Rode Wireless GO II Mode d'emploi

Taper
Mode d'emploi

Ce manuel convient également à

dB
RX
Wireless GO II Quickstart Guide
TX
TX1
TX2
1
TX1 TX2
TX1 TX2
2
3
4
5
3s
0 dB
RX
-12 dB
-24 dB
RX
3s
3s
3s
RX
5
A
android
* Cable available separately
câble disponible séparément
kabel separat erhältlich
cable disponible por separado
cabo disponível separadamente
歏綈⽀杝䲿⣘
ⴽ㡰׶ך؛٦ـٕ
ா੉࠶߹ب౸ݒ
TX1
TX2
TX1 + TX2
L+R
TX1
TX2
TX1 L
TX2 R
4
A
The Apple logo and iPhone are
trademarks of Apple Inc., registered
in the U.S. and other countries
RX
10 s
IMPORTANT SAFETY INFORMATION
1. Read and understand the instructions and safety guide completely
before using the product.
2. Ensure both the instruction manual and safety guide are accessible to
all users, including when passing the product on to third parties.
3. Only use this product with
autho
rised RØDE accessories.
4. Do not open the product housing. This will void the warranty.
5. Refer all
service and repairs to RØDE-approved
s
ervice personnel.
Service or repair is required
for produ
c
t
s that have been damaged,
e
xposed to liquid, rain or moisture, or do not operate normally.
6
. Use the product only in the ways described in the instructions.
7
. Do not use the product if
i
t
was
damaged during transportation.
8
. Keep the product away from liquids and electrically conductive objects
that are not necessary for operati
on.
9. Do not use any solvents or corrosive cleaning agents to clean the
product.
10. Do not adjust the controls of the pr
o
duct in an environment that
requires your attention (operating machinery, driving etc.).
NORTH AMERICA
This transmitter must not be co-located or operated in conjunction with any
other antenna or transmitter.
This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference
that may cause undesired operation. This equipment has been tested and
found to comply with the limits for a Class B digital device, pursuant to part 15
of the FCC Rules.
These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following
measures:
1. Reorient or relocate the receiving antenna.
2. Increase the separation between the equipment and receiver.
3. Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
4. Consult the dealer or an experienced radio/TV technician for help.
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment.
Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment. This
device contains licence-exempt transmitter(s)/receiver(s) that comply with
Innovation, Science and Economic Development Canada’s licence-exempt
RSS(s). Operation is subject to the following two conditions:
(1) This device may not cause interference.
(2) This device must accept any interference, including interference that may
cause undesired operation of the device.
L’émetteur/récepteur exempt de licence contenu dans le présent appareil est
conforme aux CNR d’Innovation, Sciences et Développement économique
Canada applicables aux appareils radio exempts de licence. L’exploitation est
autorisée aux deux conditions suivantes :
(1) L' appareil ne doit pas produire de brouillage;
(2) L' appareil doit accepter tout brouillage radioélectrique subi, même si le
brouillage est susceptible d' en compromettre le fonctionnement.
Regulatory information such as identification numbers are displayed on the
Wireless GO II receiver by pressing the Gain and Power buttons simultaneously
for at least three seconds. To dismiss this screen, simply press any button on
the receiver.
EU COMPLIANCE STATEMENT
RØDE Microphones hereby declares that the Wireless GO II transmitter and
receiver are in compliance with Radio Emissions Directive 2014/53/EU.
A copy of the EU Declaration of Conformity is available at
http://www.rode.com/wireless/wirelessgoII.
For details of EU Representative go to rode.com/distributors.
Frequency Range: 2.402 – 2.480 GHz
Transmission Power: < 10mW
SOUTH KOREA
硽疩ֵአᘏ礚Ꭳᒫ殻虻懱ԏ砺֢ྍ詽褖ӣ㮆砺֢ྍ詽
憙ێ狒虁蘻承物ֵአ螂ଶ盳㰁疏憙ێ
憙ێ狒虁ဳ఺Ԫ殻物
Lֵአ獤楮藶ջ௳獤楮牐
LL๚笕䵇ଞ㱾犋蓦癷䵇犥Ӥྯॠ蓦癷犋ᥝ᩻螂ੜ碻牐
犵ۑሲ疤毱襎秚蘻承物犵ۑሲ疤毱襎秚螕አ妿ࣳୗ藨挨ݳ໒ԏ犵ۑሲ疤毱襎秚牧覍妿战
ݢ牧獍ݪ牏珶蒈౲ֵአᘏ璂犋஑඘ᛔ虋ๅ毱ሲ牏ےय़ۑሲ౲虋ๅܻ戔懯ԏ粬௔现ۑ胼牐犵
ۑሲ疤毱襎秚ԏֵአ犋஑୽段汜膠ਞ獊现ଗ硑ݳဩ蝢מ牪妿咳匍磪ଗ硑匍虡碻牧䛑缏ܨ؊
አ牧㪔硬珿ᛗ篷ଗ硑碻ො஑媣媲ֵአ牐獮殻ݳဩ蝢מ牧瞲狅襎מဩ憒ਧ֢禂ԏ篷娄襎蝢מ
牐犵ۑሲ疤毱襎秚殾盚ݑݳဩ蝢מ౲ૡ禂牏ᑀ䋊现蠴ዌአ襎ူᬊ疤௔襎秚戔猋ԏଗ硑牐
襎穥ਞ獊ፘ橕ဳ఺Ԫ殻牐
5V 0.3A
EUROPE
USA
CANADA
AUS/NZ
TAIWAN
POWER
TAIWAN
ݶ碻ೲӥʼnीፅŊ޾ʼn襎რŊೲ衔ᛗ੝ӣᑁ楮牧ܨݢࣁ:LUHOHVV*2,,矑硩瑊Ӥ氥纈拙ই秂蘷蒈
ԏ觊ጱဩ憒מ௳牐ᥝ橕樂種੽癷牧ݝ襑ೲ矑硩秚Ӥጱ犨֜ೲ衔ܨݢ牐
7
TX
8
RX
Love your Wireless GO II?
Share with us #rodemic
rode.com
Scan the
QR code to
find out more
rodemic
@
rodemic
@
rodemics
ID: R-R-R72-Transmitter
Company Name: RØDE Microphones
Model: Wireless GO II - Transmitter
Country of Origin: Australia
JAPAN
Transmitter ID:
Receiver ID:
Transmitter ID:
Receiver ID:
Transmitter ID:
Receiver ID:
2AEAN-WGOIITX
2AEAN-WGOIIRX
20091-WGOIITX
20091-WGOIIRX
Transmitter: 204-B00279
Wireless GO II - Transmitter
ID: R-R-R72-Receiver
Company Name: RØDE Microphones
Model: Wireless GO II - Receiver
Country of Origin: Australia
REGULATORY & SAFETY
CCAM20LP2910T2
CCAM20LP2900T2
Receiver: 204-B00280
Wireless GO II - Receiver
A
B
  • Page 1 1
  • Page 2 2

Rode Wireless GO II Mode d'emploi

Taper
Mode d'emploi
Ce manuel convient également à

dans d''autres langues