14 INSTALLATION
Unpacking the Refrigerator
WARNING
xUse two or more people to move and install the
refrigerator. Failure to do so can result in back
injury or other injury.
x7KHUHIULJHUDWRULVKHDY\3URWHFWWKHÀRRUZKHQ
moving the refrigerator for cleaning or service.
Always pull the refrigerator straight out when
moving it. Do not wiggle or walk the refrigerator
ZKHQWU\LQJWRPRYHLWDVÀRRUGDPDJHFRXOG
occur.
x.HHSÀDPPDEOHPDWHULDOVDQGYDSRUVVXFKDV
gasoline, away from the refrigerator. Failure to
GRVRFDQUHVXOWLQ¿UHH[SORVLRQRUGHDWK
NOTE
xRemove tape and any temporary labels from
your refrigerator before using. Do not remove any
warning labels, the model and serial number label,
or the Tech Sheet that is located under the front of
the refrigerator.
xTo remove any remaining tape or glue, rub the area
briskly with your thumb. Tape or glue residue can
also be easily removed by rubbing a small amount
of liquid dish soap over the adhesive with your
¿QJHUV:LSHZLWKZDUPZDWHUDQGGU\
xDo not use sharp instruments, rubbing alcohol,
ÀDPPDEOHÀXLGVRUDEUDVLYHFOHDQHUVWRUHPRYH
tape or glue. These products can damage the
surface of your refrigerator.
xReinstall or adjust shelves as needed. Refrigerator
shelves are installed in the shipping position.
Reinstall shelves according to your individual
storage needs.
Choosing the Proper
Location
Water
Water supply must be easily connected for the
automatic icemaker.
NOTE
xThe water pressure must be 20 - 120 psi or 138 -
827 kPa or 1.4 - 8.4 kgf/cm2. If the refrigerator is
installed in an area with low water pressure (below
20 psi or 138 kPa or 1.4 kgf/cm2), you can install a
booster pump to compensate for the low pressure.
Electricity
Use an individual, grounded outlet:115 Volts, 60 Hz,
AC, 15 Amps minimum.
Flooring
To avoid noise and vibration, the unit must be
LQVWDOOHGDQGOHYHOHGRQDVROLGO\FRQVWUXFWHGÀRRU,I
required, adjust the leveling legs to compensate for
WKHXQHYHQQHVVRIWKHÀRRU
NOTE
xInstalling on carpeting, soft tile surfaces, a platform
or weakly supported structure is not recommended.
Ambient Temperature
Install this appliance in an area where the
temperature is between 55 °F (13 °C) and 110 °F
(43 °C).
If the temperature around the appliance is too low or
high, cooling ability may be adversely affected.