DMP 277 Trouble Annunciator Guide d'installation

Marque
DMP
Modèle
277 Trouble Annunciator
Taper
Guide d'installation

Ce manuel convient également à

INSTALLATION GUIDE
277
Trouble Sounder
277 Installation Guide | Digital Monitoring Products 1
GET STARTED
The Model 277 Trouble Sounder is an audible trouble alert that may be installed in place of the Model 893A Module
Trouble Alert Sounder.
What’s Included
▶277 Trouble Sounder
Processor Fail Alert
The 277 Trouble Sounder monitors the keypad bus to sound an alert whenever the keypad bus is faulted.
The 277 also sounds a trouble alert whenever the panel processor is reset using the RESET header or the processor
stops functioning.
INSTALLATION
1 Install the Sounder
Warning: Ground yourself before handling the panel. To discharge static, touch any grounded metal, such as
the enclosure, before touching the panel. Also remove all AC and Battery power from the panel before
installing or connecting any modules, cards, or wires to the panel.
Taking note of the “UP” arrow to properly orient the 277, slide the connector on the 277 onto the panel 893A or
277 connector.
Figure 2: 277CAN Trouble Sounder to Panel Connections
UP
893A or 277
Figure 1: 277 Trouble Sounder
Front and Rear Views
18205
Designed, engineered, and
manufactured in Springfield, MO
using U.S. and global components.
LT-1304 21344
INTRUSION • FIRE • ACCESS • NETWORKS
2500 North Partnership Boulevard
Springfield, Missouri 65803-8877
800.641.4282 | DMP.com
© 2021
SPECIFICATIONS
Operating Voltage 12 VDC from the panel
Current Draw 5 mA
CERTIFICATIONS
Underwriters Laboratory (UL) Listed
ANSI/UL 636 Holdup Alarm Units and Systems Accessory
ANSI/UL 1023 Household Burglar
ANSI/UL 1635 Digital Burglar
ANSI/UL 985 Household Fire Warning
ANSI/UL 864 Fire Protective Signaling 9th Edition
FCC Information
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may cause undesired operation.
Changes or modifications made by the user and not expressly approved by the party responsible for compliance could void the user’s authority to
operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment o and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit dierent from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Industry Canada Information
This device complies with Industry Canada License-exempt RSS standard(s). Operation is subject to the following two conditions:
1. This device may not cause interference, and
2. This device must accept any interference, including interference that may cause undesired operation of the device.
Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux appareils radio exempts de licence. L’exploitation est autorisée aux deux
conditions suivantes:
1. l’appareil ne doit pas produire de brouillage, et
2. l’utilisateur de l’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d’en compromettre le
fonctionnement.
  • Page 1 1
  • Page 2 2
  • Page 3 3

DMP 277 Trouble Annunciator Guide d'installation

Marque
DMP
Modèle
277 Trouble Annunciator
Taper
Guide d'installation
Ce manuel convient également à
Télécharger le PDF
rapport

dans d''autres langues

Documents connexes

Autres documents