Wattstopper

®

High Bay Occupancy Sensor Mounting Bracket Extender Module

for Wet Locations

Installation Instructions • Instructions d’Installation • Instrucciones de Instalación

No: 24121 – 09/16 rev. 1

Catalog Number • Numéro de Catalogue • Número de Catálogo: HBEM3W

Country of Origin: Made in China • Pays d’origine: Fabriqué en Chine • País de origen: Hecho en China

SPECIFICATIONS

DESCRIPTION AND OPERATION

The HBEM3W Extender Module allows

you to attach an HB3xxW series IP65

compliant occupancy sensor to the side

of a wet location light fixture.

The HBEM3W includes two chase

nipples; one for use with the HB340W

and one for all other models. One end

of the nipple snaps into the extender

housing. The other end fits into a

nipple and rubber washer.

The extender module snaps apart to allow threading the wiring cable

through it and into the fixture for connection.

The extender housing is not watertight, but the inner flange rings on the

nipple and the HB3xxW housing fit into grooved rubber rings on the cable

to keep moisture from entering the fixture and sensor at those locations.

WARNING: TURN THE POWER OFF AT THE

CIRCUIT BREAKER BEFORE WIRING.

INSTALLATION

Assemble the HBEM3W to the HB3xxW series sensor and to the light

fixture as shown in the illustrations.

Note the grooved rubber ring on the sensor cable. Ensure you have

selected the correct nipple for your sensor. Make sure that when the

cable is threaded through the chase nipple, the slot is seated on

either side of the flange ring inside the chase nipple, as shown

in the explolded view. When properly seated, using