Bauknecht DNHE 3760 IN Program Chart

Marque: Bauknecht

Modèle: DNHE 3760 IN

Catégorie: Hottes

Taper: Program Chart



DNHE 3760

5019 100 75179

INSTALLATIONSANGABEN

Mindestabstand zur Kochfläche: 43 cm (Elektroplatten), 65 cm (Gas-, Öl-

oder Kohlekochplatten. Folgen Sie bei der Installation der Nummerierung

.....). Das Auslassrohr (14) wird nicht mitgeliefert und muss

gesondert erworben werden. Das Gerät darf erst nach erfolgter Installation

an die Stromversorgung angeschlossen werden. Der Stecker der

Dunstabzugshaube muss mit einer normgerechten und gut zugänglichen

Steckdose verbunden werden. Wenn die Dunstabzugshaube nicht mit einem

Stecker versehen ist (direkter Netzanschluss), muss ein zweipoliger,

normgerechter, gut zugänglicher Schalter eingebaut werden, dessen

Kontakte einen Abstand von mindestens 3 mm aufweisen). Wenn die

Dunstsabzugshaube nicht funktioniert, muss zunächst überprüft werden, ob

der Hauptschalter ON/OFF auf ON geschaltet ist. Der Hauptschalter ON/OFF

wird auf OFF geschaltet, wenn die Dunstabzugshaube für längere

Zeitabstände nicht verwendet wird. Der Hauptschalter ON/OFF darf nicht für

Instandhaltungsarbeiten der Dunstabzugshaube verwendet werden. Bei

Instandhaltungsarbeiten muss die Stromversorgung durch Abziehen des

Steckers oder Ausschalten des evtl. installierten normgerechten

zweipoligen Schalters unterbrochen werden.

INSTALLATION SHEET

Minimum height above cooker: 43 cm (electric cookers), 65 cm (gas, gas oil

or coal cookers). To install follow points (1

.....). The exhaust pipe (14)

is not supplied, and should be bought separately. Do not connect the

appliance to the electrical power supply until installation is completed. The

power plug of the hood must be connected to a socket that complies with

current regulations, located in an easily accessible point. If the hood is not

fitted with a plug (direct connection to the power supply), fit a two-pole

switch in compliance with regulations, with minimum break distance

between contacts of 3 mm (easily accessible). In the event the hood does not

work, check that the ON/OFF switch is ON. In the event the hood is not used

for a long time, the ON/OFF switch should be OFF. The ON/OFF switch

cannot be used for hood maintenance. To carry out maintenance unplug the

appliance or use the double-pole switch (in compliance with current

regulations) if fitted.

FICHE D'INSTALLATION

Distance minimale par rapport à la cuisinière : 43 cm (cuisinière électrique),

65 cm (cuisinière à gaz, mazout ou charbon). Pour le montage, suivez la

numérotation (1

.....). Le tuyau d'évacuation (14) n'est pas fourni avec

l'appareil et doit être acheté à part. Ne branchez pas l'appareil tant que

l'installation n'est pas terminée. La fiche de la hotte doit être branchée dans

une prise conforme aux normes en vigueur, placée dans un endroit

accessible. Si la hotte est branchée sans fiche (branchement direct sur le

réseau), appliquez un interrupteur bipolaire conforme aux normes ayant une

distance minimale de 3 mm entre les contacts (accessible). Si la hotte ne

fonctionne pas, contrôlez d'abord que l'interrupteur général ON/OFF est sur

la position ON. L’interrupteur général ON/OFF doit être placé sur la position

OFF si on n'utilise pas la hotte pendant une longue période. L’interrupteur

général ON/OFF ne peut pas être utilisé pour l'entretien de la hotte. Pour

l'entretien, débranchez la hotte ou agissez sur l'interrupteur bipolaire

conforme aux normes s'il a été installé.

