Monoprice 34827 Manuel utilisateur

Monoprice
Marque
Monoprice
Modèle
34827
Taper
Manuel utilisateur
USER MANUAL
Power Input
100V-240V Speed
25 mm/s
Motion Noise
<55dB
Load Capability
265 lbs / 120 kg
RATED
Sit and Stand Desk Assembly Instructions
4 Height Position Memory Vertical Range: 61-126cm
CAUTION: DO NOT
EXCEED MAXIMUM
LISTED WEIGHT
CAPACITY. SERIOUS
INJURY OR PROPERTY
DAMAGE MAY OCCUR!
COMPONENT LIST
0601
Step 4
Leg Base (x2)
Table leg 1 (x1) Side Plates (x2)
Frame 1 (x3) Frame 2 (x1)
Table leg 2 (x2)
Connection lines short (x2) Connection line long (x1)
Power cord (x1)
Desktop (x1) Not included
Control Panel (x1)Controller box (x1)
Crossbar (x4)
1
1
2 3
4 5 6
7 8 9
10
10
13
11
11
12
12
2
66
3
4
4
7
754
2
3
9
8
10 11
13
12
7
7
AC
HS
M2 M3M1
E
2
3
1
1
3
2
Cable Clip (x8)
E
0205
HARDWARE LIST
Step 3
M5×16mm (x2)
B
M6×35mm (x1)
C
M6×11mm (x2)
A
Spare Parts
A B
E F
C
D
Allen Key
S=5mm (x1) Cable Clip (x8)
Screws
M6×11mm (x42)
S=5mm
M6×11mm(x16)
A
D
M5×16mm(x8)
B
Screws
M6×35mm (x6)
Screws
M5×16mm (x28)
M5×16mm(x20)
B
F
13
9
8
B
B
B
B
F
A
D
Tabletop Connector (x2)
Tabletop
Connector (x2)
1
1
3
2
2
3
Notice for FCC
This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: (1) this device may not cause
harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired
operation.
Modifying the equipment without Monoprice's authorization may result in the equipment no longer complying with FCC
requirements for Class B digital devices. In that event, your right to use the equipment may be limited by FCC regulations, and you
may be required to correct any interference to radio or television communications at your own expense.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning
the equipment o and on, the user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit dierent from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Notice for ISED Canada
This Class B digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada.
0403
S=5mm
S=5mm
X2
X2
X2
M6×11mm(x8)
A
D
D
Step 1 Step 2
1
Inside
M6×11mm(x2)
A
M6×35mm(x2)
C
S=5mm
M6×11mm(x8)
A
D
S=5mm
M6×11mm(x8)
A
D
S=5mm
D
M6×35mm(x4)
C
2
6
2
12
A
A
A
D
D
A
D
C
D
C
D
D
1
4
7
7
4
5
3
3
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4

Monoprice 34827 Manuel utilisateur

Monoprice
Marque
Monoprice
Modèle
34827
Taper
Manuel utilisateur
Télécharger le PDF
rapport

dans d''autres langues

Autres documents