Chief CMA165 Guide d'installation

Catégorie
Accessoires pour écran plat
Taper
Guide d'installation
INSTALLATION INSTRUCTIONS
Instrucciones de instalación
Installationsanleitung
Instruções de Instalação
Istruzioni di installazione
Installatie-instructies
Instructions d´installation
Junction Box Ceiling Plate Assembly
Spanish Product Description
German Product Description
Portuguese Product Description
Italian Product Description
Dutch Product Description
French Product Description
CMA165
CMA165 Installation Instructions
2
DISCLAIMER
Milestone AV Technologies and its affiliated corporations and
subsidiaries (collectively "Milestone"), intend to make this
manual accurate and complete. However, Milestone makes no
claim that the information contained herein covers all details,
conditions or variations, nor does it provide for every possible
contingency in connection with the installation or use of this
product. The information contained in this document is subject
to change without notice or obligation of any kind. Milestone
makes no representation of warranty, expressed or implied,
regarding the information contained herein. Milestone assumes
no responsibility for accuracy, completeness or sufficiency of
the information contained in this document.
Chief® is a registered trademark of Milestone AV Technologies.
All rights reserved.
IMPORTANT WARNINGS AND
CAUTIONS!
WARNING: A WARNING alerts you to the possibility of
serious injury or death if you do not follow the instructions.
CAUTION: A CAUTION alerts you to the possibility of
damage or destruction of equipment if you do not follow the
corresponding instructions.
WARNING: Failure to read, thoroughly understand, and
follow all instructions can result in serious personal injury,
damage to equipment, or voiding of factory warranty! It is the
installer’s responsibility to make sure all components are
properly assembled and installed using the instructions
provided.
WARNING: Failure to provide adequate structural strength
for this component can result in serious personal injury or
damage to equipment! It is the installer’s responsibility to
make sure the structure to which this component is attached
can support five times the combined weight of all equipment.
Reinforce the structure as required before installing the
component.
WARNING: Exceeding the weight capacity can result in
serious personal injury or damage to equipment! It is the
installer’s responsibility to make sure the combined weight of
all components located attached to the CMA165 does not
exceed 50 lbs (22.7 kg). Use with products heavier than the
maximum weight indicated may result in collapse of the
mount and its accessories causing possible injury.
Installation Instructions CMA165
3
LEGEND
Tighten Fastener
Apretar elemento de fijación
Befestigungsteil festziehen
Apertar fixador
Serrare il fissaggio
Bevestiging vastdraaien
Serrez les fixations
Loosen Fastener
Aflojar elemento de fijación
Befestigungsteil lösen
Desapertar fixador
Allentare il fissaggio
Bevestiging losdraaien
Desserrez les fixations
Phillips Screwdriver
Destornillador Phillips
Kreuzschlitzschraubendreher
Chave de fendas Phillips
Cacciavite a stella
Kruiskopschroevendraaier
Tournevis à pointe cruciforme
Open-Ended Wrench
Llave de boca
Gabelschlüssel
Chave de bocas
Chiave a punte aperte
Steeksleutel
Clé à fourche
By Hand
A mano
Von Hand
Com a mão
A mano
Met de hand
À la main
Hex-Head Wrench
Llave de cabeza hexagonal
Sechskantschlüssel
Chave de cabeça sextavada
Chiave esagonale
Zeskantsleutel
Clé à tête hexagonale
Pencil Mark
Marcar con lápiz
Stiftmarkierung
Marcar com lápis
Segno a matita
Potloodmerkteken
Marquage au crayon
Drill Hole
Perforar
Bohrloch
Fazer furo
Praticare un foro
Gat boren
Percez un trou
Adjust
Ajustar
Einstellen
Ajustar
Regolare
Afstellen
Ajuster
Remove
Quitar
Entfernen
Remover
Rimuovere
Verwijderen
Retirez
Optional
Opcional
Optional
Opcional
Opzionale
Optie
En option
Security Wrench
Llave de seguridad
Sicherheitsschlüssel
Chave de segurança
Chiave di sicurezza
Veiligheidssleutel
Clé de sécurité
CMA165 Installation Instructions
4
TOOLS REQUIRED FOR INSTALLATION
PARTS
1/8"
(included) 3/32"
(included) 5/32" - security
(included)
4" hole saw
7/16"
A (1)
[Ceiling Plate]
B (1)
[Junction Box Assembly]
C (1)
1/8" D (1)
3/32" E (1)
5/32"
(security)
F (1)
[Security spinner]
G (2)
10-32 x 1-1/8" H (1)
10-24 x 1/4"
J (2)
#10
K (2)
#10 L (1)
10-24 x 1/4"
Installation Instructions CMA165
5
ASSEMBLY AND INSTALLATION
Installing Junction Box Assembly
1. Determine the location for the CMA165.
2. Cut hole in ceiling using a 4" hole saw.
3. Lift the junction box assembly (B) bar into place above the
ceiling. (See Figure 1)
Figure 1
4. Ensure legs are set down squarely on the ceiling.
5. Turn the square rod so ends of assembly extend into the
joists. (See Figure 2)
NOTE: Assembly expands to fit 16 or 24 inch joists.
Figure 2
6. Place the U bar over the junction box assembly bar, being
careful that bar legs remain squarely on the ceiling.
7. Place junction box onto U bar and tighten nuts. (See
Figure 3)
Figure 3
Installing Ceiling Plate
1. Install ceiling plate (A) to junction box assembly (B) using
two 10-32 x 1-1/8" button head cap screws (G), two #10
lockwashers (K) and two #10 flat washers (J). (See
Figure 4)
Figure 4
4
(B)
Extend ends
into joists
5
x 2
U-bar
Junction
box
7
1
(G) x 2
(K) x 2
(J) x 2
(A)
3
(L) x 1
CMA165 Installation Instructions
6
2. Install 1-1/2" NPT pipe (not provided) into ceiling plate.
3. Secure pipe using one 10-24 x 1/4" set screw (L). (See
Figure 4)
4. OPTIONAL: Use one 10-24 x 1/4" button head security
screw (H) and one security spinner (F) instead of the set
screw (L) to add additional security to the ceiling plate
installation. (See Figure 5)
Figure 5
4
(H) x 1
(F)
(A)
Installation Instructions CMA165
7
CMA165 Installation Instructions
USA/International A 8401 Eagle Creek Parkway, Savage, MN 55378
P800.582.6480 / 952.894.6280
F877.894.6918 / 952.894.6918
Europe A Fellenoord 130 5611 ZB EINDHOVEN, The Netherlands
P+31 (0)40 2668620
F+31 (0)40 2668615
Asia Pacific A Office No. 1 on 12/F, Shatin Galleria
18-24 Shan Mei Street
Fotan, Shatin, Hong Kong
P852 2145 4099
F852 2145 4477
Chief Manufacturing, a products division
of Milestone AV Technologies
8804-000194 RevC
2010 Milestone AV Technologies, a
Duchossois Group Company
www.chiefmfg.com
01/10
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6
  • Page 7 7
  • Page 8 8

Chief CMA165 Guide d'installation

Catégorie
Accessoires pour écran plat
Taper
Guide d'installation

dans d''autres langues