75179.fm5 Page 1 Wednesday, June 14, 2000 5:55 PM



5019 100 75179

DNHE 3760

INSTALLATIESCHEMA

Minimumafstand tot het kooktoestel: 43 cm (elektrische kooktoestellen), 65

cm (kooktoestellen op gas, olie of kolen). Volg voor de montage de

nummering (1

.....). De afvoerleiding (14) wordt niet bijgeleverd en

dient aangeschaft te worden. Geef het apparaat geen stroom totdat de

installatie geheel voltooid is. De stekker van de kap moet op een goed

toegankelijk stopcontact aangesloten worden dat aan de geldende

veiligheidsvoorschriften voldoet. In het geval dat de kap geen stekker heeft

(directe aansluiting op het elektriciteitsnet) dient u een tweepolige

schakelaar te gebruiken met een afstand tussen de contacten van minstens

3 mm (toegankelijk). Als de kap niet werkt, moet u eerst controleren of de

ON/OFF schakelaar in de stand ON staat. De ON/OFF schakelaar moet in de

stand OFF worden gezet wanneer de kap voor een langere periode niet

gebruikt zal worden. De ON/OFF schakelaar kan niet gebruikt worden bij

onderhoudswerkzaamheden aan de kap. Wanneer er

onderhoudswerkzaamheden verricht moeten worden, moet u de stekker uit

het stopcontact trekken of de eventueel geïnstalleerde tweepolige

schakelaar gebruiken.

FICHA DE INSTALACIÓN

Distancia mínima de los quemadores: 43 cm (quemadores eléctricos), 65 cm

(quemadores a gas, gasóleo o carbón). Para el montaje hay que seguir la

numeración (1

.....). El tubo de descarga (14) no se suministra con la

campana y se debe comprar aparte. No se debe enchufar el aparato hasta

que su instalación no esté terminada. La clavija eléctrica de la campana

debe conectarse a un enchufe que sea conforme a las normas vigentes y

esté en un lugar accesible. Si la campana está desprovista de clavija

(conexión directa a la red), se deberá aplicar un interruptor bipolar según las

normas con una distancia de abertura entre los contactos no inferior a 3

mm, que naturalmente deberá ser accesible). Si la campana no funciona

antes que nada hay que revisar su el interruptor general ON/OFF está en

posición ON. El interruptor general ON/OFF se debe poner en OFF si la capa

no se utiliza durante largo tiempo. El interruptor general ON/OFF no se debe

utilizar para el mantenimiento de la campana. Antes de hacer mantenimiento

hay que desenchufar la campana o desconectar el interruptor bipolar, que

por norma se debe instalar aguas arriba de la campana.

FICHA DE INSTALAÇÃO

Distância mínima dos fogões: 43 cm (fogões eléctricos), 65 cm (fogões a

gás, óleo ou carbono). Para a montagem siga a numeração (1

.....). O

tubo de descarga (14) não é fornecido com o aparelho pelo que deve ser

adquirido. Não ligue o aparelho à corrente eléctrica até a instalação estar

concluída. A ficha eléctrica do exaustor deve estar ligada a uma tomada em

conformidade com as normas em vigor, e colocada num sítio acessível. Se

o exaustor não estiver equipado com uma ficha (ligação directa com a rede

eléctrica) aplique um interruptor bipolar segundo as normas com uma

distância dos contactos à abertura não inferior a 3mm (acessível). No caso

em que o exaustor não funcione, controle primeiro se o interruptor geral ON/

OFF está na posição ON. O interruptor geral ON/OFF deve ser colocado na

posição OFF no caso de não utilização do exaustor durante muito tempo. O

interruptor geral ON/OFF não pode ser utilizado para a manutenção do

exaustor. Para as operações de manutenção retire a ficha da tomada

eléctrica agindo no interruptor bipolar eventualmente instalado segundo as

normas em vigor.

75179.fm5 Page 2 Wednesday, June 14, 2000 5:55 PM



DNHE 3760

5019 100 75179

SCHEDA INSTALLAZIONE

Distanza minima dai fuochi: 43 cm (fuochi elettrici), 65 cm (fuochi a gas,

gasolio o carbone). Per il montaggio seguire la numerazione (1

.....).

Il tubo di scarico (14) non è fornito e va acquistato. Non dare corrente

all’apparecchio finché l’installazione non è totalmente completata. La spina

elettrica della cappa deve essere allacciata ad una presa conforme alle

norme vigenti posta in zona accessibile. Se la cappa è sprovvista di spina

(collegamento diretto alla rete) applicare un interruttore bipolare a norme

con una distanza dei contatti in apertura non inferiore a 3 mm (accessibile).

Nel caso la cappa non funzioni controllare prima che l’interruttore generale

ON/OFF sia in posizione ON. L’interruttore generale ON/OFF va posto in

posizione OFF in caso di lunghi periodi di inutilizzo della cappa.

