ENGLISH | 6
WARNINGS, CAUTION
& LEGAL INFORMATION
COMPANY NAME: BRAVEN LC | MODEL: BRAVEN VALE | DC INPUT: 12V, 2.5A | COUNTRY OF ORIGIN: VIETNAM
FCC ID: Z7RBVALE | IC: 10013A-BVALE | CAN ICES-3( B )/NM B-3(B)
Any changes or modifications not expressly approved by the grantee of this device could void the user’s authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired operation.
FEDERAL COMMUNICATIONS COMMISION INTERFERENCE STATEMENT:
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on,
the user is encouraged to try to correct the inference by one or more ofthe following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Approved under the verification provision of FCC Part as a Class B Digital Device.
IC INFORMATION (FOR CANADIAN CUSTOMERS) & INFORMATIONS SUR IC (POUR LES CLIENTS CANADIENS)
This product complies with RSS-247 of Industry Canada. Operation is subject tothe following two conditions: (1): this product may not cause
harmful interference, and (2) this product must accept any interference received, including interference that may cause undesired operation.
This Class B digital apparatus complies with Canadian ICES-003. Cat apparell est conforme à la norme CNR-247 du Canada. I:utilisation de
ce dispositif est autorisée seulement au deux conditions suivantes : (1) il ne doit pas produire de brouillage, at (2) l’utilisateur du disposhif
dolt être prêt à accepter tout brouillage radioélectrique reçu, même si ce brouillage est susceptible de comprornettre le fonctionnement du
dispositif. Cet apparell numérique de la classe B est conforme à la norme NMB-003 du Canada.
CAUTION
To reduce potential radio interference to other users,the antenna type and its gain should be as chosen that the equivalent isotropically
radiated power (e.i.r.p.) is not more than that permitted for successful communication.
ATTENTION
Afin de réduire le risque d’interference aux autres utilisateurs, il faut choisir le type d’antenne et son gain de façon à ce que la puissance
isotrope rayonnée équivalente (p.i.r.e.) ne soit pas supérieure au niveau requis pour l’obtention d’une communication satisfaisante.
RF EXPOSURE INFORMATION
This equipment complies with FCC/IC radiation exposure limits set forth for an uncontrolled environment and meets the FCC radio frequency
(RF) Exposure Guidelines in Supplement C to OET65 and RSS-102 of the IC radio frequency (RF) Exposure rules. This equipment has very low
levels of RF energy that are deemed to comply testing of specific absorption ratio (SAR). This equipment should be installed and operated
with minimum distance 20cm between the radiator and your body. Cet équipement est conforme aux normes d’exposition aux radiations FCC/
IC définies pour un environnement non controlé et satisfait les directives d’exposition a la radiofréquence (RF) dans Ie supplément C des
OET65 et RSS-102 des règles d’exposition à la fréquence radio (RF) IC. Cet équipement a de très faibles niveaux d’énergie RF qui sont jugés
conformes sans test de taux d’absorption spècifique (SAR). Cet équipement doit être installé et utilisé avec un minimum de 20 cm de distance
entre la source de rayonnement et votre corps.