damp cloth. Blades and rostrum are very sharp: be
careful not to cut himself during cleaning or when
removing the accessories.
- At the end of the process, wait for the blade to
completely stop before removing the food from the
container. Once you finished using the unit, it is
recommended to wrap the power cord so as to ensure a
better cleaning and to avoid any risk of damage.
- Never exceed the maximum quantity indicated on the
container. When processing fruits, it is recommended to
remove the pit and peel.
DESCRIPTION FR23
1. Measuring lid 2. Cover with safety device 3. Handle 4. Glass jug
5. Blades unit 6. Motor body 7. Control knob with 2 speeds + PULSE option
OPERATING
1) Place the motor body (6) on a flat and stable surface.
2) Insert the glass jug (4) in the motor unit (6). To insert, bring the handle (3) on the right of the unit, push
down the joint of the jug (5) in the unit and turn it clockwise until it locks; perform this procedure
correctly, otherwise the safety device does not allow any operation.
3) Place food inside the container (4) without exceeding maximum capacity of 600ml.
4) Install cover (2) over the glass jug (4): press the cover until it fits completely with the glass.
5) Plug appliance and turn control knob (7) to "I" (low speed), "II" (high speed) or "P" (PULSE). When using,
always keep the cover in the case; if some food blocks the blades, unplug the unit before removing it.
Do not operate the blender for more than 1 minute continuously, let it cool down for at least 3 minutes.
Blender is suitable for: milkshakes, smoothies, sorbets, ices, sauces, creams, cocktails etc ... For a best result,
work foods at the lower speed first and then finish with the highest.
SAFETY DEVICE - This unit is equipped with a safety device: the device only works if the glass jug
(4) is correctly assembled into the motor unit (6). If you remove the glass, or if it is not inserted properly, the
motor shuts off. In this case, assemble the motor unit and the glass jug again.
FIRST USE - Removing and installing the glass jug a few times without plugging the unit and without
adding fruits or vegetables. Follow these steps to practice with the appliance. Wash the lid and the blender jar
in warm water using some dish detergent. Accessories with electrical parts (such as the motor block) should
be cleaned with a damp cloth and dry immediately.
CLEANING Unplug the unit from the electrical outlet.
- Do not immerse the motor unit in water, but wash it with a damp cloth and non-abrasive detergent. Also
avoid any infiltration of water inside the motor unit.
- Glass jug, blades and lid can be washed like every day crockery with non-abrasive sponge and dish
detergent. Dry them completely before you assembling the motor unit again.
For a quick cleaning of the blades between different processes, fill the jug halfway with tap water and operate
for a few seconds.