L’interruttore generale ON/OFF non può essere utilizzato per la

manutenzione della cappa. Per le operazioni di manutenzione togliere la

spina dalla presa di corrente ho agendo sull’interruttore bipolare a norme

eventualmente installato.

ù(ù ü+ù$ùþ

ü$12.)12.1.)2"0120"FP02!"0120"FP0120"

.0! #02!0. #0! # +.22  21.  #1202

.!1

.....)

1&."..&"/0/.202.02 

. !! 32!..!0.. 20$&!122! 3 / 20200

02!)!0*.21#10#!2  !&12"0.212.1" 

02!)3"2 #. !! 32!.!0.1#/0010!.102 #

1$* 2 ". 1 *2  0210! 101 10 ü 

. !! 32!."/0/.203".0#0."1*/0102 /2# 

2  02120./ )/.)2102&. 1+00$12 

 .02.*2&0.3+PP10! 101 10 0

0!2&1 #. !! 32!."/002 #!0020!+2.. 

0)"/.)2"212))!102.121210)"/.)2"

212))!0.2  0202.1212))100!2&1 # 

. !! 32!."/0$!1  02..0 $! )/12.

0)"/.)2"212))/0 !0.$!1  0.2

1#2!12 #. !! 32!.+.2"0010"1#2!1"

. 1#/1202 3".)2!.2 #!0*.2 "2 0/0$)0 

/ )/.)2 #$00.2.12.0102&. 1+

75179.fm5 Page 3 Wednesday, June 14, 2000 5:55 PM



5019 100 75179

DNHE 3760

75179.fm5 Page 4 Wednesday, June 14, 2000 5:55 PM



5019 100 75179

DNHE 3760

Control panel.

Grease filters.

Lighting unit.

Pull-out steam deflector.

ON/OFF switch (not double-pole).

CLEANING THE GREASE FILTER - Fig. 1

Wash the grease filter once a month, or whenever

the letter

appears on the control panel display.

Unplug the appliance or disconnect the mains

power supply.

Pull out the steam deflector.

Remove the grease filters.

- Rotate the grease filter handles (

), push

them inwards (

), then remove the filter by

pulling it downwards.

After cleaning the grease filter refit in reverse

order, making sure the entire extraction surface

is covered.

Resetting the grease filter

saturation indicator:

press

the buttons indicated in the

diagram to the side for about three seconds. After

resetting, the letter

will no longer be visible.

REPLACING BULBS - Fig. 1

Unplug the appliance or disconnect the mains

power supply.

Open the lighting unit (

Remove the burnt-out bulb.

Replace with 9W max (PL) bulbs only.

Close the lighting unit.

FITTING OR RENEWING THE CARBON

FILTER - Fig. 2

Unplug the appliance or disconnect the mains

power supply.

Pull out the steam deflector.

Remove the grease filters.

If the carbon filter is already fitted and needs

renewing, press the release buttons (

) and pull

the filter out downwards.

If the filters are not fitted: locate the carbon filter

under the top clips (

), then secure with the

bottom clips (

Refit the grease filters.

THE CONTROL PANEL

Display: speed and grease filter saturation

indicator (when the letter

appears).

Speed decrease button -

Speed increase button -

Timer intensive speed button

- The hood

operates at this speed for 5 minutes and then

returns to the previous settings. This function

can be cancelled by pressing button

(the

timer works for 15 minutes and then switches

off) or

Timer button (15 minutes) for all speeds - During

this function a dot flashes at the bottom right

hand side of the display. After fifteen minutes

the hood switches to stand-by (dot at bottom

right hand side remains alight). This fuction can

be cancelled by pressing button

Hood OFF button - The hood switches to stand-

by (dot at bottom right hand side remains alight).

Light ON-OFF switch.

Fig. 1

Fig. 2

PRODUCT DESCRIPTION SHEET

F NL E PGBD GRI

75179.fm5 Page 6 Wednesday, June 14, 2000 5:55 PM

Bauknecht DNHE 3760 IN Program Chart

Marque: Bauknecht

Modèle: DNHE 3760 IN

Catégorie: Hottes

Taper: Program Chart

Télécharger le PDF

rapport

dans d''autres langues

Documents connexes

Autres documents

Whirlpool AKR 602 WH Program Chart