ENG
2
Pairing Your BOOM ANC by MIIEGO® Bluetooth Headphones
1: Make sure your BOOMs are charged and turned OFF.
2: Press and hold the M- button on the headphones
for 7 seconds until the indicator light flashes Red and Blue alternatively
(pairing mode).
3: Activate Bluetooth on your phone or other device and search for Bluetooth
devices and select BOOM ANC by MIIEGO.
Charging Your MIIEGO Headphones
When the Red light is on, the headphones are charging.
When the Red light is off, the headphones are fully charged.
Full charging time is around 3-4 hours.
Next time charging
When you hear a warning tone of "battery low" every 180 seconds and the
Red light blinks, the battery status is low and needs charging.
Turning Your MIIEGO Headphones On and Off
ON: Press the M-Button for 3 seconds until the indicator light flashes Blue
3 times.
OFF: Press the M-Button until the indicator light flashes Red 2 times.
How to activate the ANC – Active Noise Cancelling function
ON: Turn the ANC button down (you see a green dot).
OFF: Turn the ANC button up (you see a red dot).
When the ANC is ON the Blue indicator light in the bottom is ON.
Interchangeable Ear
Cushions
This device contains a lithium accumulator.
Improper use can cause overheating and fire.
Only listen to music in a moderate volume and
in moderate periods of time. Excessive exposure
to high sound levels can lead to noise-induced
hearing loss.
For California Residents: WARNING: This product contains
chemicals known to the State of California to cause cancer
and birth defects or other reproductive harm.
FCC Warning
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including
interference that may cause undesired operation.
NOTE 1: This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or
more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.
NOTE 2: Any changes or modifications to this unit not expressly
approved by the party responsible for compliance could void the
user's authority to operate the equipment.