Anker Innovations Limited. All rights reserved. eufy and the eufy Logo are trademarks of Anker
Innovations Limited, registered in the United States and other countries. All other trademarks are the
property of their respective owners.
QUICK
START GUIDE
EUFYCARE BABY
MONITOR 2 COMPLETE
Sock for eufyCare Baby Monitor 2 Complete only
Table of Contents
SAFETY INSTRUCTIONS 01
HOW THE PRODUCT WORKS 01
GETTING STARTED 02
SETTING UP YOUR DISPLAY, CAMERA, AND SOCK 05
DOWNLOADING EUFYCARE APP 05
MOUNTING THE CAMERA 05
WRAPPING YOUR BABY’S FOOT WITH THE SOCK 07
NOTICE 10
01 English
SAFETY INSTRUCTIONS
Strangulation Hazard: Children get STRANGLED in cords. Keep cords out of
the reach of children (more than 1m / 3ft away). Never use extension cords
with AC adapters. Only use the AC adapters provided.
NOTE: eufyCare Baby Smart Sock is not a medical device and is not intended
for diagnosis prevention, or treatment of any disease or condition.
HOW THE PRODUCT WORKS
The product includes a camera allowing you to watch your baby, and
provides real-time monitoring of heart rate and blood oxygen level via
the smart sock worn on the baby's foot. In case of emergency, you can get
alarms from the display and your phone through the eufyCare app.
English 02
GETTING STARTED
Power on the Display：
2s
1
2
Power on the Camera:
03 English
Charge the sock, and then it can be detected and connected to the display
(for eufyCare Baby Monitor 2 Complete only)：
English 04
Item Status LED Description
Display Solid red Charging
Solid white Fully charged
Flashing red Low battery
Camera Solid white Connected
Flashing white Waiting to pair
Flashing white fast No connection
Sock Flashing red Charging and waiting
to connect
Solid red Charging and
connected
Solid green Fully charged and
connected
05 English
SETTING UP YOUR DISPLAY, CAMERA, AND SOCK
After powering on your display, follow the on-screen instructions to
complete the initial setup.
DOWNLOADING EUFYCARE APP
For remote access, download the eufyCare app from Google Play or App
Store. Scan the QR code on the display using your eufyCare app to complete
the setup.
MOUNTING THE CAMERA
You have three options to mount the camera: on the wall, in the corner, or on
the crib.
English 06
07 English
WRAPPING YOUR BABY’S FOOT WITH THE SOCK
Choose the right size for your baby. The sock with the pre-installed sensor is
for babies at 4-12 lbs. To install the sensor on the bigger sock (12-30 lbs):
1. Remove the original sensor from the sock.
English 08
2. The sock can be worn on either foot. Place the sock sensor on the foot as
illustrated (do not overtighten the strap).
09 English
English 10
NOTICE
FCC Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
Warning: Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation.
This equipment generates uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures: (1) Reorient or relocate the
receiving antenna. (2) Increase the separation between the equipment and receiver. (3) Connect
the equipment into an outlet on a circuit different from that to which the receiver is connected. (4)
Consult the dealer or an experienced radio/ TV technician for help.
FCC Radio Frequency Exposure Statement
The following importer is the responsible party
Company Name: POWER MOBILE LIFE, LLC
Address: 400 108th Ave NE Ste 400, Bellevue, WA 98004-5541
Telephone:1-800-988-7973
This product complies with the radio interference requirements of the European
Community.
Notice: Shielded cables
All connections to other computing devices must be made using shielded cables to maintain
compliance with FCC regulations.
T8340 has been evaluated and following general RF exposure requirement. The device can be
used in portable exposure condition without restriction. The min separation distance is 0cm.
T8350 has been evaluated and following general RF exposure requirement. The device can be used in
portable exposure condition without restriction. The min separation distance is 0cm.
T8360 has been evaluated to meet general RF exposure requirements. The device can be used in
fixed/mobile exposure condition. The min separation distance is 20cm.
SAR: 0.757 W/Kg
11 English
Declaration of Conformity
Hereby, Anker Innovations Limited declares that this device is in compliance with the essential
requirements and other relevant provisions of Directive 2014/53/EU.For the declaration of
conformity, visit the Web site: https://uk.eufylife.com/.
This product can be used across EU member states.
The adapter shall be installed near the equipment and shall be easily accessible. Do not use
the Device in the environment at too high or too low temperature, never expose the Device
under strong sunshine or too wet environment. The suitable temperature for the product and
accessories is 32°F to 95°F / 0°C to 35°C.
When charging, please place the device in an environment that has a normal room temperature
and good ventilation.
It is recommended to charge the device in an environment with a temperature that ranges from
5℃~25℃.
Please ensure to use only the charger offered by the manufacturer. Using unauthorized charger
may cause danger and violate the authorization of the projector and the guarantee article.
The chargers are for indoor use only. The plug considered as disconnect device of adapter.
The charger for T8340 type is TEKA-UCA10EU, output voltage/current is 5Vdc/1A.
The charger for T8350 type is TEKA-UCA20EU, output voltage/current is 5Vdc/2A.
The charger for T8360 type is TEKA-UCA20EU, output voltage/current is 5Vdc/2A.
