EN
Safety and installation instructions MagicComfort MSH50, MSH501
18
fig. 1 5, page 3: This refers to an element in an illustration. In this case,
item 5 in figure 1 on page 3.
Please observe the following safety instructions.
2 Safety and installation instructions
Please observe the prescribed safety instructions and stipulations
from the vehicle manufacturer and service workshops.
The manufacturer will not be held liable for claims for damage resulting from
the following:
z Faulty assembly or connection
z Damage to the product resulting from mechanical influences and excess
voltage
z Alterations to the product without express permission from the manu-
facturer
z Use for purposes other than those described in the operating manual
e
Warning!
To prevent the risk of short circuits, always disconnect the negative
terminal of the vehicle's electrical system before working on it.
If the vehicle has an additional battery, its negative terminal should
also be disconnected.
e
Warning!
Inadequate supply cable connections could result in short circuits,
which could have as a consequence that:
– Cable fires occur
– The airbag is triggered
– Electronic control devices are damaged
– Electric functions fail (indicators, brake light, horn, ignition,
lights)
Please observe the following instructions:
z When working on the following cables, only use insulated cable lugs,
plugs and flat push-on receptacles:
– 30 (direct supply from positive battery terminal)
– 15 (connected positive terminal, behind the battery)
– 31 (return cable from the battery, earth)
Do not use terminal strips.
_MSH50_MSH501.book Seite 18 Freitag, 7. Oktober 2011 4:30 16