Global Industrial High Capacity Boltless Steel Shelving Manuel utilisateur
- Taper
- Manuel utilisateur
1
User's manual Manual del usuario Manuel de l'utilisateur
Customer Service
US: 1-800-645-2986
Servicio de atención al Cliente
US: 1-800-645-2986
Service à la clientèle
Canada: 888-645-2986
Assembly Instructions
High Capacity Boltless
Steel Shelving
With help from others holding up the
posts, begin by installing the bottom
outer shelf support beams by inserting
the knob through the wide circle of the
slots on the posts and sliding down.
IT IS IMPORTANT TO START FROM
THE BOTTOM
While continuing to hold the 4 posts,
install the other 3 support beams for
the bottom shelf.
Continue to physically hold the
posts until at least 2 shelves are
installed. Install the middle support bar
in the same manner that the
outer support beams were
installed in the post. Align
the holes in the support bars
with the knobs on the middle
support bar, then slide the
support bar down.
BEFORE USE, REVIEW WARNINGS ON BACK OF PAGE
WARNING!
DO NOT ASSEMBLE
ALONE
2
High Capacity Boltless Assembly Instructions
Once all 5 support bars are secure, gently put the shelf
plate over the support bars. Tilt if necessary to secure
one edge rst before gently laying directly on the
supports.
Repeat the above steps for the remaining shelves. Do
not begin another shelf assembly until all steps for the
previous steps are completed.
It is recommended to install the bottom shelf rst,
then the top, then ll out the remaining shelves from
the second lowest to the second highest.
-
1
-
2
