TECHNICAL FILE
R03.002_27/04/2016
Materials
Zamak
Installation
On a existing baseboard
Page 3 of 4
The complementary pieces of Novorodapie® Rehabit are made of Zamak. Zamak is a non ferrous alloy
of Zinc with Aluminium, Magnesium and Copper (UNE EN 1774) It’s tenacious, hard hardeness and has
a high mechanical strenght and an excellent plastic deformability. The nish that is applied on to the
complementary pieces, protect them and complement the Novorodapie® Rehabit.
*For further information see the Technical Files of the materials in www.emac.es
1. Clean the surface destinated to the placement of Novorodapie® Rehabit.
2. Join the complementary pieces to the Novorodapie® Rehabit. This previous step will make easier
the union of the set to the wall.
3. Thirdly apply the adhesive on the internal surface of Novorodapie® Rehabit, ensuring the contact
between the new and the old baseboard. You can use an adhesive type MS Sealing/Express
Adhesive from Fischer or similar.
4. Then place carefully the Novorodapie® on the existing skirting and press softly.
5. Clean the leftover material and let dry. After drying remove the protective lm.
Novorodapie® Rehabit is a prole made by extrusion of aluminium. The matt silver nish has been
anodized, improving mainly through this process their corrosion resistance, mechanical resistance and
appearance. The anodized applied has the quality seal Qualanod, which guarantees the quality of the
process and the resulting proles. This seal regulates several tests: appearance and color, thickness
measurements, sealing and impregnation control, abrasion resistance, lightfastness, acetic saline
chamber and nitric acid immersion.
The off-white nish has been lacquered, obtaining so a high quality and homogeneus surface. The
lacquering has the quality seal Qualicoat, which guarantees the quality of the process and the nal
products.
The aluminium is a material with excellent chemical, physical and mechanical properties. It is lightweight,
tough, ductile, malleable and highly durable.
Without existing baseboard
1. Clean the surface destinated to place the Novorodapie® Rehabit.
2. Join the complementary pieces to the Novorodapie® Rehabit. This previous step will make easier
the union of the set to the wall.
3. Thirdly apply the adhesive on the surface of the “fastening-prole” and on the rear of the
Novorodapie®. You can use an adhesive type MS Sealing/Express Adhesive from Fischer or similar.
4. Then place carefully the Novorodapie® Rehabit on the wall, ensuring the “fastening-prole” makes
contact with the surface.
5. Clean the remaining material and let the dry. After drying, remove the protective lm.
6. *If you’re going to paint the wall, keep the lm until you have nished the operation
Novorodapie® Rehabit