WARNING: All parts must be used as indicated in these instructions. This product is designed for use only with the supplied parts and/or

accessories designated for use by Modern Forms. Substitution of parts or accessories not designated for use with this product by Modern Forms

ATTENTION: Toutes les pièces doivent être utilisées comme indiqué dans ces instructions. Ce produit est conçu pour être utilisé seulement avec

les pièces et/ou accessoires fournis pour être utilisés avec les produits Modern Forms. Remplacer des pièces ou accessoires non conçus pour ce

contacter un revendeur autorisé ou le fabricant si des pièces manquent ou sont endommagées.

Fax (800) 526.2585

Port Washington, NY 11050

Lithia Springs, GA 30122

Ontario, CA 91760

Modern Forms retains the right to modify the design of our products at any time as part of the company's continuous improvement program.

t Read all instructions before installing.

t System is intended for installation by a licensed electrician in accordance with the National Electrical Code (NEC) and local regulations.

t When handling the fixture, do not apply pressure to the LEDs. Hold the fixture by the base only.

t Retain installation instructions for future maintenance reference.

MAINTENANCE NOTE: Coastal conditions may cause mineral and residue build-up on the fixture. We recommend that customers in coastal

areas clean all external surfaces of the fixture once every two weeks with a wet cloth.

MISE EN GARDE: Pour éviter tout choc électrique, assurez-vous que le disjoncteur soit mis hors tension avant de commencer.

un chiffon humide.

Nov . 2019

Rubber Gasket

modernforms.com

Fax (800) 526.2585

44 Harbor Park Drive

Port Washington, NY 11050

1600 Distribution Ct

Lithia Springs, GA 30122

Western Distribution Center

1750 Archibald Avenue

Ontario, CA 91760

Modern Forms retains the right to modify the design of our products at any time as part of the company's continuous improvement program.

Fig. 2 Wiring

MOUNTING THE FIXTURE (Fig. 1)

CONNECTING THE WIRES (Fig. 2)

Note: (i) using any other non-original-manufacturer provided junction box screw may result in safety issue;

(ii) The side of the mounting back plate marked “GND” must face out.

5. Connect the fixture’s wires to junction box wires as shown in Fig. 2, making sure that all wire connectors (A) are secured. If your outlet

box has a green or bare copper ground wire, connect the fixture’s ground wire to it. Otherwise, connect the fixture’s ground wire directly

to the back plate using the green screw provided. After wires are connected, tuck them carefully inside the junction box.

6. Place the fixture over the mounting plate and secure with metal nut(C) and rubber gasket(D).

7. Fit the outer glass into the aluminum frame.

8. Place the frame with outer glass over the fixture and secure with mounting screws(B) and rubber gasket(D).

9. To prevent moisture from entering the outlet box and causing a short, use clear caulking (i.e. indoor/outdoor silicone sealant to)

outside of fixture back plate where it meets the wall. Leave a space at the bottom to allow moisture to escape Fig.3.