Comap Autobalancing Thermostatic Manuel utilisateur

Autobalancing thermostatic

radiator valve Autosar

changements quant à la conception et quant aux spéciﬁ cations techniques de nos produits.

Page 1 - 00880 - ENG - 2021-12

Installation

Adjusment principle of KV

The adjustment of the desired flow should be using the embedded tool that displays the 12 adjustment positions. Turn the tool with a screwdriver as

shown in the diagram below. Place the number corresponding to the desired forfeit opposite the indentation on this hat.

Sample setting in position 5

Autobalancing thermostatic

radiator valve Autosar

changements quant à la conception et quant aux spéciﬁ cations techniques de nos produits.

Page 2 - 00880 - ENG - 2021-12

Nominal level setting

• Close the valve completely and mark it with one position.

• Open and count 6 marks. The valve is now open at nominal opening.

• To install thermostatic head, remove the plastic cap.

• Put the thermostatic head in position 5, firmly push the head on the faucet and screw in hand tight.