5
1
2
3
4
Setting the clock
In standby mode, press and hold CLOCK/DISPLAY on the
remote control set for 2 seconds.
Press PROG to select 12-hour or 24-hour display.
Press CLOCK/DISPLAY to confirm.
➜ The clock digits for the hours flash.
Press TUNING 4 ¢ (à / á on the remote control)
to set the hours.
Press CLOCK/DISPLAY again.
➜ The clock digits for the minutes flash.
Press TUNING 4 ¢ (à / á on the remote control)
to set the minutes.
Press CLOCK/DISPLAY to confirm the time.
6
7
1
2
3
4
5
Playing a disc
Select CD source.
Lift the CD door on the top of the system to open the CD compartment.
Insert a disc with the printed side facing up and press down
on PULL TO OPEN to close the CD door.
PressÉÅto start playback.
Press 9 to stop playback.
MC147_QSG_Eng 2010.3.31, 10:203