Amba TRADITIONAL T-2040 Guide d'installation

Taper
Guide d'installation

A
h
INSTALLATION INSTRUCTIONS
 = 
products
BEFORE STARTING ASSEMBLY MAKE SURE ALL COMPONENTS LISTED ARE IN THE PACKAGE
Important safety instructions
All of the safety and operating instructions should be read,
adhere to and followed before the unit is operated.












! CAUTION - SURFACE OF UNIT IS HOT WHEN ON !
TRADITIONAL T-2040
A h
 
  
products
WARNINGS
   
These units should be installed by a certified electrician in accordance with the National Electrical Code (NEC) and the Canadian Electrical Code ( CEC).
The unit requires a 115 volt, 60Hz power sour ce and should be installed on a GFCI protected circuit.
Follow installation instructions to ensure unit is securely fixed to wall. Unit is designed for drying towels. Under no circumstances should anybody climb on or hang on unit.
The unit must be installed in an upright position wit h the wire cover tube/junction box being positioned at the bottom.
Unit is intended for indoor use only. Do not place units inside a shower, sauna, steam room, or wherever unit would be exposed to water.
To reduce the risk of electric shock,burns,fire or injury:
Close supervision is necessary when this unit is used near children or disabled persons.
Use this unit only for its intended use as described in this manual.
Do not use outdoors.
Do not operate with a voltage converter.
Do not touch hot surfaces.
Do not use accessories or attachments not recommended by the manufacturer as this may cause injuries.
CAUTION
As this is a heating device, the surface temperature can increase depending on the ambient temperature in the room and the number of towels applied to the unit.
The fasteners provided with the installation kit are for convenience only and are not suitable for all installation conditions.
It is the ultimate responsibility of the installer to ensure proper mounting hardware is employed in attaching the unit to the wall.
OPERATING INSTRUCTION
After installation, connect the electric power.
Tur n on the wall switch and towel warmer will start to heat-Allow
3
0-40 minutes to heat up.
This towel warmer has been designed to run continuously- turn off at wall switch when the towel warmer is not in use for long periods of time.
CARE & MAINTENANCE
Towels which contain soap or detergent residue may appear to have scorch marks; this is simply discoloration of the residue in the towels themselves.
The unit is constructed from extremely durable low carbon steel. To maintain a good appearance, follow these simple instructions:
o
For routine cleaning, simply switch off the unit, allow to cool to room temperature, wipe with a damp cloth and buff with a soft, dry cloth.
o
Under no circumstances should abrasive cleaners be used to clean the unit.
o
If the product is damaged,do not repair by yourself, please return to the maintenance center for possible repair.
SAVE THESE INSTRUCTIONS
FOR REFERENCE
INCLUDED COMPONENTS TOOLS REQUIRED


e




ELECTRICAL INFO
150 1.3 115
  
WARRANTY
Two year limited warranty
with proof of purchase will
apply if all Terms and
Conditions of Sale are met
and Installation Instructions
are adhered to.
c�us
t1O
lntertek

WARRANTY 
www.ambaproducts.com/warranty
Page 1
TRADITIONAL T-2040
INSTALLATION INSTRUCTIONS
2
�products
PARAMETER













  




 
 
 
  
  
  


404-3509738

404-3550166

 
 
 
custom e rse rvi ce@am bap ro ducts.com

www.ambaproducts.com
r------
7
I
I
I
L
---
➔
r----------------
,






 

 
 
 


 
L ________________ J
! CAUTION - SURFACE OF UNIT IS HOT WHEN ON !
Page 2
Liquid-filled
models MUST be
installed with
the wire cover
tube / junction
box being
positioned at
the bottom.
PN - Polished Nickel BN - Brushed Nickel
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4

Amba TRADITIONAL T-2040 Guide d'installation

Taper
Guide d'installation

dans d''autres langues