CAUTION RISK OF EXPLOSION IF BATTERY IS REPLACED BY AN INCORRECT TYPE. DISPOSE OF
USED BATTERIES ACCORDING TO THE INSTRUCTIONS
RF exposure information:
The Maximum Permissible Exposure (MPE) level has been calculated based on a distance of
d=20 cm between the device and the human body. To maintain compliance with RF exposure
requirement, use product that maintain a 20cm distance between the device and human body.
T8340 Bluetooth Operating Frequency Range:2402~2480 MHz; Bluetooth Max Output Power:8 dBm(EIRP) .
T8350 Wifi Operating Frequency Range:2412~2472 MHz(2.4G); Wifi Max Output Power:19 dBm(ERIP );Bluetooth Operating
Frequency Range:2402~2480 MHz; Bluetooth Max Output Power:8 dBm(EIRP) .
T8360 Wifi Operating Frequency Range:2412~2472 MHz(2.4G); Wifi Max Output Power:19 dBm(ERIP );Bluetooth Operating
Frequency Range:2402~2480 MHz; Bluetooth Max Output Power:8 dBm(EIRP) .
T8350 was tested for typical body-worn operations with the back of the handset kept 0 mm from the body. The SAR limit of
Europe is 4.0 W/kg.
this product has also been tested against this SAR limit. The highest SAR value reported under
this standard during product certification for use at the limb is 1.707W/kg .
This device was tested for typical hand held operations with the back of the device kept 0mm
from the Limb.
Anker Innovations Deutschland GmbH I Georg-Muche-Strasse 3, 80807 Munich, Germany
English 12
This product complies with the radio interference requirements of the United Kingdom
Declaration of Conformity
Hereby, Anker Innovations Limited declares that this product is in compliance with Radio
Equipment Regulations 2017. The full text of the UK declaration of conformity is available at the
following internet address: https://uk.eufylife.com
The chargers is for indoor use only. The plug is considered a disconnect device of the adapter.
The charger for T8340 type is TEKA-UCA10BS, output voltage/current is 5V DC/1A.
The charger for T8350 type is TEKA-UCA20BS, output voltage/current is 5V DC/2A.
The charger for T8360 type is TEKA-UCA20BS, output voltage/current is 5V DC/2A.
Anker Technology (UK) Ltd I Suite B, Fairgate House, 205 Kings Road, Tyseley, Birmingham, B11
2AA, United Kingdom
IC Statement
This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the
following two conditions:(1) this device may not cause interference, and(2) this device must accept any
interference, including interference that may cause undesired operation of the device."
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence
. L'exploitation est autorisée aux deux conditions suivantes:(1) l'appareil nedoit pas produire de brouillage, et(2)
l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible
d'en compromettre le fonctionnement."
This Class B digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada.
This product is designed and manufactured with high quality materials and components,
which can be recycled and reused.
This symbol means the product must not be discarded as household waste, and should
be delivered to an appropriate collection facility for recycling. Proper disposal and
recycling helps protect natural resources, human health and the environment. For more
information on disposal and recycling of this product, contact your local municipality,
disposal service, or the shop where you bought this product.
13 English
IC RF Statement:
T8340 has been evaluated and following general RF exposure requirement. The
device can be used in portable exposure condition without restriction. The min
separation distance is 0cm.
Le T8340 a été évalué et conforme aux exigences générales d'exposition aux RF.
L'appareil peut être utilisé dans des conditions d'exposition portable sans
restriction. La distance de séparation minimale est de 0 cm.
T8350 has been evaluated and following general RF exposure requirement. The
device can be used in portable exposure condition without restriction. The min
separation distance is 0cm.
Le T8350 a été évalué et conforme aux exigences générales d'exposition aux RF.
L'appareil peut être utilisé dans des conditions d'exposition portable sans
restriction. La distance de séparation minimale est de 0 cm.
When using T8360, maintain a distance of 20cm from the body to ensure
compliance with RF exposure requirements.
Lors de l'utilisation du T8360, maintenez une distance de 20 cm du corps afin de
vous conformer aux exigences en matière d'exposition RF.
English 14
CUSTOMER SERVICE
• Warranty
12-month limited warranty
• Call Us
United States +1 (800) 988 7973 Mon-Fri 9AM-5PM (PT)
United Kingdom +44 (0) 1604 936 200 Mon-Fri 6AM-11AM (GMT)
Germany +49 (0) 69 9579 7960 Mon-Fri 6:00-11:00
• Email Us
Customer Support: [email protected]
@EufyOfficial
@EufyOfficial
@EufyOfficial
15 English
English 16
-
1
-
2
-
3
-
4
-
5
-
6
-
7
-
8
-
9
-
10
-
11
-
12
-
13
-
14
-
15
-
16
-
17
-
18
-
19
-
20
dans d''autres langues
- English: Eufy T8350 User guide
Documents connexes
Autres documents
-
JVC SP-SG2BT Manuel utilisateur
-
ACCO Brands M01627-D Manuel utilisateur
-
eufy Security SoloCam L20 Mode d'emploi
-
Anker D2400 Manuel utilisateur
-
Anker T8420S Mode d'emploi
-
Anker NEBULA Mode d'emploi
-
eufy Security Smart Drop Delivery Box Mode d'emploi
-
eufy Security Indoor Cam 2K Pan & Tilt Guide de démarrage rapide
-
Asus E1600WK Mode d'emploi
-
Asus Chromebook RTL8822C Laptop Mode d'emploi