Quick Start Guide

X-PORT

DCC 120

functionality

1

The X-PORT DCC120 module is designed to support dual input 3D (left and right eye in separate cables) and double flash 3D.

For dual input 3D, 2 x HDMI or 2 x DVI or 2 x VGA with left and right eye information on the 2 chosen connectors is then supported.

For double flash 3D, sequential 3D is supported between 48 and 60 Hz (24 to 30 Hz per eye) on a single input connector. The input

signal will then be converted to a standard 3D feed between 96 and 120 Hz.

projector and the X-PORT module.

Fit the X-PORT module to the connector on the projector using the guiding pins, and press into place. Fasten the four retainer screws

(see picture 1), using a screwdriver. Take care not tightening the screws too hard as this may damage the threads.

3

connecting sources

The X-PORT DCC120 module does not have any input connectors.

Sources are connected to the projector as described in the user guide.

4

indicator lamps

The X-PORT DCC120 module has one LED indicator on the right hand side ((picture 1/STATUS). The LED indicator will be illuminated in

francais

español