Before using for the first time en
11
K Before using for the
first time
Before using for the first time
In this section, you will learn how to
commission your appliance.
Note: Only use the appliance in
frost-free areas. If the appliance was
transported or stored at temperatures
below 0 °C, you must wait for at least 3
hours before using it.
Installing and connecting the
appliance
1. Remove any protective plastic film.
2. Place the appliance on a level,
water-resistant surface which can
bear the weight.
3. Using the mains plug, connect the
appliance to an earthed socket that
has been correctly installed.
Note: After plugging in, always wait
(approx. 5 seconds).
Commissioning the appliance
Filling the bean container
This appliance can be used to make
coffee drinks from coffee beans.
1. Open the lid )* of the bean
container )2.
2. Pour in the beans.
3. Close the lid again.
Notes
■ The coffee beans are freshly ground
for each brewing.
■ The coffee beans just be sealed and
stored in a cool place to retain
optimum quality.
■ Coffee beans can be stored in the
bean container for a number of days
without losing their aroma.
Filling the water tank
Important: Fill the water tank with fresh,
cold, still water on a daily basis. Prior to
operation, check whether the water tank
has been sufficiently filled.
1. Carefully remove the cover of the
water tank.
2. Use the handle to remove the water
tank.
3. Fill the water tank with water up to
the "max" marking.
4. Put the water tank back in the holder
again, keeping it straight, and fit the
cover of the water tank.
Setting the language
1. Switch on the appliance with
the k button.
The preset language appears in the
display.
2. Touch the “V” button cappuccino
repeatedly until the required
language appears on the display.
3. Touch the “ok” button latte
macchiato to confirm the setting.
The appliance rinses and is ready to
use when "Choose beverage" appears
in the display.
Notes
■ Language selection only appears
automatically when the appliance is
switched on for the first time.
■ You can change the language at any
time. ~ "Settings" on page 16