Gamber-Johnson Panasonic Toughpad FZ-G1 Thin Docking Station, Dual RF Guide d'installation
- Taper
- Guide d'installation
Rev. H INST-668
required. Gamber-Johnson specifically disclaims any responsibility for the improper use or installation of its products not consistent with the original vehicle manufactures specifications
Product Mounting Disclaimer
Gamber-Johnson is not liable under any theory of contract or tort law for any loss, damage, personal injury, special, incidental or consequential damages for personal injury or other damage
of any nature arising directly or indirectly as a result of the improper installation or use of its products in vehicle or any other application. In order to safely install and use Gamber-Johnson
products full consideration of vehicle occupants, vehicle systems (i.e., the location of fuel lines, brakes lines, electrical, drive train or other systems), air-bags and other safety equipment is
and recommendations, Gamber-Johnson product instruction sheets, or workmanship standards as endorsed through the Gamber-Johnson Certified Installer Program.
Lite, Dual RF
This docking station is designed to be used with a Standard TOUGHPAD FZ-G1/FZ-G2
only. A TOUGHPAD FZ-G1/FZ-G2 with a handstrap or with optional add-on
instructions on features, set-up, and operation of the computer, please refer to the manual
attachments such as an extended battery or a card reader will not fit into this docking
station.
This docking station is designed to be used with a variety of Gamber-Johnson mounting
systems. Installation instructions for other Gamber-Johnson products are provided with
each individual product.
provided by Panasonic with the computer.
© Copyright 2021 Gamber-Johnson, LLC
This instruction sheet is for the TOUGHPAD FZ-G1/FZ-G2 docking station only. For
This instruction sheet is for the following products:
Item No. 7160-0595-00(-P)(-E) No RF
Item No. 7160-0595-02(-P)(-E) Dual RF
Item No. 7160-0595-20(-P)(-E) Lite, No RF
Item No. 7160-0595-22(-P)(-E)
1/7
7160-0595
Revision
TOUGHPAD FZ-G1/FZ-G2 SLIM DOCKING STATION
INSTALLATION INSTRUCTIONS
Printing Spec: PS-004
Product Form
If you need assistance or have questions, call Gamber-Johnson at 1-800-456-6868
prior to the actual install to verify that mounting locations are safe and practical.
IMPORTANT SAFETY INFORMATION FOR INSTALLERS
When drilling into the vehicle, DO make sure that both sides of the surface are clear of anything that
could be damaged.
CAUTION: If wiring is shorted to the frame, high current conductors can cause hazardous sparks
resulting in electrical fires or flying molten metal.
After installation:
Test the docking station to ensure that it is working properly.
File these instructions in a safe place and refer to them when performing maintenance or re-
Opening the docking station will void the product warranty.
serious injury, or death.
docking station.
There are no adjustments required at any time of the electrical components within the
service of aftermarket vehicle equipment.
, along with proficiency in the installation and
systems
automotive electrical procedures and
To properly install a Gamber-Johnson docking station you must have a good understanding of
important to read and follow all instructions before installing this product.
Safety is dependent on the proper installation and servicing of this docking station. It is
installing.
WARNING: Failure to follow all safety precautions and instructions may result in property damage,
install equipment or route wiring or cords in the deployment path of any air bag.
PRE-INSTALLATION RECOMMENDATOINS
During Installation:
DO NOT connect this docking station to the vehicle battery until:
All other electrical connections are made1. Mounting of all components is complete2. Verification that no shorts exist in the entire system3.
DO NOT
Conduct a "Bench Test"
Gamber-Johnson strongly advises a "bench test" be conducted to verify all electronic and
software issues are resolved prior to installation:
Make sure the computer is operational by itself.1. Insert computer into the docking station and verify that the computer is 2. operating in the dock.
Interconnect entire assembly and verify start-up of all components, including 3. other equipment (printers, modems, scanners, etc.)
Gamber-Johnson recommends positioning of all mounts and equipment in the vehicle
2/7
Ground Pins
Lock
Thumb Knob
Alignment Tabs
Docking Connector Dual RF Connector
TOUGHPAD FZ-G1/FZ-G2 DOCKING STATION FEATURE IDENTIFICATON
3/7
NOTE:
RF connections are configurable in the BIOS of
the computer. The terms "UPPER" and "LOWER"
positon used in the BIOS of the computer
correlates with Gamber Johnson TOUGHPAD FZ-G1/FZ-G2 Docking
Station "Ant 1" and "Ant 2" as follows: "UPPER" = "Ant 1"
and "LOWER" = "Ant 2".
ferrite (GJ# 15064 - Fair-
HDMI (-00 & -02 Models)
- If using HDMI cable, snap
Serial
Video (-00 & -02 Models)
Rite Part# 0431167281)
4x 1/4-20unc
mounting studs
Dual-RF output
location
possible
Ethernet
as close to the dock as
3.0
15.6 Vdc Input (2) USB
bag onto the HDMI cable
supplied in the hardware
for External RF
to outside position
RF Switch - move
Antenna
75MM hole pattern
Cable Tie Locations
RF (2)
PROPER CABLE MANAGEMENT
HDMI
2. OPTIONAL - Use zip ties to secure bundled cables for improved routing.
USB
USB
Ethernet
1. REQUIRED - Use zip ties to secure each cable to the specific strain relief feature on the hub plastic.
4/7
Figure 1
DOCKING AND UNDOCKING THE COMPUTER
used for security purposes.
