Checkpoint Systems YWZ-HB-PRICETAG Manuel utilisateur

Taper
Manuel utilisateur

Ce manuel convient également à

5015 B.U. Bowman Drive Buford, GA 30518 USA Voice: 770-831-8048 Fax: 770-831-8598
Certification Exhibit
FCC ID: YWZ-HB-PRICETAG
IC: 3356F-HBPTAG
FCC Rule Part: 15.247
IC Radio Standards Specification: RSS-210
ACS Project Number: 13-0165
Manufacturer: Alpha - High Theft Solutions
Model: HB-PRICETAG
Manual
Instructions for
Hummingbird Price Tag
For supplemental information, check out our instructional videos at www.alphaworld.com/videos.asp
Hummingbird Price Tag
A battery operated device which allows data, price
information, to be displayed and updated on display shoes.
Facts about the Hummingbird Price Tag:
Provides accurate and up to date pricing
Ability to display regular or sale price
Long lasting replaceable lithium battery
Linking Price Tag to shoe:
1. Using the HB Scan Gun, scan the UPC on
either the display shoe or shoe box.
2. Scan the bar code on back of Price Tag.
NOTE:
If successful, display on Linking Device will read
Link: Successful.
If unsuccessful, display on Linking Device will read
Link: Unsuccessful. Try again.
3. Gently shake the Price Tag to initiate price change.
4. Attach to right display shoe.
Unlinking Hummingbird Price Tag
from shoe:
1. Using the HB Scan Gun, scan the bar code on back
of tag twice within four (4) seconds.
If successful, display on Linking Device will read
Unlink: Successful.
If unsuccessful, display on Linking Device will read
Unlink: Unsuccessful. Try again.
2. Place the Price Tag in appropriate storage
container for later use.
HB Scan Gun
Back of Price Tag
Link:
Successful
Linking Device
Price Tag
Instructions for
Hummingbird Price Tag
For supplemental information, check out our instructional videos at www.alphaworld.com/videos.asp
General Statements (For all devices):
Warning: Changes or modifications to this device not expressly approved by Alpha could void the users authority to
operate the equipment.
FCC Information and Compliance
RF Exposure
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled
environment. This equipment should be installed and operated with minimum distance 20cm
between the radiator and your body. This transmitter must not be co-located or operating in
conjunction with any other antenna or transmitter.
For Class A Devices:
“NOTE: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15
o
f
the FCC rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is
operated in a
commercial
environment. This equipment generates, uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instruction manual, may cause harmful interference to radio communications.
Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be
requ
ired
to correct the interference at his own expense.“
Under Industry Canada regulations, this radio transmitter may only operate using an antenna of a type and maximum (or
lesser) gain approved for the transmitter by Industry Canada. To reduce potential radio interference to other users, the
antenna type and its gain should be so chosen that the equivalent isotropically radiated power (e.i.r.p.) is not more than that
necessary for successfulcommunication.
Conformément à la
réglementation
d’Industrie Canada, le présent émetteur radio peut fonctionner avec une antenne dun
type et dun gain maximal (ou inférieur) approu pour l’émetteur par Industrie Canada. Dans le but de réduire les risques de
brouillage
radilectrique
à lintention des autres utilisateurs, il faut choisir le type dantenne et son gain de sorte que la
puissance isotrope rayonnée équivalente (p.i.r.e.) ne dépasse pas lintensité nécessaire à
l’établissement
dune
communication
satisfaisante.
This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two
conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including
interference that may cause undesired operation of the device.
Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux appareils radio exempts de licence.
L’exploitation est autorisée aux deux conditions suivantes : (1) l’appareil ne doit pas produire de brouillage, et (2)
l’util
isateur
de l’appareil doit accepter tout brouillage
radilectrique
subi, même si le brouillage est susceptible den compromettre le
fonctionnement.
  • Page 1 1
  • Page 2 2
  • Page 3 3

Checkpoint Systems YWZ-HB-PRICETAG Manuel utilisateur

Taper
Manuel utilisateur
Ce manuel convient également à

dans d''autres langues