V d.c.
Die Stromversorgung muss für sämtliche Module in der Anordnung
ausreichend sein.
Klasse II ist erfordert.
Die Klemmen dürfen nicht geerdet werden.
Alimentation = 24 V c.a. ou 18-36 V c.c.
S'assurer que l'alimentation fournit susamment de puissance pour
tous les modules de l'alignement.
La class II est indiquée.
Il ne faut pas relier les bornes à la terre.
Address
= 001
TERM
= on
Address
= 001
TERM
= o
Address
= 002
TERM
= on
Max. 20 VA
Max. 32 VA
Max. 20 VA
  • Page 1 1
  • Page 2 2

Danfoss AK-CM 102 Guide d'installation

Taper
Guide d'installation