Figure 2
(See figure 3)
under the top latch until the computer is
resting inside the main housing. The
latch will spring down in front of the
computer to hold it in place.
(see Figues 1 & 2)
3. Turn the computer on for use.
4. (Optional) The key lock can now be
Then rotate the top of the comptuter
TO DOCK THE COMPUTER
1. Turn the computer off.
2. Insert the bottom of the computer into
the docking station.
TO UNDOCK THE COMPUTER
1. Turn the computer off.
2. Unlock if locked.
3. Push upward on the thumb knob and
pull outward on the top of the computer
until it clears the top latch. Lift the
computer out of the dock.
5/7
10R-04 7045
may cause undesired operation.
Stevens Point, WI, 54481, USA, 715-344-3790
Regulatory Certification Information
Regulatory Model #: 7160-0486
Gamber-Johnson LLC, 5001 Joerns Drive,
UL 60950-1:2007/R:2014-10• E-Mark
7160-0595-20-E, 7160-0595-22-E
Descriptions: Dock-Panasonic-FZG1
7160-0595-20, 7160-0595-22, 7160-0595-20-P, 7160-0585-22-P
7160-0595-00-E, 7160-0595-02-E
7106-0595-00, 7160-0595-02, 7160-0595-00-P, 7160-0595-02-P
GJ Model #'s:
•
Certifications:
EN 55022:2010 CISPR 22:2008 Class B• EN 50498:2010• EN 50581:2012• IEC 60950-1(ed.2);am1;am2• EN 60950-1:2006/A2:2013• CAN/CSA C22.2 No. 60950-1:2007/A2:2014-10•
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions. (1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interfernece that
6/7
•
EN: Safety instructions for proper use
Precautions for Operating the Car Mounter
If a Malfunction Occurs, Immediately Unplug the Car Plug and Remove the Computer From this product•
Use Only the Specified Car Adaptor With This Product•
Avoid a Lot of Water, Moisture, Steam, Dust, Oily Vapors, etc•
Portions of your car mounter may differ somewhat from the illustrations in the operating instructions, but this should present •
no problems in actual use
For business users in the European Union. If you wish to discard electrical and electronic equipment, please contact your dealer
or supplier for further information.
Precautions for Installing the Car Mounter
Do Not Install This Product in Unstable State•
Do Not Install This Product Wherever There is a Lot of Water, Moisture, Steam, Dust, Oily Vapors, etc•
DE: Sicherheitshinweise bei einer ordnungsgemäßen Nutzung
Vorsichtsmaßnahmen beim Einsatz der Fahrzeughalterung
Entfernen Sie beim Auftreten einer Fehlfunktion unverzüglich das Fahrzeugnetzteil und trennen Sie die Verbindung zwischen •
Computer und dem Produkt
Verwenden Sie nur das angegebene Fahrzeugnetzteil für das Produkt•
Wasser, Feuchtigkeit, Dampf, Staub, ölige Dämpfe usw. vermeiden•
Einige Bereiche Ihrer Automontagevorrichtung können von den Abbildungen in der Bedienungsanleitung geringfügig •
abweichen, was für die tatsächliche Nutzung jedoch unerheblich ist.
Für Kunden in der Europäischen Union. Bitte treten Sie mit Ihrem Händler oder Lieferanten in Kontakt, wenn Sie elektrische und
elektronische Geräte entsorgen möchten. Er hält weitere Informationen für Sie bereit.
Vorsichtshinweise zum Einbau der Automontagevorrichtung
Installieren Sie das Produkt nicht in instabilem Zustand•
Installieren Sie das Produkt nicht in der Umgebung von Wasser, Feuchtigkeit, Dampf, Staub, öligen Dämpfen usw.•
FR: Consignes de sécurité pour une utilisation correcte
Précautions d’utilisation de auto monter
En cas de dysfonctionnement, débrancher immédiatement la fiche et déconnecter l’ordinateur de ce produit.•
Ne connectez pas au port pour réseau local un câble téléphonique ou un câble réseau autre que ceux spécifiés.•
Eviter le contact de l‘eau, de l’humidité, de la vapeur, de la poussière, des vapeurs graisseuses, etc.•
Certaines parties de votre auto monter peuvent différer quelque peu des illustrations imprimées dans les instructions •
d’utilisation mais cela ne doit présenter aucun problème lors de l’utilisation.
Utilisateurs professionnels de l’Union européenne. Pour en savoir plus sur l’élimination des appareils électriques et
électroniques, contactez votre revendeur ou fournisseur.
Précautions à prendre pour l’installation de l’Auto monter
Ne pas installer ce produit sur un support instable•
Ne pas installer ce produit en présence d’eau, d’humidité, de vapeur, de poussière, de vapeurs graisseuses,etc.
7 / 7
-
1
-
2
-
3
-
4
-
5
-
6
-
7
Gamber-Johnson Panasonic Toughpad FZ-G1 Thin Docking Station, Dual RF Guide d'installation
- Taper
- Guide d'installation
dans d''autres langues
Documents connexes
-
Gamber-Johnson Panasonic Toughbook S1/L1 Tablet Docking Station, Dual RF Guide d'installation
-
-
Gamber-Johnson Panasonic Toughbook 20/G2 Docking Station, Dual RF Guide d'installation
-
Gamber-Johnson Panasonic Toughbook 20/G2 Docking Station, Dual RF Guide d'installation
-
-
